Method for obtaining reliable R-waves in fish electrocardiograms by utilizing conductivity of seawater.

A simple method for measuring bioelectric signals of fish in seawater is expected for managing the health of farmed fish and clarifying the ecophysiology of natural fish. We previously proposed a simple and unique method for measuring bioelectric signals of fish by inserting only one special internal electrode (which can be isolated from seawater) into the fish's body and by sinking an external electrode in seawater (for utilizing the conductivity of seawater). However, the proposed method could not obtain fish electrocardiograms (ECGs) with reliable R-waves in the same manner as the conventional method. In this study, we thus experimentally investigated whether the R-waves of ECGs could be observed by optimizing the insertion position of the internal electrode into the fish's body. The results of the experiment show that for four species of fish (each slightly longer than 10 cm) with different body shapes, reliable R-waves could be observed by inserting the internal electrode near the heart. We also investigated the possibility of simultaneously measuring ECGs of multiple fish by the proposed method. The results of the investigation show that the fish ECGs with R-waves of three fish could be observed simultaneously even when one single common external electrode replaced multiple external electrodes. This result indicates the advantage of the proposed method in reducing the total number of bioelectrodes compared to the conventional method for ECG measurements of multiple fish.

Particle Size-Dependent Component Separation Using Serially Arrayed Micro-Chambers.

The purpose of this research was to enable component separation based on simple control of the flow rate. We investigated a method that eliminated the need for a centrifuge and enabled easy component separation on the spot without using a battery. Specifically, we adopted an approach that uses microfluidic devices, which are inexpensive and highly portable, and devised the channel within the fluidic device. The proposed design was a simple series of connection chambers of the same shape, connected via interconnecting channels. In this study, polystyrene particles with different sizes were used, and their behavior was evaluated by experimentally observing the flow in the chamber using a high-speed camera. It was found that the objects with larger particle diameters required more time to pass, whereas the objects with smaller particle diameters flowed in a short time; this implied that the particles with a smaller size could be extracted more rapidly from the outlet. By plotting the trajectories of the particles for each unit of time, the passing speed of the objects with large particle diameters was confirmed to be particularly low. It was also possible to trap the particles within the chamber if the flow rate was below a specific threshold. By applying this property to blood, for instance, we expected plasma components and red blood cells to be extracted first.

X-ray Photoemission Spectroscopy Study of Uniaxial Magnetic Anisotropy Induced in a Ni Layer Deposited on a LiNbO3 Substrate.

The competition between magnetic shape anisotropy and the induced uniaxial magnetic anisotropy in the heterojunction between a ferromagnetic layer and a ferroelectric substrate serves to control magnetic domain structures as well as magnetization reversal characteristics. The uniaxial magnetic anisotropy, originating from the symmetry breaking effect in the heterojunction, plays a significant role in modifying the characteristics of magnetization dynamics. Magnetoelastic phenomena are known to generate uniaxial magnetic anisotropy; however, the interfacial electronic states that may contribute to the uniaxial magnetic anisotropy have not yet been adequately investigated. Here, we report experimental evidence concerning the binding energy change in the ferromagnetic layer/ferroelectric substrate heterojunction using X-ray photoemission spectroscopy. The binding energy shifts, corresponding to the chemical shifts, reveal the binding states near the interface. Our results shed light on the origin of the uniaxial magnetic anisotropy induced from the heterojunction. This knowledge can provide a means for the simultaneous control of magnetism, mechanics, and electronics in a nano/microsystem consisting of ferromagnetic/ferroelectric materials.

A novel method for noninvasive bioelectric measurement utilizing conductivity of seawater.

A novel method of noninvasive bioelectric measurement that utilizes the conductivity of seawater covering a person's whole body is proposed. Concretely, a conductor used as a common electrode is sunk into the seawater, and four special bioelectrodes isolated from the seawater are attached at measurement points on the body. Bioelectric signals generated between the common electrode and special bioelectrodes are then measured. To verify the effectiveness of the proposed method, bioelectric signals of six participants immersed in a bathtub filled with seawater were experimentally measured. The measurement results revealed that the proposed method enables multipoint bioelectric measurement using about half the number of bioelectrodes used by the conventional method on land, and a plurality of bioelectric phenomena can be observed at one measurement point. It was also revealed that compared with the conventional method, the proposed method significantly reduces external electrical noise included in the bioelectric signals by exploiting the shielding effect of seawater. If simple bioelectric measurements in seawater were possible in the manner described above, not only people such as scuba divers but also precious animals living in the sea could be noninvasively treated as measurement subjects.

Utilizing conductivity of seawater for bioelectric measurement of fish.

To manage health conditions of farmed fish and other living creatures, a simple method to measure bioelectric signals of the creatures in seawater is expected. A novel method to measure bioelectric signals by utilizing the conductivity of seawater surrounding the entire body of a fish is proposed. As for the proposed method, a needle-type internal electrode is inserted into the fish's muscle at a certain measurement point, and an external electrode is sunk in seawater. The internal electrode is isolated from the seawater by virtue of being inserted in the fish. Bioelectric signals generated between the external and internal electrodes are then measured. By sharing the external electrode with the internal electrode, it is possible to measure bioelectric signals with half the number of bioelectrodes used by conventional methods. To demonstrate the practicality of the proposed method, two internal electrodes were inserted into different parts (above the gills and near the tail) of three fish (Parajulis poecilepterus, ca. 20 cm fork length) kept in a tank. The proposed method obtained reliable bioelectric signals corresponding to electrocardiograms (ECGs) and electromyograms (EMGs) from each part of the individual fish.

Electrochemical characteristics of a hyperthermophilic enzyme in microdroplets stirred and heated by surface acoustic waves.

Micro total analysis system (µTAS) is expected to be applied in various fields. In particular, since electrochemical measurement is inexpensive and easy, electrochemical measurement can be integrated with a microchannel. However, electrochemical detection sensitivity in a microchannel is lowered because the diffusion of the detection target is limited. In an ordinary electrochemical detection system, using a stirrer in a beaker can overcome limited diffusion. We previously proposed a new detection system that combines a microliquid solution agitation technology using surface acoustic waves (SAWs) with the µTAS. The SAWs function as microstirrers, thus making electrochemical detection possible by overcoming limited diffusion of the sample. However, when the solution is stirred by the SAWs, the temperature of the solution increases to 70°C due to vibrational energy. This leads to enzyme inactivation and impaired electrochemical response. Therefore, in this study, we used a hyperthermophile-derived enzyme. Temperature and electrochemical characteristics of the detection system using SAWs and a multi-copper oxidase (MCO) derived from the hyperthermophilic archaea Pyrobaculum aerophilum were studied. Laccase, which is an MCO derived from the thermophilic fungus Trametes versicolor, was also studied. We also characterized the enzyme-electrochemical reaction using SAWs by comparing the magnitude of the reduction current obtained using the two enzymes with different heat resistances. We observed an increase in the electrochemical response with the SAWs, without impaired enzyme activity. Thus, the use of a thermostable enzyme is suitable for the development of a biosensor that uses SAWs for agitation.