A promising dehydrogenase-based bioanode for a glucose biosensor and glucose/O2 biofuel cell.

A new type of dehydrogenase-based amperometric glucose biosensor was constructed using glucose dehydrogenase (GDH) which was immobilized on the edge-plane pyrolytic graphite (EPPG) electrode modified with poly(phenosafranin)-functionalized single-walled carbon nanotubes (PPS-SWCNTs). The PPS-SWCNT-modified EPPG electrode was prepared by electropolymerization of phenosafranin on the EPPG electrode which had been previously coated with SWCNTs. The performance of the GDH/PPS-SWCNT/EPPG bioanode was evaluated using cyclic voltammetry and amperometry in the presence of glucose. The GDH/PPS-SWCNT/EPPG electrode possesses promising characteristics as a glucose sensor: a wide linear dynamic range of 50 to 700 µM, low detection limit of 0.3 µM, fast response time (1-2 s), high sensitivity (96.5 µA cm(-2) mM(-1)), and anti-interference and anti-fouling abilities. Moreover, the performance of the GDH/PPS-SWCNT/EPPG bioanode was tested in a glucose/O(2) biofuel cell. The maximum power density delivered by the assembled glucose/O(2) biofuel cell could reach 64.0 µW cm(-2) at a cell voltage of 0.3 V with 40 mM glucose.

pH Dependence of the size and crystallographic orientation of the gold nanoparticles prepared by seed-mediated growth.

The effect of the pH of the growth solution on the size and crystallographic orientation of gold nanoparticles (GNPs) was studied during the course of the preparation of surface-confined spherical GNPs following a two-step protocol (electrochemical and chemical). GNPs were first electrodeposited onto a clean glassy carbon (GC) electrode and these GNPs were used as seeds. Seed-mediated growth of the electrodeposited GNPs was performed in a solution of H[AuCl(4)] at various pHs (5.0 to 0.5) using NH(2)OH as a reducing agent. The thus-prepared GNPs were characterized by electrochemical, UV-visible absorption spectral, SEM, and TEM studies. The nucleation (i.e., formation of the new seeds) was found to dominate over growth (i.e., enlargement of the seed particles) process at higher pH during NH(2)OH seeding, whereas only growth was recognized at low pH (0.5). Nonspherical byproducts were noticed when the seed-mediated growth was performed at higher pHs, but at pH 0.5 only spherical GNPs were observed. The present method provides a way out for the preparation of GNPs with homogeneous shape resolving the problem of simultaneous formation of nonspherical byproducts during the seed-mediated growth as well as for the preparation of GNPs with a Au(111) facet ratio as high as 97%. On the basis of the obtained results, the mechanism of the growth process at low pH is also discussed. Interestingly, an enhanced electrochemical response was obtained for the oxidation of H(2)O(2) using the GNPs prepared at pH 0.5.

Determination of formal potential of NADH/NAD+ redox couple and catalytic oxidation of NADH using poly(phenosafranin)-modified carbon electrodes.

The electrochemical regeneration of NADH/NAD(+) redox couple has been studied using poly(phenosafranin) (PPS)-modified carbon electrodes to evaluate the formal potential and catalytic rate constant for the oxidation of NADH. The PPS-modified electrodes were prepared by electropolymerization of phenosafranin onto different carbon substrates (glassy carbon (GC) and basal-plane pyrolytic graphite (BPPG)) in different electrolytic solutions. The formal potential was estimated to be -0.365±0.002V vs. SHE at pH 7.0. As for the bare carbon electrodes, the oxidation of NADH at the BPPG electrode was found to be enhanced compared with the GC electrode. For the PPS-modified electrodes, it was found that the electrocatalysis of PPS-modified electrodes for the oxidation of NADH largely depends on the carbon substrate and electrolyte solution employed for their preparation, i.e., the PPS-modified BPPG electrode prepared in 0.2M NaClO(4)/acetonitrile solution exhibits an excellent and persistent electrocatalytic property toward NADH oxidation in phosphate buffer solution (pH 7.0) with a diminution of the overpotential of about 740 and 670mV compared with those at the bare GC electrode and the PPS-modified GC electrode prepared in 0.2M H(2)SO(4) solution, respectively. A quantitative analysis of the electrocatalytic reaction based on rotating disk voltammetry gave the electrocatalytic reaction rate constants of the order of 10(3)-10(4)M(-)(1)s(-1) depending on the preparation conditions of the PPS-modified electrodes.