Accentuated Eccentric Loading and Cluster Set Configurations in the Back Squat: A Kinetic and Kinematic Analysis.

ABSTRACT: Wagle, JP, Cunanan, AJ, Carroll, KM, Sams, ML, Wetmore, A, Bingham, GE, Taber, CB, DeWeese, BH, Sato, K, Stuart, CA, and Stone, MH. Accentuated eccentric loading and cluster set configurations in the back squat: a kinetic and kinematic analysis. J Strength Cond Res 35(2): 420-427, 2021-This study examined the kinetic and kinematic differences between accentuated eccentric loading (AEL) and cluster sets in trained male subjects (age = 26.1 ± 4.1 years, height = 183.5 ± 4.3 cm, body mass = 92.5 ± 10.5 kg, and back squat to body mass ratio = 1.8 ± 0.3). Four load condition sessions consisted of traditionally loaded (TL) "straight sets," TL cluster (TLC) sets, AEL cluster (AEC) sets, and AEL "straight sets" where only the first repetition had eccentric overload (AEL1). An interrepetition rest interval of 30 seconds was prescribed for both TLC and AEC. Concentric intensity for all load conditions was 80% 1 repetition maximum (1RM). Accentuated eccentric loading was applied to repetitions using weight releasers with total eccentric load equivalent to 105% of concentric 1RM. Traditionally loaded cluster had statistically greater concentric outputs than TL. Furthermore, statistically greater eccentric and concentric outputs were observed during AEC compared with TL with the exception of peak power. Statistically greater concentric characteristics were observed in TLC compared with AEL1, but statistically greater eccentric outputs were observed in AEL1. In the 2 cluster set conditions, statistically greater concentric rate of force development (RFDCON) (d = 0.470, p < 0.001) and average velocity (vavg) (d = 0.560, p < 0.001) in TLC compared with AEC were observed. However, statistically greater eccentric work (WECC) (d = 2.096, p < 0.001) and eccentric RFD (RFDECC) (d = 0.424, p < 0.001) were observed in AEC compared with TLC. Overall, eccentric overload demonstrated efficacy as a means of increasing eccentric work and RFD, but not as a means of potentiating concentric output. Finally, interrepetition rest seems to have the largest influence on concentric power output and RFD.

Using the Session Rating of Perceived Exertion to Quantify Training Load in a Men's College Soccer Team.

Sams, ML, Wagle, JP, Sato, K, DeWeese, BH, Sayers, AL, and Stone, MH. Using the session rating of perceived exertion to quantify training load in a men's college soccer team. J Strength Cond Res 34(10): 2793-2799, 2020-The purpose of this study was to examine the training load (TL) programming of 3 training groups of a National Collegiate Athletic Association Division I men's college soccer team across a season. Thirty athletes were classified as starters (S), substitutes (NS), or redshirts (RS) based on the percentage of possible minutes played during the season. Training load was quantified at the season, phasic, and weekly levels by the session rating of perceived exertion. Between-group differences were observed at the season level (p < 0.001), and group-by-time interactions for average weekly TL were found at both the phasic (p = 0.04) and weekly levels (p < 0.001). In general, S accumulated greater TL than NS (effect size range for all analyses: -0.59 < d < 1.91) and RS (0.17 < d < 3.67), and NS accumulated greater TL than RS (-0.54 < d < 2.34). Within-group variation at the phasic level was less apparent (-0.35 < d < 1.44); however, all 3 groups displayed training variation at the weekly level (-1.80 < d < 3.24). The session rating of perceived exertion can serve as a low-cost, valid means of quantifying TL in men's college soccer athletes. Practitioners should be especially aware of the possibility of insufficient loading in NS.

Cluster Set Loading in the Back Squat: Kinetic and Kinematic Implications.

Wetmore, A, Wagle, JP, Sams, ML, Taber, CB, DeWeese, BH, Sato, K, and Stone, MH. Cluster set loading in the back squat: Kinetic and kinematic implications. J Strength Cond Res 33(7S): S19-S25, 2019-As athletes become well trained, they require greater stimuli and variation to force adaptation. One means of adding additional variation is the use of cluster loading. Cluster loading involves introducing interrepetition rest during a set, which in theory may allow athletes to train at higher absolute intensities for the same volume. The purpose of this study was to investigate the kinetic and kinematic implications of cluster loading as a resistance training programming tactic compared with traditional loading (TL). Eleven resistance-trained men (age = 26.75 ± 3.98 years, height = 181.36 ± 5.96 cm, body mass = 89.83 ± 10.66 kg, and relative squat strength = 1.84 ± 0.34) were recruited for this study. Each subject completed 2 testing sessions consisting of 3 sets of 5 back squats at 80% of their 1 repetition maximum with 3 minutes of interset rest. Cluster loading included 30 seconds of interrepetition rest with 3 minutes of interset rest. All testing was performed on dual-force plates sampling at 1,000 Hz, and the barbell was connected to 4 linear position transducers sampling at 1,000 Hz. Both conditions had similar values for peak force, concentric average force, and eccentric average force (p = 0.25, effect size (ES) = 0.09, p = 0.25, ES = 0.09, and p = 0.60, ES = 0.04, respectively). Cluster loading had significantly higher peak power (PP) (p < 0.001, ES = 0.77), peak and average velocities (p < 0.001, ES = 0.77, and p < 0.001, ES = 0.81, respectively), lower times to PP and velocity (p < 0.001, ES = -0.68, and p < 0.001, ES = -0.68, respectively) as well as greater maintenance of time to PP (p < 0.001, ES = 1.57). These results suggest that cluster loading may be superior to TL when maintaining power output and time point variables is the desired outcome of training.

The Physical Demands of NCAA Division I Women's College Soccer.

Extensive research into women's collegiate soccer is scarce, leaving gaps in the literature with little information available detailing the physical demands at different standards of play. Our purpose was to elucidate the physical demands of the Division I collegiate level and identify differences between playing positions. Twenty-three field players were observed during four competitive seasons using 10-Hz GPS units (Catapult Sports, Melbourne, Australia). Descriptive statistics and 95% confidence intervals were used to determine group and position-specific physical demands. Linear mixed modelling (LMM) was used to compare attacker, midfielder, and defender position groups. Total distance, high-speed distance, and sprint distance were 9486 ± 300 m, 1014 ± 118 m, and 428 ± 70 m, respectively. Furthermore, attackers were observed to cover the greatest distance at all speeds compared to midfielders and defenders. Our findings suggest that the physical demands of Division I women's soccer differ by position and appear lower compared to higher standards of play. Therefore, coaches and sports scientists responsible for the physical training of Division I collegiate players should consider the specific physical demands of the collegiate level and playing position when prescribing training, as well as in the development of their annual training programs.

Repetition-to-Repetition Differences Using Cluster and Accentuated Eccentric Loading in the Back Squat.

The current investigation was an examination of the repetition-to-repetition magnitudes and changes in kinetic and kinematic characteristics of the back squat using accentuated eccentric loading (AEL) and cluster sets. Trained male subjects (age = 26.1 ± 4.1 years, height = 183.5 ± 4.3 cm, body mass = 92.5 ± 10.5 kg, back squat to body mass ratio = 1.8 ± 0.3) completed four load condition sessions, each consisting of three sets of five repetitions of either traditionally loaded straight sets (TL), traditionally loaded cluster sets (TLC), AEL cluster sets (AEC), and AEL straight sets where only the initial repetition had eccentric overload (AEL1). Eccentric overload was applied using weight releasers, creating a total eccentric load equivalent to 105% of concentric one repetition maximum (1RM). Concentric load was 80% 1RM for all load conditions. Using straight sets (TL and AEL1) tended to decrease peak power (PP) (d = −1.90 to −0.76), concentric rate of force development (RFDCON) (d = −1.59 to −0.27), and average velocity (MV) (d = −3.91 to −1.29), with moderate decreases in MV using cluster sets (d = −0.81 to −0.62). Greater magnitude eccentric rate of force development (RFDECC) was observed using AEC at repetition three (R3) and five (R5) compared to all load conditions (d = 0.21⁻0.65). Large within-condition changes in RFDECC from repetition one to repetition three (∆REP1⁻3) were present using AEL1 (d = 1.51), demonstrating that RFDECC remained elevated for at least three repetitions despite overload only present on the initial repetition. Overall, cluster sets appear to permit higher magnitude and improved maintenance of concentric outputs throughout a set. Eccentric overload with the loading protocol used in the current study does not appear to potentiate concentric output regardless of set configuration but may cause greater RFDECC compared to traditional loading.

Quantifying Changes in Squat Jump Height Across a Season of Men's Collegiate Soccer.

Sams, ML, Sato, K, DeWeese, BH, Sayers, AL, and Stone, MH. Quantifying changes in squat jump height across a season of men's collegiate soccer. J Strength Cond Res 32(8): 2324-2330, 2018-The purposes of this study were to examine the effectiveness of an athlete monitoring program in managing athlete neuromuscular fatigue across a men's collegiate soccer season as measured by changes in squat jump (SJ) height and to compare possible changes with the session rating of perceived exertion (sRPE) training load (TL). Eighteen outfield Division I men's college soccer players performed SJ testing before each game of the fall season in addition to a baseline measurement at the start of preseason. The athletes provided sRPE values after all training sessions, weight-training, and games. Linear mixed modeling was used to compare changes in SJ height across the season with the baseline, and a correlation coefficient and single-lag cross-correlation coefficient were calculated between TL and changes in SJ height. No statistically significant decreases in SJ height occurred across the season, although a moderate practical decline occurred after the preseason (-1.6 cm, effect size = -0.70). The correlation between TL and changes in SJ height was statistically nonsignificant, whereas the cross-correlation was significant (r = 0.18, p = 0.48 and r = 0.55, p = 0.02, respectively). The athlete monitoring program was successful in managing the athletes' neuromuscular fatigue across the season as evidenced by the maintenance of SJ height and positive relationship between TL and changes in SJ height. Thus, SJ monitoring may serve as a useful fatigue monitoring tool for collegiate soccer athletes. Future study is needed, relating changes in vertical jump performance to other markers of athlete preparedness and performance.