Degreasing and bleaching bones using light sources as a tool to increase the safety of teaching osteology at the University of Veterinary Sciences Brno.

The key part of creating bone material for teaching is degreasing and whitening it. However, the substances used are often dangerous and toxic. We tested and compared safer methods based on two physical variables. These are light and heat. The material for our study was 45 femurs from 23 adult domestic dogs (Canis lupus f. familiaris). The bones were divided into three groups of 15 pieces according to the method used to remove muscles and ligaments from their surface. Five femurs from each group were exposed to three different light sources for 28 days-sunlight, warm light from a classical incandescent light bulb and cold light by a LED bulb. At regular intervals, the change in the colour of the bone surface and the amount of fat loss from the medullary cavity was also monitored. The best degreasing and bleaching results were achieved in macerated bones exposed to sunlight. They achieved the required condition as early as 21 days after the start of sun exposure. The biggest problem was haemoglobin, which permeated through the Haversian canals and discoloured the bone tissue. The results showed that the use of light and heat is a suitable and safe alternative to chemical methods of degreasing and bleaching bones. The disadvantage is the length of time, especially for native material.

Applying 3D prints to reconstructing postmortem craniofacial features damaged by devastating head injuries.

Postmortem facial identification is one of the most common techniques for establishing a deceased person's identity. In victims suffering from devastating cranial injuries, the feasibility of facial identification tasks can be compromised by damage to or disfigurement of the identifying cranial features. Although there are several reconstructive approaches, which help experts to restore the essence of person's physical appearance, thus enhancing the chances of recognition, only a few of them involve restoring the fractured cranial bones as the foundation for the reconstructed soft tissues. Here, we propose a technique based on replacement of heavily damaged hard tissues with generic prosthetics manufactured by 3D printing. Our approach does not require medical imaging technologies or other costly lab equipment. It is simple, affordable and relatively labor-efficient. The deceased's reconstructed craniofacial features can be subsequently assessed, photographed, drawn or otherwise reproduced in order to help determine his or her identity. In addition, the imagery can be displayed, published or broadcasted in media without concerns of being overly graphic.