Fatigue Properties of Weakened and Non-weakened Roots Restored with CAD-CAM Milled Fiber Post, Prefabricated Fiber Post, or Cast Metal Post.

STATEMENT OF PROBLEM: Customized glass fiber posts using CAD-CAM technology have been suggested for restoring endodontically treated teeth. However, how weakened or non-weakened roots restored with anatomical CAD-CAM posts behave under cyclic fatigue is not clear. OBJECTIVE: To evaluate the load-bearing capacity under fatigue (fatigue failure load [FFL], the number of cycles for failure [CFF], and survival probabilities) and fracture pattern of weakened and non-weakened roots restored with CAD-CAM fiber post and cores, metal cast-post-core, and prefabricated fiber post and resin core. METHODS AND MATERIALS: A total of 60 crack-free bovine incisor roots (13 mm in length) with standard geometry were obtained and randomly allocated considering the factor "root condition" in two levels (weakened and non-weakened). Thus, half of the roots were weakened to obtain a wall thickness of 0.5 mm. After that, the endodontic treatment was executed, all roots embedded with acrylic resin and the specimens randomly allocated (n=10) considering the factor "post system" in three levels (CAD-CAM: CAD-CAM milled glass-fiber post and core; MBC: metallic-based post and core; and FRC: prefabricated glass-fiber post and composite resin core). The posts were luted with a dual-cure self-adhesive luting agent. Then, all teeth received a metallic crown. An initial load of 100 N at 20 Hz for 5000 cycles was applied for the step-stress fatigue test, followed by incremental steps of 50 N for 20,000 cycles each step, up to failure. A fracture pattern analysis was performed. RESULTS: CAD-CAM fiber post (FFL: 865 N; CFF: 311,000 cycles) presented similar fatigue performance (p>0.05) to FRC (FFL: 925 N; CFF: 335,000 cycles), with 100% of repairable fractures for non-weakened roots; however, both groups presented worse performance than MBC (p<0.05; FFL: 1265 N; CFF: 471,000 cycles) which led to 100% of catastrophic failures. No statistical difference was found in fatigue performance among the three systems for weakened roots (p>0.05; FFL: 1035-1170 N; CFF: 379,000-433,000 cycles), with a high rate of catastrophic failures. CONCLUSIONS: CAD-CAM fiber post presented similar fatigue performance to MBC and FRC approaches when restoring weakened roots. CADCAM was similar to FRC when restoring non-weakened roots, while MBC enhanced fatigue properties in this scenario.

Does the instrument used for the implant site preparation influence the bone-implant interface? A systematic review of clinical and animal studies.

This systematic review evaluates the influence of the instrument used for the implant site preparation on the bone-implant interface. Any type of clinical or animal study were searched for in MEDLINE/PubMed, ISI Web of Science, and SciVerse Scopus. Two independent reviewers screened titles/abstracts of articles and the full-text of potentially eligible studies. Comparisons of bone to implant contact and crestal bone loss were estimated using pairwise meta-analysis. Twenty-nine studies met the inclusion criteria. The instruments identified in the articles were conventional drills (CDs), osteotome (OT), piezoelectric device (PD), Er:YAG LASER (LS) and osseodensification drills (ODs). The meta-analysis on bone to implant contact suggested no difference between CDs and other techniques and the meta-analysis on crestal bone loss suggested no difference between CDs and PD. The survival of implants in sites prepared with CDs vs. OT or PD presented no significant differences. The use of PD provided lower inflammatory response and earlier bone formation when compared to CDs. ODs provided significant biomechanical improvement in comparison to CDs. LS did not provide any relevant improvement in comparison to CDs or PD. The influence of the instrument used for implant site preparation depended on the property evaluated.

A scoping review of root canal revascularization: relevant aspects for clinical success and tissue formation.

The aim of this scoping study was to evaluate the survival rate and nature of tissue formed inside root canals of human immature permanent teeth with necrotic pulps (NIPT) under root canal revascularization (RCR). The search was performed in SciVerse Scopus®, PubMed/MEDLINE, Web of Science®, BIREME and in the grey literature up to November 2015. The keywords were selected using MeSH terms and DECs. Two independent reviewers scrutinized the records obtained considering specific inclusion criteria. The included studies were evaluated in accordance with a modified Arksey and O' Malley's framework. From 375 studies that were evaluated, 75 were included. A total of 367 NIPT were submitted to RCR, from which only 21 needed further endodontic treatment. The weighted mean follow-up time was 17.6 months. The data were derived mainly from case reports (69%) or small case series (15%). NaOCl [0.5-6%] was applied as the disinfecting solution in almost all studies. Triple antibiotic paste was as effective as Ca(OH)2 as on intracanal medicament. De novo tissue was cementum and poorly mineralized bone positive to bone sialoprotein (BSP) but negative to dentine sialoprotein (DSP). Failures were associated mainly with reinfection of the root canal. The majority of included studies reported a significant increase in both root length and width. However, as most of these data came from case reports, they must be interpreted with care, as most were focused on treatment successes (not failures). Therefore, well-designed randomized controlled trials comparing RCR with available apexification treatments are needed to address this gap in the literature.

Can Silanization Increase the Retention of Glass-fiber posts? A Systematic Review and Meta-analysis of In Vitro Studies.

The role of silanes in the bonding of resin luting agents to glass-fiber posts (GFPs) is a controversial topic, and the question still remains whether post silanization is able to improve the retention of GFPs luted into root canals. Thus, this study was designed to determine whether evidence exists to justify silanization of GFPs before cementation to increase their retention into root canals. In vitro studies that evaluated the retention of GFPs cemented into root canals or artificial substrates and that used silane coupling agents for pretreatment of the post were selected. Searches were carried out in PubMed and Scopus databases with no publication year or language limits. The last search was carried out in August 2014. Two distinct data analyses were carried out: 1) control group (no post pretreatment) vs silane only and 2) post pretreatment + silane vs silane only. Pooled-effect estimates were obtained by comparing the difference between each bond strength mean value and were expressed as the weighted mean difference between groups (p≤0.05). A total of 178 articles were found, and 23 were included in the review. The results were affected by the substrate into which the GFPs were luted (teeth or artificial devices). The analysis between control group and silane only for studies that used artificial devices favored the use of silane (p<0.0001), but considering studies that used teeth as substrate, no significant difference was observed (p=0.35). The analysis between silane only and pretreatment + silane did not show a significant difference between groups when artificial devices were used (p=0.71), whereas the analysis favored the use of post pretreatment + silane over silane (p<0.00001) only when the GFPs were luted into teeth. In conclusion, this review indicates that silanization improves the retention of GFPs luted into root canals provided that selective surface pretreatments are applied to the post before silanization.

MMP Inhibitors on Dentin Stability: A Systematic Review and Meta-analysis.

The aim of this study was to systematically review the literature for in vitro and ex vivo studies that evaluated the effect of matrix metalloproteinase (MMP) inhibitors during the adhesive procedure on the immediate and long-term resin-dentin bond strength. The search was conducted in 6 databases with no publication year or language limits, following the Preferred Reporting Items for Systematic Reviews and Meta-Analyses (PRISMA) statement. From 1,336 potentially eligible studies, 48 were selected for full-text analysis, and 30 were included for review, with 17 considered in the meta-analysis. Two reviewers independently selected the studies, extracted the data, and assessed the risk of bias. Pooled effect estimates were expressed as the weighted mean difference between groups. The most used MMP inhibitor was chlorhexidine (CHX). Immediate bond strength results showed no difference between 2% CHX and control; however, a difference was found between 0.2% CHX and control at baseline. After aging, CHX presented higher bond strength values compared to control groups (p < .05). However, this was not observed for longer periods of aging. High heterogeneity was found in some comparisons, especially for the water storage aging subgroup. Subgroup analyses showed that self-etching and etch-and-rinse adhesives are benefited by the CHX use. From the studies included, only 1 presented low risk of bias, while the others showed medium or high risk of bias. The use of MMP inhibitors did not affect the immediate bond strength overall, while it influenced the aged bond strength. Aging procedures influenced bond strength values of the dentin adhesion stability.

The role of resin cement on bond strength of glass-fiber posts luted into root canals: a systematic review and meta-analysis of in vitro studies.

Because there are several ways to cement glass-fiber posts (GFPs) into root canals, there is no consensus on the best strategy to achieve high bond strengths. A systematic review was conducted to determine if there is difference in bond strength to dentin between regular and self-adhesive resin cements and to verify the influence of several variables on the retention of GFPs. This report followed the Preferred Reporting Items for Systematic Reviews and Meta-Analyses statement. In vitro studies that investigated the bond strength of GFPs luted with self-adhesive and regular resin cements were selected. Searches were carried out in the PubMed and Scopus databases. No publication year or language limit was used, and the last search was done in October 2012. A global comparison was performed between self-adhesive and regular resin cements. Two subgroup analyses were performed: 1) Self-adhesive × Regular resin cement + Etch-and-rinse adhesive and 2) Self-adhesive × Regular resin cement + Self-etch adhesive. The analyses were carried out using fixed-effect and random-effects models. The results showed heterogeneity in all comparisons, and higher bond strength to dentin was identified for self-adhesive cements. Although the articles included in this meta-analysis showed high heterogeneity and high risk of bias, the in vitro literature seems to suggest that use of self-adhesive resin cement could improve the retention of GFPs into root canals.

Do educational methods affect students' ability to remove artificial carious dentine? A randomised controlled trial.

This trial aimed to evaluate the influence of two educational methods on students' ability to remove artificial carious dentine. Traditional lecture and lecture plus a live demonstration of artificial carious tissue removal were compared in a blind two-parallel-group design. Twenty-six students were randomly divided into two groups, and their skills were evaluated according to the following criteria: time spent on the dentine excavation procedure (in min), students' perceived confidence in conducting the procedure (graded assessed on a scale from 0 to 10), and the outcome of artificial carious tissue removal, evaluated by measuring the residual dyed artificial carious dentine layer (in µm). Statistical analyses were carried out using a t-test to compare the students' confidence and time spent on the procedure, and a two-way ANOVA was used to compare residual artificial decayed dentine with educational methods and tooth region (incisal, medium, and cervical thirds) as factors. There were no differences between the methods regarding excavation time (P = 0.898) and students' confidence (P = 0.382). The residual artificial carious dentine results showed that the educational method (P < 0.001) and cavity region (P < 0.001) were statistically significant, as was their interaction (P = 0.040). The lecture plus live demonstration group presented the best results for artificial caries removal. Although there were no differences between the two groups for the cervical region, the best results for the lecture plus live demonstration group was in the other two-thirds of the tooth.