High-sensitive multi-pass imaging interferometry of a gas/plasma jet.

To increase the sensitivity of optical interferometry for diagnostic of gas/plasma jet density with weak refractivity, we realize several multi-pass probing setups with the visualization field. These optical setups are based on a modified Michelson interferometer with multi-pass and multi-angle propagation of the probing beam through the transparent inhomogeneity. In comparison to the standard single-pass Mach-Zehnder setup, the multi-pass interferometer allows for an increase in the measurement sensitivity of up to 8 times. This technique can be applied to a transparent axially symmetrical gas/plasma jet with low refractivity.

Experimental platform for investigations of high-intensity laser plasma interactions in the magnetic field of a pulsed power generator.

An experimental platform for the studying of high-intensity laser plasma interactions in strong magnetic fields has been developed based on the 1 MA Zebra pulsed power generator coupled with the 50-TW Leopard laser. The Zebra generator produces 100-300 T longitudinal and transverse magnetic fields with different types of loads. The Leopard laser creates plasma at an intensity of 1019 W/cm2 in the magnetic field of coil loads. Focusing and targeting systems are integrated in the vacuum chamber of the pulsed power generator and protected from the plasma debris and strong mechanical shock. The first experiments with plasma at laser intensity >2 × 1018 W/cm2 demonstrated collimation of the laser produced plasma in the axial magnetic field strength >100 T.

Propagation of a laser-driven relativistic electron beam inside a solid dielectric.

Laser probe diagnostics: shadowgraphy, interferometry, and polarimetry were used for a comprehensive characterization of ionization wave dynamics inside a glass target induced by a laser-driven, relativistic electron beam. Experiments were done using the 50-TW Leopard laser at the University of Nevada, Reno. We show that for a laser flux of ∼2 × 10(18) W/cm2 a hemispherical ionization wave propagates at c/3 for 10 ps and has a smooth electron-density distribution. The maximum free-electron density inside the glass target is ∼2 × 10(19) cm-3, which corresponds to an ionization level of ∼0.1%. Magnetic fields and electric fields do not exceed ∼15 kG and ∼1 MV/cm, respectively. The electron temperature has a hot, ringlike structure with a maximum of ∼0.7 eV. The topology of the interference phase shift shows the signature of the "fountain effect", a narrow electron beam that fans out from the propagation axis and heads back to the target surface. Two-dimensional particle-in-cell (PIC) computer simulations demonstrate radial spreading of fast electrons by self-consistent electrostatic fields driven by laser. The very low ionization observed after the laser heating pulse suggests a fast recombination on the sub-ps time scale.

Transformation of a tungsten wire to the plasma state by nanosecond electrical explosion in vacuum.

Experiment demonstrates the first direct transformation of a tungsten wire core to the plasma state by Joule heating during nanosecond electrical explosion in vacuum. Energy of approximately 130 eV/atom was deposited into the 12 microm W wire coated by 2 microm polyimide during the first approximately 10 ns. All the metal rapidly transformed to highly ionized plasma, while the surrounding polyimide coating remained primarily in a gaseous state. This coating totally suppressed corona formation. The expansion velocity of the wire was approximately 12-18 km/s, the average wire ionization at 50 ns reached approximately 67% with corresponding LTE temperature of approximately 1.2 eV . Explosion of bare W wire demonstrated earlier termination of the wire core heating due to shunting corona generation. Magnetohydrodynamic (MHD) simulation reproduces the main features of coated and uncoated W wire explosion.

Thermodynamical calculation of metal heating in nanosecond exploding wire and foil experiments.

A method of thermodynamical calculation of thin metal wire heating during its electrical explosion is discussed. The technique is based on a calculation of Joule energy deposition taking into account the current wave form and the temperature dependence of the resistivity and heat capacity of the metal. Comparing the calculation to a set of exploding tungsten wire experiments demonstrates good agreement up to the time of melting. Good agreement is also demonstrated with resistive magnetohydrodynamics simulation. A similar thermodynamical calculation for Mo, Ti, Ni, Fe, Al, and Cu shows good agreement with experimental data. The thermodynamical technique is useful for verification of the voltage measurements in exploding wire experiments. This technique also shows good agreement with an exploding W foil experiment.

Wire initiation critical for radiation symmetry in z-pinch-driven dynamic hohlraums.

Axial symmetry in x-ray radiation of wire-array z pinches is important for the creation of dynamic hohlraums used to compress inertial-confinement-fusion capsules. We present the first evidence that this symmetry is directly correlated with the magnitude of the negative radial electric field along the wire surface. This field (in turn) is inferred to control the initial energy deposition into the wire cores, as well as any current shorting to the return conductor.

Dynamics of mass transport and magnetic fields in low-wire-number-array Z pinches.

The dynamics of mass transport were observed in a wire array implosion with multiframe laser probing. Plasma bubbles arise at breaks in the wires. Interferometry shows that the leading edge of the bubbles brings material to the axis of the array. The speed of this material was measured to be > or =3 x 10(7) cm/s during the wire array implosion. A shock was observed during the collision of the bubbles with the precursor. The Faraday effect indicates current flowing in breaks on the wires. The current switches from the imploding mass to the on-axis plasma column at the beginning of the x-ray pulse.

Direct experimental evidence for current-transfer mode operation of nested tungsten wire arrays at 16-19 MA.

Nested tungsten wire arrays (20-mm on 12-mm diam.) are shown for the first time to operate in a current-transfer mode at 16-19 MA, even for azimuthal interwire gaps of 0.2 mm that are the smallest typically used for any array experiment. After current transfer, the inner wire array shows discrete wire ablation and implosion characteristics identical to that of a single array, such as axially nonuniform ablation, delayed acceleration, and trailing mass and current. The presence of trailing mass from the outer and the inner arrays may play a role in determining nested array performance.

Nanosecond electrical explosion of thin aluminum wires in a vacuum: experimental and computational investigations.

Experimental and computational investigations of nanosecond electrical explosion of a thin Al wire in vacuum are presented. We have demonstrated that increasing the current rate leads to increased energy deposited before voltage collapse. The experimental evidence for synchronization of the wire expansion and light emission with voltage collapse is presented. Hydrocarbons are indicated in optical spectra and their influence on breakdown physics is discussed. The radial velocity of low-density plasma reaches a value of approximately 100 km/s. The possibility of an over-critical phase transition due to high pressure is discussed. A one-dimensional magnetohydrodynamic (MHD) simulation shows good agreement with experimental data. The MHD simulation demonstrates separation of the exploding wire into a high-density cold core and a low-density hot corona as well as fast rejection of the current from the wire core to the corona during voltage collapse. Important features of the dynamics for the wire core and corona follow from the MHD simulation and are discussed.

Characteristics and scaling of tungsten-wire-array z -pinch implosion dynamics at 20 MA.

We present observations for 20-MA wire-array z pinches of an extended wire ablation period of 57%+/-3% of the stagnation time of the array and non-thin-shell implosion trajectories. These experiments were performed with 20-mm-diam wire arrays used for the double- z -pinch inertial confinement fusion experiments [M. E. Cuneo, Phys. Rev. Lett. 88, 215004 (2002)] on the Z accelerator [R. B. Spielman, Phys. Plasmas 5, 2105 (1998)]. This array has the smallest wire-wire gaps typically used at 20 MA (209 microm ). The extended ablation period for this array indicates that two-dimensional (r-z) thin-shell implosion models that implicitly assume wire ablation and wire-to-wire merger into a shell on a rapid time scale compared to wire acceleration are fundamentally incorrect or incomplete for high-wire-number, massive (>2 mg/cm) , single, tungsten wire arrays. In contrast to earlier work where the wire array accelerated from its initial position at approximately 80% of the stagnation time, our results show that very late acceleration is not a universal aspect of wire array implosions. We also varied the ablation period between 46%+/-2% and 71%+/-3% of the stagnation time, for the first time, by scaling the array diameter between 40 mm (at a wire-wire gap of 524 mum ) and 12 mm (at a wire-wire gap of 209 microm ), at a constant stagnation time of 100+/-6 ns . The deviation of the wire-array trajectory from that of a thin shell scales inversely with the ablation rate per unit mass: f(m) proportional[dm(ablate)/dt]/m(array). The convergence ratio of the effective position of the current at peak x-ray power is approximately 3.6+/-0.6:1 , much less than the > or = 10:1 typically inferred from x-ray pinhole camera measurements of the brightest emitting regions on axis, at peak x-ray power. The trailing mass at the array edge early in the implosion appears to produce wings on the pinch mass profile at stagnation that reduces the rate of compression of the pinch. The observation of precursor pinch formation, trailing mass, and trailing current indicates that all the mass and current do not assemble simultaneously on axis. Precursor and trailing implosions appear to impact the efficiency of the conversion of current (driver energy) to x rays. An instability with the character of an m = 0 sausage grows rapidly on axis at stagnation, during the rise time of pinch power. Just after peak power, a mild m = 1 kink instability of the pinch occurs which is correlated with the higher compression ratio of the pinch after peak power and the decrease of the power pulse. Understanding these three-dimensional, discrete-wire implosion characteristics is critical in order to efficiently scale wire arrays to higher currents and powers for fusion applications.

Corona-free electrical explosion of polyimide-coated tungsten wire in vacuum.

We present experimental evidence of corona-free electrical explosion of dielectric-coated W wire in vacuum. A fast current rise of approximately 150 A/ns and a coating of 2 microm polyimide are both needed to achieve the corona-free regime of explosion. Breakdown is absent in corona-free explosion; the wire remains resistive, and this allows anomalously high energy deposition (approximately 20 times atomization enthalpy). MHD simulations reproduce the main differences between corona and corona-free explosions. A corona-free explosion of a wire can be useful for the generation of a hot plasma column by direct energy deposition.

Mass-profile and instability-growth measurements for 300-wire Z-pinch implosions driven by 14-18 MA.

We present the first comprehensive study of high wire-number, wire-array Z-pinch dynamics at 14-18 MA using x-ray backlighting and optical shadowgraphy diagnostics. The cylindrical arrays retain slowly expanding, dense wire cores at the initial position up to 60% of the total implosion time. Azimuthally correlated instabilities at the array edge appear during this stage which continue to grow in amplitude and wavelength after the start of bulk motion, resulting in measurable trailing mass that does not arrive on axis before peak x-ray emission.

Polarity effect for exploding wires in a vacuum.

Experimental evidence for a strong influence of the radial electric field on energy deposition into thin metal wires during their electrical explosion in vacuum is presented. Explosion of the metal wire with a positive polarity when the radial electric field "pushes" electrons into the wire results in twice as much deposited energy than with the negative polarity when the radial field "expels" electrons from the wires. Moreover, the axial structure of the deposited energy changes. This effect can be explained by the influence of radial electric field on electronic emission and on vapor breakdown along the wire surface.

Self-focusing, channel formation, and high-energy ion generation in interaction of an intense short laser pulse with a He jet.

Using interferometry, we investigate the dynamics of interaction of a relativistically intense 4-TW, 400-fs laser pulse with a He gas jet. We observe a stable plasma channel 1 mm long and less than 30 microm in diameter, with a radial gradient of electron density approximately 5 x 10(22) cm(-4) and with an on-axis electron density approximately ten times less than its maximum value of 8 x 10(19) cm(-3). A high radial velocity of the surrounding gas ionization of approximately 3.8 x 10(8) cm/s has been observed after the channel formation, and it is attributed to the fast ions expelled from the laser channel and propagating radially outward. We developed a kinetic model which describes the plasma channel formation and the subsequent ambient gas excitation and ionization. Comparing the model predictions with the interferometric data, we reconstructed the axial profile of laser channel and on-axis laser intensity. The estimated maximum energy of accelerated ions is about 500 keV, and the total energy of the fast ions is 5% of the laser pulse energy.