Capsules with Ileocolonic-Targeted Release of Vitamin B2, B3, and C (ColoVit) Intended for Optimization of Gut Health: Development and Validation of the Production Process.

The ileocolonic-targeted delivery of vitamins can establish beneficial alterations in gut microbial composition. Here, we describe the development of capsules containing riboflavin, nicotinic acid, and ascorbic acid covered with a pH-sensitive coating (ColoVit) to establish site-specific release in the ileocolon. Ingredient properties (particle size distribution, morphology) relevant for formulation and product quality were determined. Capsule content and the in vitro release behaviour were determined using a HPLC-method. Uncoated and coated validation batches were produced. Release characteristics were evaluated using a gastro-intestinal simulation system. All capsules met the required specifications. The contents of the ingredients were in the 90.0-120.0% range, and uniformity requirements were met. In the dissolution test a lag-time in drug release of 277-283 min was found, which meets requirements for ileocolonic release. The release itself is immediate as shown by dissolution of the vitamins of more than 75% in 1 h. The production process of the ColoVit formulation was validated and reproducible, it was shown that the vitamin blend was stable during the production process and in the finished coated product. The ColoVit is intended as an innovative treatment approach for beneficial microbiome modulation and optimization of gut health.

Development and potential application of an oral ColoPulse infliximab tablet with colon specific release: A feasibility study.

The monoclonal antibody infliximab is one of the cornerstones in the treatment of Crohn's disease. Local delivery of infliximab would be an alternative to overcome the inherent disadvantages of intravenous therapy. For this purpose 5mg infliximab tablets were developed. To stabilize the antibody during production and storage it was incorporated in a sugar glass containing the oligosaccharide inulin. To obtain colon-specific release a ColoPulse coating was applied. The tablets were stored for 16 months under different conditions based on ICH climatic zone I.

Gastrointestinal pH and Transit Time Profiling in Healthy Volunteers Using the IntelliCap System Confirms Ileo-Colonic Release of ColoPulse Tablets.

INTRODUCTION: ColoPulse tablets are an innovative development in the field of oral dosage forms characterized by a distal ileum and colon-specific release. Previous studies in humans showed release in the ileo-colonic region, but the relationship between gastrointestinal pH and release was not experimentally proven in vivo. This information will complete the in vivo release-profile of ColoPulse tablets. MATERIALS AND METHODS: Release from ColoPulse tablets was studied in 16 healthy volunteers using the dual label isotope strategy. To determine gastrointestinal pH profiles and transit times the IntelliCap system was used. A ColoPulse tablet containing 13C-urea and an uncoated, immediate release tablet containing 15N2-urea were taken simultaneously followed by a standardized breakfast after three hours. Five minutes after intake of the tablets the IntelliCap capsule was swallowed and pH was measured until excretion in the feces. Breath and urine samples were collected for isotope analysis. RESULTS: Full analysis could be performed in 12 subjects. Median bioavailability of 13C -urea was 82% (95% CI 74-94%, range 61-114%). The median lag time (5% release of 13C) was 5:42 h (95% CI 5:18-6:18 h, range 2:36-6:36 h,) There was no statistically significant difference between lag time based on isotope signal and colon arrival time (CAT) based on pH (median 5:42 vs 5:31 h p = 0.903). In all subjects an intestinal pH value of 7.0 was reached before release of 13C from the ColoPulse tablet occurred. DISCUSSION AND CONCLUSIONS: From the combined data from the IntelliCap system and the 13C -isotope signal it can be concluded that release from a ColoPulse tablet in vivo is not related to transit times but occurs in the ileo-colonic region after pH 7.0 is reached. This supports our earlier findings and confirms that the ColoPulse system is a promising delivery system for targeting the distal ileum and colon. TRIAL REGISTRATION: ISRCTN Registry 18301880.

Ulcerative colitis patients with an inflammatory response upon mesalazine cannot be desensitized: a randomized study.

BACKGROUND AND AIMS: Mesalazine is a key drug in the treatment of ulcerative colitis (UC). Intolerance to mesalazine has been described, including fever and gastrointestinal symptoms. Several case reports reported successful desensitization of patients with mesalazine intolerance. The aim was to assess the number of UC patients who are persistently intolerant to mesalazine after single-blinded rechallenge and to test the effectiveness of a rapid desensitization protocol in UC patients demonstrated mesalazine intolerance. METHODS: This is a prospective, single-blind randomized study in UC patients who discontinued mesalazine because of intolerance. Patients with severe reactions were excluded. Eligible patients underwent a skin patch test with mesalazine followed by a single-blinded randomized crossover rechallenge with 500 mg mesalazine or placebo. Patients with symptoms upon rechallenge were admitted to the hospital for 3 days oral desensitization. RESULTS: Nine of the 37 identified UC patients who discontinued mesalazine because of intolerance were included. All nine patients had negative patch tests, seven patients had symptoms (fever, nausea, vomiting and diarrhea) within 2 h upon rechallenge. Four of these seven patients participated in the desensitization protocol and in none a successful desensitization could be performed. All four had an inflammatory intolerance reaction with rise in C-reactive protein. There were no elevations in serum tryptase or urinary-methylhistamine levels observed and no signs of immediate type allergic reactions, like urticaria, bronchial obstruction or anaphylaxis. CONCLUSION: We recommend not to rechallenge UC patients with an inflammatory response upon mesalazine and these patients will not benefit from a rapid desensitization protocol.

Isotope-labelled urea to test colon drug delivery devices in vivo: principles, calculations and interpretations.

This paper describes various methodological aspects that were encountered during the development of a system to monitor the in vivo behaviour of a newly developed colon delivery device that enables oral drug treatment of inflammatory bowel diseases. [(13)C]urea was chosen as the marker substance. Release of [(13)C]urea in the ileocolonic region is proven by the exhalation of (13)CO2 in breath due to bacterial fermentation of [(13)C]urea. The (13)CO2 exhalation kinetics allows the calculation of a lag time as marker for delay of release, a pulse time as marker for the speed of drug release and the fraction of the dose that is fermented. To determine the total bioavailability, also the fraction of the dose absorbed from the intestine must be quantified. Initially, this was done by calculating the time-dependent [(13)C]urea appearance in the body urea pool via measurement of (13)C abundance and concentration of plasma urea. Thereafter, a new methodology was successfully developed to obtain the bioavailability data by measurement of the urinary excretion rate of [(13)C]urea. These techniques required two experimental days, one to test the coated device, another to test the uncoated device to obtain reference values for the situation that 100 % of [(13)C]urea is absorbed. This is hampered by large day-to-day variations in urea metabolism. Finally, a completely non-invasive, one-day test was worked out based on a dual isotope approach applying a simultaneous administration of [(13)C]urea in a coated device and [(15)N2]urea in an uncoated device. All aspects of isotope-related analytical methodologies and required calculation and correction systems are described.

A non-invasive, low-cost study design to determine the release profile of colon drug delivery systems: a feasibility study.

PURPOSE: Conventional bioavailability testing of dosage forms based on plasma concentration-time graphs of two products in a two-period, crossover-design, is not applicable to topical treatment of intestinal segments. We introduce an isotope dual-label approach ((13)C- and (15)N(2)-urea) for colon drug delivery systems that can be performed in a one-day, non-invasive study-design. METHODS: Four healthy volunteers took an uncoated or a ColoPulse-capsule containing (13)C-urea and an uncoated capsule containing (15)N(2)-urea. In case of colon-release (13)C-urea is fermented and (13)C detected as breath (13)CO(2). Absorbed (13)C-urea and (15)N-urea are detected in urine. RESULTS: C and (15)N in urine released from uncoated capsules showed a ratio of 1.01 ± 0.06. The (13)C/(15)N-recovery ratio after intake of a ColoPulse-capsule was constant and lower >12 h post-dose (median 0.22, range 0.13-0.48). The (13)C/(15)N-ratio in a single urine sample at t ≥ 12 h predicted the 24 h non-fermented fraction (13)C of <26 %. Breath (13)CO(2) indicated delayed (>3 h) release and a fermented fraction (13)C >54 %. CONCLUSIONS: Breath and urine (13)C and (15)N data describe the release-profile and local bioavailability of a colon delivery device. This allows non-invasive bioavailability studies for evaluation of colon-specific drug delivery systems without radioactive exposure and with increased power and strongly reduced costs.

Preparation and physicochemical evaluation of a new tacrolimus tablet formulation for sublingual administration.

The aim of this study was to develop a new fast-disintegrating tablet formulation containing 1 mg tacrolimus for sublingual application. First, solid dispersions containing tacrolimus (2.5%, 5% and 10% w/w) incorporated in Ac-Di-Sol(®) and carriers (inulin 1.8 kDa and 4 kDa, and polyvinylpyrrolidone (PVP) K30) were prepared by freeze drying. Subsequently, a tablet formulation composed of a mixture of the solid dispersions, Ac-Di-Sol(®), mannitol, Avicel(®) PH-101 and sodium stearyl fumarate was optimized concerning drug load in the solid dispersions and the type of carrier. Tablet weight was kept constant at 75 mg by adjusting the amount of Avicel(®) PH-101. Differential scanning calorimetry (DSC) and X-ray powder diffraction (XRPD) results indicated the absence of the drug in the crystalline state, which was confirmed by the scanning electron microscopy (SEM). These results suggest that tacrolimus incorporated in all of the solid dispersions was fully amorphous. Dissolution of the tablets containing solid dispersions with a low drug load highly depends on the type of carrier and increased in the order: PVP K30 < inulin 4 kDa < inulin 1.8 kDa. Solid dispersions with a drug load of 10% w/w incorporated in the carriers yielded optimal formulations. In addition, the physicochemical characteristics and the dissolution behavior of the tablet formulation containing inulin 1.8 kDa-based solid dispersions with a drug load of 10% w/w did not change after storage at 20°C/45%RH for 6 months indicating excellent storage stability.

Film coated tablets (ColoPulse technology) for targeted delivery in the lower intestinal tract: influence of the core composition on release characteristics.

The design of a film coating technology which allows a tablet to deliver the drug in the ileocolonic segment would offer new treatment possibilities. The objective is to develop a platform technology that is suitable for a broad range of drug compounds. We developed a coated tablet with a delayed, pulsatile release profile based on a pH-sensitive coating technology (ColoPulse). The production process was validated, and the effect of core composition on the in vitro release and water uptake investigated. The release profile of the standard tablet core composition, based on the use of cellulose as a filler, was independent of the coat thickness in a range of 9.0-13.2 mg/cm(2). The release profile of a coated tablet was strongly influenced when cellulose was partly replaced by the model substance glucose (loss of sigmoidal release), citric acid (stabilization), sodium bicarbonate (destabilization) or sodium benzoate (destabilization). The film coating takes up water when below the pH-threshold. However, this did not cause early disintegration of the coating. The ColoPulse technology is successfully applied on tablets. The in vitro release characteristics of the coated tablets are influenced by the composition of the core.

Applications of stable isotopes in clinical pharmacology.

This review aims to present an overview of the application of stable isotope technology in clinical pharmacology. Three main categories of stable isotope technology can be distinguished in clinical pharmacology. Firstly, it is applied in the assessment of drug pharmacology to determine the pharmacokinetic profile or mode of action of a drug substance. Secondly, stable isotopes may be used for the assessment of drug products or drug delivery systems by determination of parameters such as the bioavailability or the release profile. Thirdly, patients may be assessed in relation to patient-specific drug treatment; this concept is often called personalized medicine. In this article, the application of stable isotope technology in the aforementioned three areas is reviewed, with emphasis on developments over the past 25 years. The applications are illustrated with examples from clinical studies in humans.