Development and Characterization of Inhaled Ethanol as a Novel Pharmacological Strategy Currently Evaluated in a Phase II Clinical Trial for Early-Stage SARS-CoV-2 Infection.

Inhaled administration of ethanol in the early stages of COVID-19 would favor its location on the initial replication sites, being able to reduce the progression of the disease and improving its prognosis. Before evaluating the efficacy and safety of this novel therapeutic strategy in humans, its characterization is required. The developed 65° ethanol formulation is stable at room temperature and protected from light for 15 days, maintaining its physicochemical and microbiological properties. Two oxygen flows have been tested for its administration (2 and 3 L/min) using an automated headspace gas chromatographic analysis technique (HS-GC-MS), with that of 2 L/min being the most appropriate one, ensuring the inhalation of an ethanol daily dose of 33.6 ± 3.6 mg/min and achieving more stable concentrations during the entire treatment (45 min). Under these conditions of administration, the formulation has proven to be safe, based on histological studies of the respiratory tracts and lungs of rats. On the other hand, these results are accompanied by the first preclinical molecular imaging study with radiolabeled ethanol administered by this route. The current ethanol formulation has received approval from the Spanish Agency of Medicines and Medical Devices for a phase II clinical trial for early-stage COVID-19 patients, which is currently in the recruitment phase (ALCOVID-19; EudraCT number: 2020-001760-29).

Determination of butylated hydroxytoluene in food samples by high-performance liquid chromatography with ultraviolet detection and gas chromatography/mass spectrometry.

A reversed-phase high-performance liquid chromatography (RP-HPLC) method was developed and compared with a gas chromatography/mass spectrometry (GC/MS) method for determining butylated hydroxytoluene (BHT) in foodstuffs as a result of migration from plastic packaging. Similar extraction procedures were used in both methods. BHT was quantitated using an external standard in the HPLC method and an internal standard in the GC/MS method. Both methods presented good linearity (r(2) > or = 0.9917) and low detection limits. Recoveries obtained with the HPLC method (chicken meat, 95.8%, and Gouda cheese, 83.9%) were better than with the GC/MS method (chicken meat, 85.6%, and Gouda cheese, 71.3%).

Determination of triclosan in foodstuffs.

A reverse-phase high-performance liquid chromatographic (RP-HPLC) method coupled with an ultraviolet detector was developed to determine triclosan which had migrated into foodstuffs from packaging materials. The method includes extraction with hexane, followed by evaporation to dryness and residue re-dissolution in ACN 90%. Chromatographic separation was performed with a Kromasil 100 C18 column (15 cm x 0.4 cm ID, 5 microm particle size) at 30 degrees C and using ACN and water as mobile phases. Regarding recoveries, good results (higher than 83% and lower than 112%) were obtained for the three representative food matrixes selected (orange juice, chicken breast meat, and Gouda cheese).

Determination of diphenylbutadiene by liquid chromatography-UV-fluorescence in foodstuffs.

Diphenylbutadiene (DPBD) is an optical brightener incorporated into a wide range of polymeric materials. Framed in the FOODMIGROSURE project, it was chosen as a model migrant to study the migration kinetics from polymeric materials in relevant foodstuffs. An analytical method was developed and optimized for the DPBD determination in foods. The sample preparation procedure uses both hexane and acetonitrile as extraction solvents, followed by high-performance liquid chromatography (HPLC) analysis. HPLC analysis was performed using UV detection at a wavelength of 330 nm, and fluorescence detection achieved with excitation and emission wavelengths of 330 and 375 nm, respectively. Good linearity and recovery were achieved. Data are reported.

Determination of bisphenol A diglycidyl ether and its hydrolysis and chlorohydroxy derivatives by liquid chromatography-mass spectrometry.

European Legislation establishes that the sum of the migration levels of bisphenol A diglycidyl ether (BADGE), its hydrolysis (BADGE.H2O and BADGE.2H2O) and chlorohydroxy (BADGE.HCl, BADGE.2HCl and BADGE.H2O.HCl) derivatives shall not exceed the limit of 1 mg/kg in foodstuffs or food simulants. A reversed-phase high-performance liquid chromatographic (RP-HPLC) method combined with mass spectrometry detection using atmospheric pressure chemical ionisation (APCI) is developed for the separation, quantification and identification of the interesting compounds. Quantification of the analytes was carried out in the single ion recording mode, once their characteristic masses were selected from their full spectra, by using an external calibration. The optimised method was suitable for the migration evaluation of these compounds in different samples.