RESUMO
Nickel- and zinc-doped TiO2(B) nanobelts were synthesized using a hydrothermal technique. It was found that the incorporation of 5 at.% Ni into bronze TiO2 expanded the unit cell by 4%. Furthermore, Ni dopant induced the 3d energy levels within TiO2(B) band structure and oxygen defects, narrowing the band gap from 3.28 eV (undoped) to 2.70 eV. Oppositely, Zn entered restrictedly into TiO2(B), but nonetheless, improves its electronic properties (Eg is narrowed to 3.21 eV). The conductivity of nickel- (2.24 × 10-8 S·cm-1) and zinc-containing (3.29 × 10-9 S·cm-1) TiO2(B) exceeds that of unmodified TiO2(B) (1.05 × 10-10 S·cm-1). When tested for electrochemical storage, nickel-doped mesoporous TiO2(B) nanobelts exhibited improved electrochemical performance. For lithium batteries, a reversible capacity of 173 mAh·g-1 was reached after 100 cycles at the current load of 50 mA·g-1, whereas, for unmodified and Zn-doped samples, around 140 and 151 mAh·g-1 was obtained. Moreover, Ni doping enhanced the rate capability of TiO2(B) nanobelts (104 mAh·g-1 at a current density of 1.8 A·g-1). In terms of sodium storage, nickel-doped TiO2(B) nanobelts exhibited improved cycling with a stabilized reversible capacity of 97 mAh·g-1 over 50 cycles at the current load of 35 mA·g-1.
RESUMO
Herein, we report a study of the electronic structure of the ground and first excited states of Rb2TeCl6, Rb2TeBr6, and Rb2TeI6 halide-perovskite-derived crystals. Using X-ray photoelectron spectroscopy (XPS) measurements and density functional theory and multiconfiguration self-consistent field (MCSCF) calculations, the experimental and theoretical XPS spectra of the valence region were obtained. In addition, the effects of the cations and halogen atoms on the electronic structure were determined, and the classification of the excited states in double point group representation was carried out. Furthermore, a possible reason for the luminescence quenching in an isostructural series of crystals containing the [TeI6]2- anions was determined.
RESUMO
Hafnium-doped titania (Hf/Ti = 0.01; 0.03; 0.05) had been facilely synthesized via a template sol-gel method on carbon fibre. Physico-chemical properties of the as-synthesized materials were characterized by X-ray diffraction, Raman spectroscopy, scanning electron microscopy, energy-dispersive X-ray analysis, scanning transmission electron microscopy, X-ray photoelectron spectroscopy, thermogravimetry analysis and Brunauer-Emmett-Teller measurements. It was confirmed that Hf4+ substitute in the Ti4+ sites, forming Ti1-x Hf x O2 (x = 0.01; 0.03; 0.05) solid solutions with an anatase crystal structure. The Ti1-x Hf x O2 materials are hollow microtubes (length of 10-100 µm, outer diameter of 1-5 µm) composed of nanoparticles (average size of 15-20 nm) with a surface area of 80-90 m2 g-1 and pore volume of 0.294-0.372 cm3 g-1. The effect of Hf ion incorporation on the electrochemical behaviour of anatase TiO2 in the Li-ion battery anode was investigated by galvanostatic charge/discharge and electrochemical impedance spectroscopy. It was established that Ti0.95Hf0.05O2 shows significantly higher reversibility (154.2 mAh g-1) after 35-fold cycling at a C/10 rate in comparison with undoped titania (55.9 mAh g-1). The better performance offered by Hf4+ substitution of the Ti4+ into anatase TiO2 mainly results from a more open crystal structure, which has been achieved via the difference in ionic radius values of Ti4+ (0.604 Å) and Hf4+ (0.71 Å). The obtained results are in good accord with those for anatase TiO2 doped with Zr4+ (0.72 Å), published earlier. Furthermore, improved electrical conductivity of Hf-doped anatase TiO2 materials owing to charge redistribution in the lattice and enhanced interfacial lithium storage owing to increased surface area directly depending on the Hf/Ti atomic ratio have a beneficial effect on electrochemical properties.
