Electronic cleansing for 24-h limited bowel preparation CT colonography using principal curvature flow.

CT colonography (CTC) is one of the recommended methods for colorectal cancer screening. The subject's preparation is one of the most burdensome aspects of CTC with a cathartic bowel preparation. Tagging of the bowel content with an oral contrast medium facilitates CTC with limited bowel preparation. Unfortunately, such preparations adversely affect the 3-D image quality. Thus far, data acquired after very limited bowel preparation were evaluated with a 2-D reading strategy only. Existing cleansing algorithms do not work sufficiently well to allow a primary 3-D reading strategy. We developed an electronic cleansing algorithm, aimed to realize optimal 3-D image quality for low-dose CTC with 24-h limited bowel preparation. The method employs a principal curvature flow algorithm to remove heterogeneities within poorly tagged fecal residue. In addition, a pattern recognition-based approach is used to prevent polyp-like protrusions on the colon surface from being removed by the method. Two experts independently evaluated 40 CTC cases by means of a primary 2-D approach without involvement of electronic cleansing as well as by a primary 3-D method after electronic cleansing. The data contained four variations of 24-h limited bowel preparation and was based on a low radiation dose scanning protocol. The sensitivity for lesions ≥ 6 mm was significantly higher for the primary 3-D reading strategy (84%) than for the primary 2-D reading strategy (68%) (p = 0.031). The reading time was increased from 5:39 min (2-D) to 7:09 min (3-D) (p = 0.005); the readers' confidence was reduced from 2.3 (2-D) to 2.1 (3-D) ( p = 0.013) on a three-point Likert scale. Polyp conspicuity for cleansed submerged lesions was similar to not submerged lesions (p = 0.06). To our knowledge, this study is the first to describe and clinically validate an electronic cleansing algorithm that facilitates low-dose CTC with 24-h limited bowel preparation.

Electronic cleansing for computed tomography (CT) colonography using a scale-invariant three-material model.

A well-known reading pitfall in computed tomography (CT) colonography is posed by artifacts at T-junctions, i.e., locations where air-fluid levels interface with the colon wall. This paper presents a scale-invariant method to determine material fractions in voxels near such T-junctions. The proposed electronic cleansing method particularly improves the segmentation at those locations. The algorithm takes a vector of Gaussian derivatives as input features. The measured features are made invariant to the orientation-dependent apparent scale of the data and normalized in a way to obtain equal noise variance. A so-called parachute model is introduced that maps Gaussian derivatives onto material fractions near T-junctions. Projection of the noisy derivatives onto the model yields improved estimates of the true, underlying feature values. The method is shown to render an accurate representation of the object boundary without artifacts near junctions. Therefore, it enhances the reading of CT colonography in a 3-D display mode.

Primary uncleansed 2D versus primary electronically cleansed 3D in limited bowel preparation CT-colonography. Is there a difference for novices and experienced readers?

The purpose of this study was to compare a primary uncleansed 2D and a primary electronically cleansed 3D reading strategy in CTC in limited prepped patients. Seventy-two patients received a low-fibre diet with oral iodine before CT-colonography. Six novices and two experienced observers reviewed both cleansed and uncleansed examinations in randomized order. Mean per-polyp sensitivity was compared between the methods by using generalized estimating equations. Mean per-patient sensitivity, and specificity were compared using the McNemar test. Results were stratified for experience (experienced observers versus novice observers). Mean per-polyp sensitivity for polyps 6 mm or larger was significantly higher for novices using cleansed 3D (65%; 95%CI 57-73%) compared with uncleansed 2D (51%; 95%CI 44-59%). For experienced observers there was no significant difference. Mean per-patient sensitivity for polyps 6 mm or larger was significantly higher for novices as well: respectively 75% (95%CI 70-80%) versus 64% (95%CI 59-70%). For experienced observers there was no statistically significant difference. Specificity for both novices and experienced observers was not significantly different. For novices primary electronically cleansed 3D is better for polyp detection than primary uncleansed 2D.

Lesion conspicuity and efficiency of CT colonography with electronic cleansing based on a three-material transition model.

OBJECTIVE: The purpose of this article is to report the effect on lesion conspicuity and the practical efficiency of electronic cleansing for CT colonography (CTC). MATERIALS AND METHODS: Patients were included from the Walter Reed Army Medical Center public database. All patients had undergone extensive bowel preparation with fecal tagging. A primary 3D display method was used. For study I, the data consisted of all patients with polyps > or = 6 mm. Two experienced CTC observers (observer 1 and observer 2) scored the lesion conspicuity considering supine and prone positions separately. For study II, data consisted of 19 randomly chosen patients from the database. The same observers evaluated the data before and after electronic cleansing. Evaluation time, assessment effort, and observer confidence were recorded. RESULTS: In study I, there were 59 lesions partly or completely covered by tagged material (to be uncovered by electronic cleansing) and 70 lesions surrounded by air (no electronic cleansing required). The conspicuity did not differ significantly between lesions that were uncovered by electronic cleansing and lesions surrounded by air (observer 1, p < 0.5; observer 2, p < 0.6). In study II, the median evaluation time per patient after electronic cleansing was significantly shorter than for original data (observer 1, 20 reduced to 12 minutes; observer 2, 17 reduced to 12 minutes). Assessment effort was significantly smaller for both observers (p < 0.0000001), and observer confidence was significantly larger (observer 1, p < 0.007; observer 2, p < 0.0002) after electronic cleansing. CONCLUSION: Lesions uncovered by electronic cleansing have comparable conspicuity with lesions surrounded by air. CTC with electronic cleansing sustains a shorter evaluation time, lower assessment effort, and larger observer confidence than without electronic cleansing.

Classifying CT image data into material fractions by a scale and rotation invariant edge model.

A fully automated method is presented to classify 3-D CT data into material fractions. An analytical scale-invariant description relating the data value to derivatives around Gaussian blurred step edges--arch model--is applied to uniquely combine robustness to noise, global signal fluctuations, anisotropic scale, noncubic voxels, and ease of use via a straightforward segmentation of 3-D CT images through material fractions. Projection of noisy data value and derivatives onto the arch yields a robust alternative to the standard computed Gaussian derivatives. This results in a superior precision of the method. The arch-model parameters are derived from a small, but over-determined, set of measurements (data values and derivatives) along a path following the gradient uphill and downhill starting at an edge voxel. The model is first used to identify the expected values of the two pure materials (named L and H) and thereby classify the boundary. Second, the model is used to approximate the underlying noise-free material fractions for each noisy measurement. An iso-surface of constant material fraction accurately delineates the material boundary in the presence of noise and global signal fluctuations. This approach enables straightforward segmentation of 3-D CT images into objects of interest for computer-aided diagnosis and offers an easy tool for the design of otherwise complicated transfer functions in high-quality visualizations. The method is applied to segment a tooth volume for visualization and digital cleansing for virtual colonoscopy.

Visualization of boundaries in volumetric data sets using LH histograms.

A crucial step in volume rendering is the design of transfer functions that will highlight those aspects of the volume data that are of interest to the user. For many applications, boundaries carry most of the relevant information. Reliable detection of boundaries is often hampered by limitations of the imaging process, such as blurring and noise. We present a method to identify the materials that form the boundaries. These materials are then used in a new domain that facilitates interactive and semiautomatic design of appropriate transfer functions. We also show how the obtained boundary information can be used in region-growing-based segmentation.

CT colonography: feasibility of substantial dose reduction--comparison of medium to very low doses in identical patients.

In a feasibility study, the authors compared polyp detection and interobserver variability at computed tomographic (CT) colonography in 15 patients with doses ranging from medium to very low (12.00-0.05 mSv). At levels down to 2% of the medium dose, the mean detection of polyps 5 mm or larger remained at least 74%, while the number of false-positive results decreased and the interobserver agreement remained constant. Initial observations indicate that it is feasible to reduce the radiation dose required for CT colonography. Further studies are needed, however, to investigate the clinical value of very low-dose CT colonography.

Three-dimensional display modes for CT colonography: conventional 3D virtual colonoscopy versus unfolded cube projection.

The authors compared a conventional two-directional three-dimensional (3D) display for computed tomography (CT) colonography with an alternative method they developed on the basis of time efficiency and surface visibility. With the conventional technique, 3D ante- and retrograde cine loops were obtained (hereafter, conventional 3D). With the alternative method, six projections were obtained at 90 degrees viewing angles (unfolded cube display). Mean evaluation time per patient with the conventional 3D display was significantly longer than that with the unfolded cube display. With the conventional 3D method, 93.8% of the colon surface came into view; with the unfolded cube method, 99.5% of the colon surface came into view. Sensitivity and specificity were not significantly different between the two methods. Agreements between observers were kappa = 0.605 for conventional 3D display and kappa = 0.692 for unfolded cube display. Consequently, the latter method enhances the 3D endoluminal display with improved time efficiency and higher surface visibility.

CT colonography at different radiation dose levels: feasibility of dose reduction.

PURPOSE: To investigate the sensitivity and specificity of polyp detection and the image quality of computed tomographic (CT) colonography at different radiation dose levels and to study effective doses reported in literature on CT colonography. MATERIALS AND METHODS: CT colonography and colonoscopy were performed with 100 mAs in 50 consecutive patients at high risk for colorectal cancer; 50- and 30-mAs CT colonographic examinations were simulated with controlled addition of noise to raw transmission measurements. One radiologist randomly evaluated all original and simulated images for the presence of polyps and scored image quality. Differences in image quality were assessed with the Wilcoxon rank test. Scan protocols from the literature and recent (unpublished) updates were collected. RESULTS: In nine of 10 patients with polyps 5 mm in diameter or larger (sensitivity, 90%) and in seven of 17 patients with polyps smaller than 5 mm, polyps were correctly identified with CT colonography at all dose levels. Specificity for patients without polyps 5 mm or larger was 53%-60% at all dose levels and for patients without any polyps was 26% (at 100 and 50 mAs) and 48% (at 30 mAs). Image quality decreased significantly as the dose level decreased. The median effective doses (supine and prone positions) calculated from protocols reported in the literature and updates were 7.8 and 8.8 mSv, respectively. CONCLUSION: Although image quality decreases significantly at 30 mAs (3.6 mSv), polyp detection remains unimpaired. The median dose for CT colonography at institutions that perform CT colonographic research is currently 8.8 mSv.