Thermal-induced growth of gold nanoparticles conjugated with thermoresponsive polymer without chemical reduction.

The growth of gold nanoparticles without chemical reduction of gold (III) ions was achieved by the disruption of thermoresponsive polymers conjugated with the gold nanoparticles through the phase transition of the polymers. When a solution of gold nanoparticles coated with thermoresponsive polymers was heated, chains of the thermoresponsive polymers were disrupted because of dehydration, resulting in the fusion of gold nanoparticles to form larger nanoparticles. The evolution of the extinction band around 550 nm evidenced the formation of these large (post-fusion) gold nanoparticles, which were characterized by transmission electron microscope (TEM) and dynamic light scattering (DLS). TEM images verified the formation of the large gold nanoparticles having particle sizes of 80-100 nm, whereas DLS indicated the existence of large nanoparticles with hydrodynamic diameters exceeding 200 nm. The deposition did not require the addition of reductants or trivalent gold ions for the formation of the large gold nanoparticles. Both the heating and the solution conditions were studied to elucidate the mechanism of the formation of large gold nanoparticles.

Monitoring of environmental arsenic by cultures of the photosynthetic bacterial sensor illuminated with a near-infrared light emitting diode array.

Recombinant Rhodopseudomonas palustris, harboring the carotenoid-metabolizing gene crtI (CrtIBS), and whose color changes from greenish yellow to red in response to inorganic As(III), was cultured in transparent microplate wells illuminated with a light emitting diode (LED) array. The cells were seen to grow better under near-infrared light, when compared with cells illuminated with blue or green LEDs. The absorbance ratio of 525 to 425 nm after cultivation for 24 h, which reflects red carotenoid accumulation, increased with an increase in As(III) concentrations. The detection limit of cultures illuminated with near-infrared LED was 5 microgram/l, which was equivalent to that of cultures in test tubes illuminated with an incandescent lamp. A near-infrared LED array, in combination with a microplate, enabled the simultaneous handling of multiple cultures, including CrtIBS and a control strain, for normalization by the illumination of those with equal photon flux densities. Thus, the introduction of a near-infrared LED array to the assay is advantageous for the monitoring of arsenic in natural water samples that may contain a number of unknown factors and, therefore, need normalization of the reporter event.

Colorimetric assay of glutathione based on the spontaneous disassembly of aggregated gold nanocomposites conjugated with water-soluble polymer.

This article describes the glutathione-triggered disassembly of gold nanocomposites composed of gold cores and water-soluble copolymers [poly(N-n-isopropylacrylamide-co-acryloyldiethyletriamine)] attached to the surfaces of gold cores. The gold nanocomposites exhibit a bluish purple color because of the assembled gold cores that are conjugated with the diethylenetriamine groups incorporated into the copolymers. Glutathione added to the gold nanocomposite solution adsorbs onto the surface of the gold cores to liberate diethylenetriamine groups, resulting in spontaneous disassembly that changes the color of the solution to a reddish shade. Increasing the glutathione concentration facilitates the spontaneous disassembly of the gold nanocomposites. For the determination of glutathione, the colorimetric change of the gold nanoparticles is quantified with the a* value of the L*a*b* color coordinates defined by the CIE (Commission Internationale de l'Eclairage) chromaticity diagram. A linear relationship between the a* value and the glutathione concentration of up to 6 x 10(-6) mol/L is obtained 15 min after the addition of glutathione that has a detection limit (defined as 3sigma) of 2.9 x 10(-8) mol/L. The colorimetric assay is successfully applied to the determination of glutathione in eye drops and health supplements.

Colorimetric assay of aminopeptidase N activity based on inhibition of the disassembly of gold nano-composites conjugated with a thermo-responsive copolymer.

A colorimetric change of gold nano-composites conjugated with a thermo-responsive copolymer has been applied to a colorimetric assay to quantify the activity of aminopeptidase N (APN). Heating a solution of assembled gold nano-composites provokes the gold nano-composites to disassemble, leading to a colorimetric change in the solution from blue-purple to red. The disassembly is inhibited by cysteine, but not by cysteinylglycine, thus allowing us to monitor the progress of an enzymatic decomposition of cysteinylglycine into cysteine and glycine with APN. The activity of APN is estimated through a colorimetric change in a solution of gold nano-composites from blue-purple to red, after being heated (98 degrees C for 30 min), followed by being cooled. A good relationship between the a(*) value in L(*)a(*)b(*) color coordinates, which quantified the color of the solution, and the activity of APN was obtained in 3 h of the incubation time, indicating the potential of a colorimetric assay of APN activity.

Blue-to-red chromatic sensor composed of gold nanoparticles conjugated with thermoresponsive copolymer for Thiol sensing.

We describe the first determination of thiol compounds with gold nanocomposites composed of gold nanoparticles and thermoresponsive copolymers having polyamino groups. The gold nanocomposites, which are used as a chromatic sensor, reveal chromatic change from blue to red with thermal stimuli, heating followed by cooling the solution. The blue-to-red chromatic change results from disassembly of the gold nanocomposites, which arises from shrinkage of the thermoresponsive copolymers bound to the gold nanoparticle surfaces due to the phase transition induced by thermal stimuli. The disassembly is inhibited by addition of thiol compounds through displacement of the adhered thermoresponsive copolymers. The detached copolymers no longer influence morphological change of the gold nanocomposites. Corresponding with increase of concentration of the thiol compounds, a solution of the gold nanocomposites after the thermal stimuli shows chromatic change, which was quantified with the a* value in L*a*b* chromatic coordinates. A linear relationship between the a* value and concentration of cysteine, examined as a bio-important thiol, is obtained below 7x10(-6) mol dm(-3), estimating a detection limit defined as 3sigma of the blank to be 2.8x10(-7) mol dm(-3). The chromatic sensor of the gold nanocomposites is applied to the determination of cysteine in commercial supplements containing ascorbic acid, which seriously interferes with redox-based determination of cysteine. Analytical results obtained with the chromatic sensor are identical to those obtained with HPLC.

Simple and selective sensing of cysteine using gold nanoparticles conjugated with a thermoresponsive copolymer having carboxyl groups.

We describe a simple, yet selective cysteine sensor based on gold nanoparticles (AuNPs) conjugated with thermoresponsive copolymers, the carboxyl groups of which are incorporated. Copolymer-conjugated AuNPs, used as the cysteine sensor, in a solution form sediment when cysteine is added. Heating followed by cooling the solution induces phase transitions of the thermoresponsive copolymers, resulting in an acceleration of sedimentation of the copolymer-conjugated AuNPs. The absorbance of supernatants at 520 nm, which are ascribed to a surface plasmon band of discrete AuNPs, decays with increasing concentration of cysteine. Sedimentation of the copolymer-conjugated AuNPs is specific to cysteine. The addition of other popular amino acids, or ascorbic acid, causes no sedimentation of the AuNPs. The relationship between the absorbance of the supernatant at 520 nm and the cysteine concentration provides a sigmoidal profile at a concentration range between 1 x 10(-6) to 6 x 10(-6) mol dm(-3). The determination of cysteine in a supplement is achieved using an inflection point on the sigmoidal profiles.

Tris(2-methyl-8-quinolinolato)iron(III) as a novel spectrophotometric probe for silanol detection.

Tris(2-methyl-8-quinolinolato)iron(III) was proposed as a sensitive spectrophotometric silanol-detecting probe based on the coordination ability of silanol groups on the surface of octadecylsylanized silica gel (ODS silica gel) for reversed-phase high-performance liquid chromatography. A peak of the iron(III) complex on a chromatogram abruptly collapsed as the silanol content in an ODS column increased, indicating that the iron(III) complex could sense trace amounts of silanol groups. The change of the peak parameters, such as the peak height and the peak area was highly related to the output of some nitrogen-containing compounds used as silanol-detecting probes as a function of the silanol content in an ODS column. The response of the peak height of the iron(III) complex to the silanol content was much more sensitive than the response of the nitrogen-containing probes, and was comparable to that of tris(2-methyl-8-quinolinolato)gallium(III), which had been proposed as a fluorometric silanol-detecting probe based on the coordination ability of the silanol groups.

Tris(2-methyl-8-quinolinolato)gallium(III) as a fluorescent probe for sensitive silanol-testing.

The peak shape of tris(2-methyl-8-quinolinolato)gallium(III) by reversed-phase high-performance liquid chromatography was found to be very sensitive to trace amounts of silanol groups on the surface of octadecylsylanized silica gel (ODS silica gel). The variation of the peak of the gallium(III) complex can be used as a probe of the residual silanol groups in an ODS column. The chromatographic peak parameters of the complex were compared with the silanol activities output by some silanol-detecting tests using nitrogen-containing compounds as probes. The comparison was performed with several commercially available ODS columns and laboratory-packed columns in which the amount of silanol groups was controlled by mixing fully endcapped ODS materials and a non-endcapped ODS material. The peak height was the most effective parameter among the peak parameters, and much more sensitive than the silanol-detecting tests using nitrogen-containing compounds, in detecting a trace amount of silanol groups that could not be detected by other silanol-detecting tests.

A novel kinetic method for the speciation of cadmium in river water by micro solvent extraction with dithizone.

Cadmium species in river water were kinetically extracted with dithizone by varying the extraction time. The obtained extraction curve showed a three-stage stepwise profile that reflected the rate of the ligand substitution reaction between the dithizone and cadmium species. Corresponding to each stage, we divided these extracted cadmium species into three groups: "highly labile", "moderately labile" and "slowly labile" species.