SpeedFlower: a comprehensive speed breeding protocol for indica and japonica rice.

To increase rice yields and feed billions of people, it is essential to enhance genetic gains. However, the development of new varieties is hindered by longer generation times and seasonal constraints. To address these limitations, a speed breeding facility has been established and a robust speed breeding protocol, SpeedFlower is developed that allows growing 4-5 generations of indica and/or japonica rice in a year. Our findings reveal that a high red-to-blue (2R > 1B) spectrum ratio, followed by green, yellow and far-red (FR) light, along with a 24-h long day (LD) photoperiod for the initial 15 days of the vegetative phase, facilitated early flowering. This is further enhanced by 10-h short day (SD) photoperiod in the later stage and day and night temperatures of 32/30 °C, along with 65% humidity facilitated early flowering ranging from 52 to 60 days at high light intensity (800 µmol m-2 s-1). Additionally, the use of prematurely harvested seeds and gibberellic acid treatment reduced the maturity duration by 50%. Further, SpeedFlower was validated on a diverse subset of 198 rice accessions from 3K RGP panel encompassing all 12 distinct groups of Oryza sativa L. classes. Our results confirmed that using SpeedFlower one generation can be achieved within 58-71 days resulting in 5.1-6.3 generations per year across the 12 sub-groups. This breakthrough enables us to enhance genetic gain, which could feed half of the world's population dependent on rice.

Rice breeding for yield under drought has selected for longer flag leaves and lower stomatal density.

Direct selection for yield under drought has resulted in the release of a number of drought-tolerant rice varieties across Asia. In this study, we characterized the physiological traits that have been affected by this strategy in breeding trials across sites in Bangladesh, India, and Nepal. Drought- breeding lines and drought-tolerant varieties showed consistently longer flag leaves and lower stomatal density than our drought-susceptible check variety, IR64. The influence of environmental parameters other than drought treatments on leaf traits was evidenced by close grouping of treatments within a site. Flag-leaf length and width appeared to be regulated by different environmental parameters. In separate trials in the Philippines, the same breeding lines studied in South Asia showed that canopy temperature under drought and harvest index across treatments were most correlated with grain yield. Both atmospheric and soil stress strengthened the relationships between leaf traits and yield. The stable expression of leaf traits among genotypes and the identification of the environmental conditions in which they contribute to yield, as well as the observation that some breeding lines showed longer time to flowering and higher canopy temperature than IR64, suggest that selection for additional physiological traits may result in further improvements of this breeding pool.

Genotype × environment interactions for grain iron and zinc content in rice.

BACKGROUND: Nutrient deficiency in humans, especially in children and lactating women, is a major concern. Increasing the micronutrient concentration in staple crops like rice is one way to overcome this. The micronutrient content in rice, especially the iron (Fe) and zinc (Zn) content, is highly variable. The identification of rice genotypes in which there are naturally high Fe and Zn concentrations across environments is an important target towards the production of biofortified rice. RESULTS: Phenotypic correlations between grain Fe and Zn content were positive and significant in all environments but a significant negative association was observed between grain yield and grain Fe and Zn. Promising breeding lines with higher Zn or Fe content, or both, were: IR 82475-110-2-2-1-2 (Zn: 20.24-37.33 mg kg-1 ; Fe: 7.47-14.65 mg kg-1 ); IR 83294-66-2-2-3-2 (Zn: 22-37-41.97 mg kg-1 ; Fe: 9.43-17.16); IR 83668-35-2-2-2 (Zn: 27.15-42.73 mg kg-1 ; Fe: 6.01-14.71); IR 68144-2B-2-2-3-1-166 (Zn: 23.53-40.30 mg kg-1 ; Fe: 10.53-17.80 mg kg-1 ) and RP Bio 5478-185M7 (Zn: 22.60-40.07 mg kg-1 ; Fe: 7.64-14.73 mg kg-1 ). Among these, IR82475-110-2-2-1-2 (Zn: 20.24-37.33 mg kg-1 ; Fe: 7.47-14.65 mg kg-1 ) is also high yielding with 3.75 t ha-1 . Kelhrie Cha (Zn: 17.76-36.45 mg kg-1 ; Fe: 7.17-14.77 mg kg-1 ), Dzuluorhe (Zn: 17.48-39.68 mg kg-1 ; Fe: 7.89-19.90 mg kg-1 ), Nedu (Zn: 18.97-43.55 mg kg-1 Fe: 8.01-19.51 mg kg-1 ), Kuhusoi-Ri-Sareku (Zn: 17.37-44.14 mg kg-1 ; Fe: 8.99-14.30 mg kg-1 ) and Mima (Zn: 17.10-45.64 mg kg-1 ; Fe: 9.97-17.40 mg kg-1 ) were traditional donor genotypes that possessed both high grain Fe and high Zn content. CONCLUSION: Significant genotype × location (G × L) effects were observed in all traits except Fe. Genetic variance was significant and was considerably larger than the variance of G × L for grain Zn and Fe content traits, except grain yield. The G × L × year variance component was significant in all cases. © 2020 Society of Chemical Industry.

Characterization of pond ash-bentonite mixes as landfill liner material.

Characterization of pond ash-bentonite mixes is made to assess their suitability as liner material for waste disposal facilities by examining the relevant index and engineering properties. Further, a comparative assessment is made between sand-bentonite and pond ash-bentonite mixes for the range of bentonite content varying from 0 to 30% by weight at an interval of 5% to ensure an effective substitution of sand with pond ash. Addition of bentonite to sand or pond ash significantly influences the plasticity, strength and permeability properties. Besides, the shape parameters of the coarser fraction and morphology of compacted mixes also influence the engineering properties. A multiple linear regression equation is suggested to predict the hydraulic conductivity of these mixes by considering the basic material properties such as liquid limit, plasticity index and void ratio as an input variable with a correlation coefficient of 0.92 between the measured and predicted hydraulic conductivity values. At comparable conditions, compacted pond ash-bentonite mixes exhibit higher strength but also higher permeability than sand-bentonite mixes. Pond ash-bentonite and sand-bentonite mixes met the liner requirements when compacted with modified Proctor compaction effort at a minimum bentonite content of 20% and 15%, respectively.

In-situ stabilization of sedimented ash deposit by partial penetrating chemical columns.

This paper highlights the efficacy of partial penetrating chemical columns of sodium hydroxide (NaOH) in improving the geo-engineering and leaching characteristics of sedimented ash deposits through a comprehensive laboratory model testing program. Sedimented ash beds were formed in cylindrical tanks and treated with centrally installed chemical columns of either 9M or 18M concentration. After specified curing periods the in-situ moisture content, dry density, unconfined compressive strength (UCS), hydraulic conductivity, pH and concentration of major and trace elements were measured at different locations. Bell-shaped stabilized zones were found to develop around the columns with different magnitudes of strength. A series of sodium based geopolymeric compounds and calcium-based hydration products were identified in the treated ash specimens. Formation of these compounds is primarily responsible for modifying the geo-engineering properties of the sedimented ash deposits. The leaching of different elements from the ash bed is expressed in terms of contamination potential ratio (CPR), which is influenced by the reaction products, the pH of pore fluid and hydraulic conductivity. Test results indicate that chemical columns are quite effective in increasing the strength, reducing the hydraulic conductivity and leachability of elements along with modifying other parameters like in-situ water content and dry density.

Depth of soil compaction predominantly affects rice yield reduction by reproductive-stage drought at varietal screening sites in Bangladesh, India, and Nepal.

AIMS: Drought is the major constraint to rainfed rice productivity in South Asia, but few reports provide detailed characterization of the soil properties related to drought stress severity in the region. The aim of the study was to provide a compilation of drought breeding network sites and their respective levels of drought stress, and to relate soil parameters with yield reduction by drought. METHODS: This study characterized levels of drought stress and soil nutrient and physical properties at 18 geographically distributed research station sites involved in rice varietal screening in Bangladesh, India, and Nepal, as well as at farmers' fields located near the research stations. RESULTS: Based on soil resistance to penetration profiles, a hardpan was surprisingly absent at about half of the sites characterized. Significant relationships of depth of compaction and yield reduction by drought indicated the effects of soil puddling on susceptibility to cracking, rather than water retention by hardpans, on plant water availability in this region. The main difference between research stations and nearby farmers' fields was in terms of soil compaction. CONCLUSIONS: These results present an initiative for understanding the range of severities of reproductive-stage drought stress in drought-prone rainfed lowland rice-growing areas in South Asia.