Short single-frequency self-pulsing Brillouin-Raman distributed feedback fiber laser.

We demonstrate that the stimulated Brillouin scattering of a 250 mm long distributed feedback Raman fiber laser can self-pulse with repetition rates up to 7 MHz, pulse widths of 25 ns, and peak powers of 1.2 W. While both CW and pulsed lasing are produced from a bespoke grating at 1119 nm this laser design could be constructed at almost any wavelength, as the Raman and Brillouin gain regions are relative to the pump wavelength. The laser has a low lasing threshold for a Raman laser of 0.55 W, a peak slope efficiency of 14 %, and a maximum average output of 0.25 W. An investigation of beating between pure Raman and Raman-pumped Brillouin lasing shows that the outputs of the two processes are highly correlated and thus the Brillouin lasing is essentially single-frequency when CW and near transform limited for pulsed operation. A phenomenological model of the Raman-Brillouin interaction shows that the pulsing behaviour of such a cavity is expected and produces very similar pulsing to that the seen in experimental results.

Highly-chirped Bragg gratings for integrated silica spectrometers.

A blazed chirped Bragg grating in a planar silica waveguide device was used to create an integrated diffractive element for a spectrometer. The grating diffracts light from a waveguide and creates a wavelength dependent focus in a manner similar to a bulk diffraction grating spectrometer. An external imaging system is used to analyse the light, later device iterations plan to integrate detectors to make a fully integrated spectrometer. Devices were fabricated with grating period chirp rates in excess of 100 nm mm-1, achieving a focal length of 5.5 mm. Correction of coma aberrations resulted in a device with a footprint of 20 mm×10 mm, a peak FWHM resolution of 1.8 nm, a typical FWHM resolution of 2.6 nm and operating with a 160 nm bandwidth centered at 1550 nm.

Individual inscription of spectrally multiplexed Bragg gratings in optical multicore fibers using small spot direct UV writing.

We have demonstrated the inscription of Bragg gratings into five individual cores of a seven core fiber using small spot direct UV writing. With this technique, we defined spectrally multiplexed Bragg gratings consecutively in separate cores as well as spectrally multiplexed gratings at the same longitudinal location in different cores. The effect of bending on the optical spectrum was evaluated to allow the differentiation between cross-exposure and cross-talk, and an alignment process to reduce cross-exposure by 13 dB was found.

Integrated polarizer based on 45° tilted gratings.

We report the first integrated implementation of a polarizer based on the use of 45° tilted gratings in planar waveguides. The waveguides and gratings are fabricated by direct UV writing in a hydrogenated germanium-doped silica-on-silicon chip. We experimentally demonstrate a polarization extinction ratio per unit length of 0.25 dB mm -1 with a modelled wavelength dependence smaller than 0.3 dB for a 20 mm device over the C band from 1530-1570 nm. We also present a novel numerical study and analytical description of the architecture that are in good agreement with each other and the experimental data.

Thermal approach to classifying sequentially written fiber Bragg gratings.

We demonstrate thermal classification of sequentially written fiber Bragg gratings. This Letter presents a process to determine the type of fiber Bragg grating written in SMF28 and GF4A by introducing the gratings to thermal treatment. This technique can be applied to several approaches based on sequential writing, including the small spot direct ultraviolet writing technique. Four different types of gratings have been identified, which are dependent on the fiber type and fluence used during the writing process.

High-birefringence direct UV-written waveguides for use as heralded single-photon sources at telecommunication wavelengths.

Direct UV-written waveguides are fabricated in silica-on-silicon with birefringence of (4.9 ± 0.2) × 10-4, much greater than previously reported in this platform. We show that these waveguides are suitable for the generation of heralded single photons at telecommunication wavelengths by spontaneous four-wave mixing. A pulsed pump field at 1060 nm generates pairs of photons in highly detuned, spectrally uncorrelated modes near 1550 nm and 800 nm. Waveguide-to-fiber coupling efficiencies of 78-91 % are achieved for all fields. Waveguide birefringence is controlled through dopant concentration of GeCl4 and BCl3 using the flame hydrolysis deposition process. The technology provides a route towards the scalability of silica-on-silicon integrated components for photonic quantum experiments.

Leaky mode integrated optical fibre refractometer.

A route to monitor external refractive indices greater than the core index of the waveguide is presented. Initial application utilizes an integrated optical fibre (IOF) platform due to its potential for use in harsh environment sensing. IOF is fabricated using a bespoke flame hydrolysis deposition process to fuse an optical fibre to a planar substrate achieving an optical quality, ruggedized glass layer between the fibre and substrate was fabricated. The presented refractometer is created by direct UV writing of multiple fibre Bragg gratings into an etched (22 µm diameter) optical fibre post fabrication. Linear regression analysis is applied to quantify propagation loss by monitoring each FBG's back reflected power. The device operates with a sensitivity of approximately 350 dB/cm/RIU at a refractive index of 1.451 at 1550 nm. Numerical simulations using a transfer matrix method are presented and potential routes for development are discussed.

Conclusive quantum steering with superconducting transition-edge sensors.

Quantum steering allows two parties to verify shared entanglement even if one measurement device is untrusted. A conclusive demonstration of steering through the violation of a steering inequality is of considerable fundamental interest and opens up applications in quantum communication. To date, all experimental tests with single-photon states have relied on post selection, allowing untrusted devices to cheat by hiding unfavourable events in losses. Here we close this 'detection loophole' by combining a highly efficient source of entangled photon pairs with superconducting transition-edge sensors. We achieve an unprecedented ∼62% conditional detection efficiency of entangled photons and violate a steering inequality with the minimal number of measurement settings by 48 s.d.s. Our results provide a clear path to practical applications of steering and to a photonic loophole-free Bell test.