Impact of microwave radiation on in vitro starch digestibility, structural and thermal properties of rice flour. From dry to wet treatments.

Microwave radiation (MW) is an environment-friendly technology used to physically modify flours. Rice flour was MW-treated at different moisture content (MC) (3 %, 8 %, 13 %, 15 %, 20 % and 30 %). In vitro starch digestibility was determined and related to the changes caused by MW treatment to flours' structure and thermal properties, which were influenced by MC. A reduction of 49 % and 65 % in the gelatinization enthalpy of samples treated at 20 % and 30 % MC denoted a partial gelatinization. A loss of granular crystallinity in treated samples was confirmed by XR-diffraction and FTIR, particularly at 15 %, 20 % and 30 % MC. MW promoted the formation of random-coil, α-helix and ß-turn protein structure, and the disappearance of LF-ß-sheet. Morphological differences were found between samples treated at 8 % MC (loss of polygonal structure, protein layer covering granules' surface and small holes) and 30 % MC (rounded and aggregated granules, covered with exudate amylose). In vitro starch digestibility revealed that samples treated at 20 % and 30 % MC showed 40 % and 47 % higher rapidly digestible starch, 48 % and 70 % lower slowly digestible starch and 90 % lower resistant starch than the untreated flour. Flour MC in MW-treatment allowed the modulation of structural and thermal characteristics of rice flour and consequently its starch hydrolysis rate.

Substrates emulsification process to improve lipase-catalyzed sardine oil glycerolysis in different systems. Evaluation of lipid oxidation of the reaction products.

Mono- and diacylglycerols rich in omega-3 have a great interest due to their good bioavailability and oxidation stability compared with other kind of omega-3 concentrates. The main drawback in mono- and diacylglycerols production by glycerolysis is the immiscibility of the substrates, oil and glycerol. To improve mass transfer rates, avoiding the use of organic solvents, emulsification of both reactants as reverse micelles (glycerol-in-oil) was carried out previous to lipase-catalyzed sardine oil glycerolysis. Substrate emulsification yielded higher reaction rates compared to kinetics with no previous emulsification, but still lower than in organic solvents. To avoid the use of organic solvent, SC-CO2 was used as reaction medium but no kinetic advantages were demonstrated in the pressure range from 15 to 25 MPa. By increasing temperature, from 40 to 90°C, reaction rates increased both in a solvent-free system and in SC-CO2 medium. It was also found that an increase in temperature does not lead to an increase in the final oxidation status of the reaction products. This behavior was due to the adsorption capacity of the Lipozyme 435 support, giving lower oxidation status at the highest temperature, 80-90°C.

Production and concentration of monoacylglycerols rich in omega-3 polyunsaturated fatty acids by enzymatic glycerolysis and molecular distillation.

Production of monoacylglycerols (MAGs) rich in ω-3 polyunsaturated fatty acids (n-3 PUFAs) was conducted through short path distillation (SPD) of an acylglycerol mixture (containing 67% MAGs) produced by enzymatic glycerolysis of sardine oil with glycerol. A stepwise SPD process in a UIC KDL 5 system (vacuum 10(-3)mbar, feeding flow 1.0 mL/min) was proceeded: the first distillation performed at evaporator temperature (TE) of 110 °C to remove glycerol completely and most of FFAs; and the second distillation at optimized TE 155 °C; resulting in a stream distillate with 91% purity and 94% overall recovery of MAGs. This work also demonstrated that SPD is able to concentrate n-3 PUFAs in MAG form by distilling at proper TE e.g. 125 °C, where n-3 PUFAs are concentrated in the residues. Moreover, this work mapped out a complete processing diagram for scalable production of n-3 PUFAs enriched MAGs as potential food emulsifier and ingredient.

Kinetic study for the ethanolysis of fish oil catalyzed by lipozyme(®) 435 in different reaction media.

The ethanolysis of fish oil in various reaction medium (tert-pentanol, n-hexane and solvent free system) catalyzed by the immobilized commercial lipase Lipozyme(®) 435 (Candida Antarctica) at atmospheric pressure has been studied in this work. The effect of some kinetic parameters, such as the amount of lipase, temperature and the initial reactant molar ratio ethanol:oil on monoacyglyceride and ethyl ester yield has been analyzed. Experimental data were successfully correlated by a simple kinetic model based on the elementary reactions proposed in this work. At high initial reactant molar ratio the three elementary steps can be considered as irreversible. However the reaction rate constants ratio for the deacylation of monoglyceride to glycerol decreased by decreasing the molar ratio ethanol:oil. The reaction rates are slower in n-hexane as reaction medium compared to tert-pentanol and a solvent-free system, at the experimental conditions essayed in this work. In this last case, ethanol acts as solvent for reaction and as reactant.

Characterization of triacylglycerol composition of fish oils by using chromatographic techniques.

Triacylglycerols (TAG) of two different refined fish oils from sardine and a mixture of tuna and sardine oil were separated by reverse phase high performance liquid chromatography (RP-HPLC) with a binary solvent gradient of acetone/acetonitrile. Different fractions were observed in the chromatogram and TAG species were tentatively identified by subsequent analysis of the fatty acid (FA) profile in each fraction by capillary Gas Chromatography (GC). Peak identities were assigned on the basis of a multiple linear regression analysis by using factors such as carbon number, number of double bonds, number of monounsaturated fatty acids (MUFA) and number of polyunsaturated fatty acids (PUFA) in the molecule as predictors for TAG retention time. A successful correlation was obtained between retention times and the equivalent carbon number (ECN) of triacylglycerols. Regiospecific analysis of fatty acids in the TAG has been conducted by ethanolysis of the fish oil by using an immobilized lipase. The subsequent separation of 2-monoacylglycerol (2-MAG) by TLC (thin layer chromatography) analysis showed that ethanolysis system is effective for analysis of FA composition at the 2-position in oils containing PUFA. Principal components analysis (PCA) has been also applied to establish correlations between the different fatty acids in the TAG.