Submerged leaves of live indoor foliage plants adsorb H1N1 influenza virus from suspension.

Control of hazardous indoor particles using plants has attracted interest due to the increasing worldwide air pollution and spread of pandemic-causing viruses. However, the interaction between human pathogenic viruses (HPVs) and live plants has not been examined largely due to issues in detecting tiny amounts of infectious viruses in a carrier (such as an aerosol) and the lack of suitable examination methods. In this study, as a novel evaluation method, the effect of submerged leaves of live plants on HPVs in water was examined, using the H1N1 influenza virus as a model. Selected plant foliage of a live plant was immersed in a small bag containing HPV water suspension. In an initial screening test, the activities of 20 different plant species on the virus suspension were evaluated using a rapid virus detection kit. Ten plant species had the capability to decrease virus concentrations in the water suspension within 72 h. Among the experimental plant species, Epipremnum aureum showed the highest virus decreasing characteristics when examined using both the kit and quantitative real time polymerase chain reaction. The capacity of immersed leaf of live E. aureum to decrease viral content was enhanced when the plant-containing pot was electrically grounded to the earth (approximately 70% decrease in virus concentration). The foliage sample analysis showed that virus adsorption to the plant foliage surface could be the major reason for the decrease in the suspension. These results suggest that the proposed method can be applied to select plants to further investigate plant-HPV interactions.

Morphological and Chemical Evaluations of Leaf Surface on Particulate Matter2.5 (PM2.5) Removal in a Botanical Plant-Based Biofilter System.

Particulate matter has been increasing worldwide causing air pollution and serious health hazards. Owing to increased time spent indoors and lifestyle changes, assessing indoor air quality has become crucial. This study investigated the effect of watering and drought and illumination conditions (constant light, light/dark cycle, and constant dark) on particulate matter2.5 (PM2.5) removal and surface characterization of leaf in a botanical plant-based biofilter system. Using Ardisia japonica and Hedera helix as experimental plants in the plant-based biofilter system, PM2.5, volatile organic carbon, and CO2, as the evaluators of indoor air quality, were estimated using a sensor. Morphological and chemical changes of the leaf surface (i.e., roughness and wax) associated with PM2.5 removal were characterized via scanning electron microscopy, Fourier transform infrared spectroscopy, and atomic force microscopy. The highest PM2.5 removal efficiency, stomata closure, high leaf roughness, and wax layer were observed under drought with constant light condition. Consequently, PM2.5 removal was attributed to the combined effect of leaf roughness and wax by adsorption rather than stomatal uptake. These results suggest that operating conditions of indoor plant-based biofilter system such as watering (or drought) and illumination may be applied as a potential strategy for enhancing PM2.5 removal.

Methodology: non-invasive monitoring system based on standing wave ratio for detecting water content variations in plants.

BACKGROUND: Water content variation during plant growth is one of the most important monitoring parameters in plant studies. Conventional parameters (such as dry weight) are unreliable; thus, the development of rapid, accurate methods that will allow the monitoring of water content variation in live plants is necessary. In this study, we aimed to develop a non-invasive, radiofrequency-based monitoring system to rapidly and accurately detect water content variation in live plants. The changes in standing wave ratio (SWR) caused by the presence of stem water and magnetic particles in the stem water flow were used as the basis of plant monitoring systems. RESULTS: The SWR of a coil probe was used to develop a non-invasive monitoring system to detect water content variation in live plants. When water was added to the live experimental plants with or without illumination under drought conditions, noticeable SWR changes at various frequencies were observed. When a fixed frequency (1.611 GHz) was applied to a single experimental plant (Radermachera sinica), a more comprehensive monitoring, such as water content variation within the plant and the effect of illumination on water content, was achieved. CONCLUSIONS: Our study demonstrated that the SWR of a coil probe could be used as a real-time, non-invasive, non-destructive parameter for detecting water content variation and practical vital activity in live plants. Our non-invasive monitoring method based on SWR may also be applied to various plant studies.

Adsorptive removal of tetracycline from aqueous solution by maple leaf-derived biochar.

The present study evaluates the physicochemical properties of maple leaf-derived biochars (M-BCs) produced at different pyrolytic temperatures (i.e., 350, 550, and 750 °C) and their adsorptive properties for tetracycline onto M-BCs. The increase in pyrolysis temperature to produce M-BCs led to a significant increase in the biochar's hydrophobicity, surface area, and calcite (CaCO3) crystallization. The M-BC750 produced without functionalization or activation possessed a high calcite composition and a hydrophobic nature with lower O/C and H/C, hydroxyl groups (-OH) on the surface, and functional groups (i.e., O-containing) as H-bond acceptors. Among M-BCs, the M-BC750 present a highest TC adsorption capacity owing to possible mechanisms such as metal complexation, H-bonding, and hydrophobic interactions. The isotherm and kinetic models for TC adsorption followed the Freundlich models and pseudo-second-order models, respectively. M-BCs produced from the waste fallen maple leaves could be applied as low-cost environmental adsorbents for TC removal.

Enhanced growth and total fatty acid production of microalgae under various lighting conditions induced by flashing light.

Microalgae are gaining importance as a source of high-value bioproducts. However, data regarding optimization of algal productivity via variation of environmental factors are lacking. Here, we evaluated a novel lighting method for the enhancement of biomass and total fatty acid (TFA) productivities during algal cultivation. We cultivated six different algal strains (Chlorella vulgaris KCTC AG10002, Acutodesmus obliquus KGE18, Uronema sp. KGE03, Micractinium reisseri KGE19, Fragilaria sp., and Spirogyra sp.) under various lighting conditions-continuous light (CL), light-dark cycle (LD), and continuous dark (CD)-with or without additional flashing light. We monitored dry cell weight (DCW) and TFA concentrations during cultivation. For each algal strain, the growth rate showed markedly different responses to the various lighting modes. The growth rates of C. vulgaris KCTC AG10002 (1.34-fold DCW increase, LD with flash), A. obliquus KGE18 (5.16-fold DCW increase, LD with flash), Uronema sp. KGE03 (2.77-fold DCW increase, CL with flash), and M. reisseri KGE19 (1.52-fold DCW increase, CL with flash) markedly increased in response to flashing light. Additionally, in some algal strains cultivated under the LD mode, the flashing light treatment induced increased TFA concentrations (C. vulgaris, 1.19-fold increase; A. obliquus, 2.59-fold increase; and M. reisseri, 3.31-fold increase). Phytohormone analysis of M. reisseri revealed increases in growth rate and TFA concentrations, associated with phytohormone induction via flashing light (e.g. 2.93-fold increase in gibberellic acid); hence, flashing light can promote substantial alterations in algal metabolism.

In vitro cytotoxic evaluation of MgO nanoparticles and their effect on the expression of ROS genes.

Water-dispersible MgO nanoparticles were tested to investigate their cytotoxic effects on oxidative stress gene expression. In this in vitro study, genes related to reactive oxygen species (ROS), glutathione S-transferase (GST) and catalase, were quantified using real-time polymerase chain reactions (molecular level) and molecular beacon technologies (cellular level). The monodispersed MgO nanoparticles, 20 nm in size, were used to treat human cancer cell lines (liver cancer epithelial cells) at different concentrations (25, 75 and 150 µg/mL) and incubation times (24, 48 and 72 h). Both the genetic and cellular cytotoxic screening methods produced consistent results, showing that GST and catalase ROS gene expression was maximized at 150 µg/mL nanoparticle treatment with 48 h incubation. However, the genotoxic effect of MgO nanoparticles was not significant compared with control experiments, which indicates its significant potential applications in nanomedicine as a diagnostic and therapeutic tool.

LED light stress induced biomass and fatty acid production in microalgal biosystem, Acutodesmus obliquus.

Microbial algal system can serve as a potential source for the production of much high value bioproducts and biofuels. The quality and intensity of light are the key elements to optimize the production of algal biomass and fatty acid contents. This study presents the effect of differential LED flashing light conditions on the growth of microalgae, Acutodesmus obliquus. The induced light stress was optimized for its biomass and fatty acid content. The microalgae are exposed to various frequency of intermittent LED flashing light (blue and red lights) at three different phases in the 18 day cell growth (log, lag and stationary phase). The frequency of light flashing rate was adjusted to 120, 10, 5, 3.75, and 1 times per min. The effect of light stress on growth and fatty acids composition of A. obliquus induced an increase in algae growth and fatty acid production. Different optimal timing for light stress was subjected to elucidate the effect of light stress on algae growth and fatty acid production. The results showed an increase in the algae growth (1.2mg/L of chl a content) under light stress condition at FT10 (flashing time, 10 times per min) from the initial day (log phase) compared with the control experiment (0.4 mg/L of chl a content). However, the total fatty acids (71 mg/g) and volumetric FAME production (9.4 ml/l) level was found to be significant under FT5 (flashing time, 5 times per min), adopting flashing light from day 10 (stationary phase). TEM studies also revealed the deposition of lipid to be largest in the 18 day old cells under flashing light (FT5) condition, representing maximum accumulation of lipids bodies (up to 770 nm diameter in particle size) occupying approximately 42% of the total area of the cell.