Symmetric Breakage-Induced Semimetallic State: Polymorphism in Ruthenate Nanosheets.

Atomic arrangements and their symmetries govern the physical properties of materials, including nanosheets that are low-dimensional nanomaterials. Although they have the same composition, symmetric changes associated with atomic displacements sometimes induce unexpected physical properties. Herein, we report that symmetric breakage induces a semimetallic state in chemically exfoliated ruthenate nanosheets. The atomic arrangements and symmetries are determined by a pair distribution function (PDF); subsequently, the physical properties are discussed using ab initio calculations and resistivity measurements. Ruthenate nanosheets can adopt an electronic structure similar to that of graphene owing to symmetric breakage. We experimentally confirmed the polymorphism in ruthenate nanosheets that highlights the importance of symmetric analysis, even in low-dimensional materials.

Postsynthetic Defect Formation in Three-Dimensional Hofmann-Type Coordination Polymers and Its Impact on Catalytic Activity.

We report a systematic investigation of postsynthetic defect formation in Hofmann-type coordination polymers M(pz)[M'(CN)4] (M = Fe2+, Co2+, Ni2+; M' = Pd2+, Pt2+; pz = pyrazine). These compounds readily undergo selective ligand exchange at the pyrazine site when immersed in methanol (MeOH) at ambient temperature. The ligand exchange changes the chemical formula to M(pz)1-x(MeOH)2x[M'(CN)4] (0 < x < 0.3), affording a defective coordination environment around the M ions. The defect concentration is highly dependent on the combination of the metal ions and solvent species, reaching the defect concentration of ca. 30% (x ∼ 0.3) at maximum. The magnetic state of one such coordination polymer gives an additional control of the defect formation, making the compound less susceptible to the ligand exchange at the low-spin state. Structures that form the defects at a high concentration function as catalysts and promote an acetalization reaction heterogeneously by providing Lewis acidic sites. The solvent-dependent character of the defect formation can be used to control the catalytic activity of the active compounds, demonstrating a facile defect engineering for functionalizing solid materials.

Low-Temperature H2 Reduction of Copper Oxide Subnanoparticles.

Invited for the cover of this issue is Kimihisa Yamamoto and co-workers at Tokyo Institute of Technology and International Christian University. The image depicts enhanced reactivity of the copper oxide subnanoparticles under low-temperature conditions. Read the full text of the article at 10.1002/chem.202100508.

Low-Temperature H2 Reduction of Copper Oxide Subnanoparticles.

Subnanoparticles (SNPs) with sizes of approximately 1 nm are attractive for enhancing the catalytic performance of transition metals and their oxides. Such SNPs are of particular interest as redox-active catalysts in selective oxidation reactions. However, the electronic states and oxophilicity of copper oxide SNPs are still a subject of debate in terms of their redox properties during oxidation reactions for hydrocarbons. In this work, in situ X-ray absorption fine structure (XAFS) measurements of Cu28 Ox SNPs, which were prepared by using a dendritic phenylazomethine template, during temperature-programmed reduction (TPR) with H2 achieved lowering of the temperature (T50 =138 °C) reported thus far for the CuII →CuI reduction reaction because of Cu-O bond elongation in the ultrasmall copper oxide particles.

Enhanced Catalytic Performance of Subnano Copper Oxide Particles.

Subnanoparticles (SNPs) with ultrasmall particle sizes (<1 nm) have potential to provide catalytic activity that is superior to that of nanoparticles. Size-controlled CunOx (n = 12, 28, and 60) materials supported on zirconia, prepared using a dendritic macromolecular reactor, exhibited increased ionicity of the Cu-O bonds with a decrease in size of the particles, which was suggested on the basis of the peak intensity in the Cu 2p3/2 region. The polarization of the Cu-O bonds in the ultrasmall copper oxides provides size-dependent catalytic activity in aerobic oxidation of the CH3 group bonded with aromatic rings. The smallest Cu12Ox materials achieved an excellent large turnover number (TON = 40 206) without any significant deactivation.

A useful preparation of ultrasmall iron oxide particles by using arc plasma deposition.

Ultrasmall particles, different from the larger size nanoparticles, have recently attracted significant attention in the scientific community in nanotechnology for catalytic, electronic and optical applications; however, their magnetic properties remain unexplored due to the difficult structural analysis. A challenging issue is to develop a preparation method for iron oxide particles (IOPs) with fine size control, and to determine the dependence of magnetic properties on the morphology and crystallinity of the magnetic particles. However, synthetic approaches to obtain IOPs, regarded as one of the new fields of magnetic nanoparticles, have been significantly limited. This article reported a developed synthetic method to prepare IOPs on carbon supports using pulsed arc plasma deposition (APD) in flowing oxygen gas, which clarified the finely-controlled formation of IOPs on graphene nanosheets. Structural characterization of the IOPs revealed the formation of crystalline γ-Fe2O3 ultrasmall particles with oxygen deficiency. The pulsed APD method for IOPs is the first simple and convenient technique to not only prevent significant aggregation and contamination by organic compounds and avoid the need for thermal pretreatment, but also provide uniform crystalline nano-order particles.