Reversible optical control of magnetism in engineered artificial multiferroics.

Optical means instead of electric fields may offer a new pathway for low-power and wireless control of magnetism, holding great potential to design next-generation memory and spintronic devices. Artificial multiferroic materials have shown remarkable suitability as platforms towards the optical control of magnetic properties. However, the practical use of magnetic modulation should be both stable and reversible and, particularly, it should occur at room temperature. Here we show an unprecedented reversible modulation of magnetism using low-intensity visible-light in Fe75Al25/BaTiO3 heterostructures, at room temperature. This is enabled by the existence of highly oriented charged domain walls arranged in arrays of alternating in-plane and out-of-plane ferroelectric domains with stripe morphology. Light actuation yields a net anisotropic stress caused by ferroelectric domain switching, which leads to a 90-degree reorientation of the magnetic easy axis. Significant changes in the coercivity and squareness ratio of the hysteresis loops can be light-modulated, encouraging the development of novel low energy-consumption wireless magneto-optical devices.

Tunable Molecular Electrodes for Bistable Polarization Screening.

The polar discontinuity at any ferroelectric surface creates a depolarizing field that must be screened for the polarization to be stable. In capacitors, screening is done by the electrodes, while in bare ferroelectric surfaces it is typically accomplished by atmospheric adsorbates. Although chemisorbed species can have even better screening efficiency than conventional electrodes, they are subject to unpredictable environmental fluctuations and, moreover, dominant charged species favor one polarity over the opposite. This paper proposes a new screening concept, namely surface functionalization with resonance-hybrid molecules, which combines the predictability and bipolarity of conventional electrodes with the screening efficiency of adsorbates. Thin films of barium titanate (BaTiO3 ) coated with resonant para-aminobenzoic acid (pABA) display increased coercivity for both signs of ferroelectric polarization irrespective of the molecular layer thickness, thanks to the ability of these molecules to swap between different electronic configurations and adapt their surface charge density to the screening needs of the ferroelectric underneath. Because electron delocalization is only in the vertical direction, unlike conventional metals, chemical electrodes allow writing localized domains of different polarity underneath the same electrode. In addition, hybrid capacitors composed of graphene/pABA/ferroelectric have been made with enhanced coercivity compared to pure graphene-electode capacitors.

Enhancing Analytical Performance of (Mg,Fe)3O4/Glassy Carbon Electrodes by Tailoring Chemical Composition of (Mg,Fe)3O4 Nanoparticles.

A series of MgxFe3-xO4 (x ═ 0-1) nanoparticles was synthesized in order to prepare novel MgxFe3-xO4/glassy carbon modified electrodes. Effects of magnesium content (x) on the analytical performance of the modified electrodes in the detection of gallic acid were evaluated. It was found that magnesium concentration and crystallite/particle size of the prepared nanoparticles play significant roles in the sensing properties of modified electrodes. The increase of magnesium concentration up to the value of x ═ 0.4 in MgxFe3-xO4/glassy carbon paste was accompanied by an increase of the corresponding oxidation current of gallic acid. However, further growth of x value caused decline of the obtained oxidation current. An electroanalytical procedure was established, and the analytical performance of the proposed Mg0.4Fe2.6O4/glassy carbon paste electrode was monitored using previously optimized experimental conditions. A working linear range from 1-39 µM gallic acid was obtained with detection limit of 0.29 µM. According to these results, the developed procedure can be applied for detection of low concentrations of gallic acid with satisfactory selectivity in the presence of some common naturally occurring compounds. Experimental results indicate that the developed procedure could be a novel approach in the detection of antioxidant, overcoming some known disadvantages such as passivation, and could be a promising replacement for sophisticated chromatographic methods.