The electronics in fluorescent bulbs and light emitting diodes (LED), rather than ultraviolet radiation, cause increased malignant melanoma incidence in indoor office workers and tanning bed users.

The epidemiology of cutaneous malignant melanoma (CMM) has a number of facets that do not fit with sunlight and ultraviolet light as the primary etiologic agents. Indoor workers have higher incidence and mortality rates of CMM than outdoor workers; CMM occurs in body locations never exposed to sunlight; CMM incidence is increasing in spite of use of UV blocking agents and small changes in solar radiation. Installation of two new fluorescent lights in the milking parlor holding area of a Minnesota dairy farm in 2015 caused an immediate drop in milk production. This lead to measurement of body amperage in humans exposed to modern non-incandescent lighting. People exposed to old and new fluorescent lights, light emitting diodes (LED) and compact fluorescent lights (CFL) had body amperage levels above those considered carcinogenic. We hypothesize that modern electric lighting is a significant health hazard, a carcinogen, and is causing increasing CMM incidence in indoor office workers and tanning bed users. These lights generate dirty electricity (high frequency voltage transients), radio frequency (RF) radiation, and increase body amperage, all of which have been shown to be carcinogenic. This could explain the failure of ultraviolet blockers to stem the malignant melanoma pandemic. Tanning beds and non-incandescent lighting could be made safe by incorporating a grounded Faraday cage which allows passage of ultraviolet and visible light frequencies and blocks other frequencies. Modern electric lighting should be fabricated to be electrically clean.

Monitoring and remediation of on-farm and off-farm ground current measured as step potential on a Wisconsin dairy farm: A case study.

Ground current commonly referred to as "stray voltage" has been an issue on dairy farms since electricity was first brought to rural America. Equipment that generates high-frequency voltage transients on electrical wires combined with a multigrounded (electrical distribution) system and inadequate neutral returns all contribute to ground current. Despite decades of problems, we are no closer to resolving this issue, in part, due to three misconceptions that are addressed in this study. Misconception 1. The current standard of 1 V at cow contact is adequate to protect dairy cows; Misconception 2. Frequencies higher than 60 Hz do not need to be considered; and Misconception 3. All sources of ground current originate on the farm that has a ground current problem. This case study of a Wisconsin dairy farm documents, 1. how to establish permanent monitoring of ground current (step potential) on a dairy farm; 2. how to determine and remediate both on-farm and off-farm sources contributing to step potential; 3. which step-potential metrics relate to cow comfort and milk production; and 4. how these metrics relate to established standards. On-farm sources include lighting, variable speed frequency drives on motors, radio frequency identification system and off-farm sources are due to a poor primary neutral return on the utility side of the distribution system. A step-potential threshold of 1 V root mean square (RMS) at 60 Hz is inadequate to protect dairy cows as decreases of a few mV peak-peak at higher frequencies increases milk production, reduces milking time and improves cow comfort.

Relationship of electric power quality to milk production of dairy herds - field study with literature review.

Public Utility Commissions (PUC) in several states adopted 0.5 volt rms (root mean squared) or 1.0 milliampere as the actionable limit for utilities to respond to complaints of uncontrolled voltage. This study clearly shows that the actionable level should be reduced to 10 mV p-p (peak-to-peak), which is 140 times less than the current standard. Dairy farmer complaints that animal behavior and milk production were affected by electrical shocks below adopted standards were investigated on 12 farms in Wisconsin, Michigan, and Minnesota. Milk production per cow was determined from daily tank-weight pickup and number of cows milked. Number of transient events, transients, voltage p-p, waveform phase angle degree, sags, and sag-Vrms were measured from event recorders plugged into milk house wall outlets. Data from 1705 cows and 939 data points were analyzed by multiherd least-squares multiple regression and SAS-ANOVA statistical programs. In five herds for 517 days, milk/cow/day decreased -0.0281 kg/transient event as transient events increased from 0 to 122/day (P<0.02). Negative effects on milk/cow/day from event recorder measurements were significant for eight independent electrical variables. Step-potential voltage and frequency of earth currents were measured by oscilloscope from metal plates grouted into the floor of milking stalls. Milk decreased as number of 3rd, 5th, 7th, 21st, 28th, and 42nd harmonics and the sum of triplen harmonics (3rd, 9th, 15th, 21st, 27th, 33rd, and 39th) increased/day (P<0.003). Event recorder transient events were positively correlated with oscilloscope average V p-p event readings. Steps/min counted from videotapes of a dancing cow with no contact to metal in the barnyard were correlated with non-sinusoidal 8.1 to 14.6 mV p-p impulses recorded by oscilloscope for 5 min from EKG patches on legs. PUC standards and use of 500-Ohm resistors in test circuits underestimate effects of non-sinusoidal, higher frequency voltage/current common on rural power lines.