RESUMO
This study investigates Ficus Macrocarpa tree bark fibers (FMB) as a sustainable alternative reinforcement for polymer composites. The Industrial Revolution marked the evolution of polymer composites with synthetic material reinforcement, leading to environmental concerns. Natural fibers have recently gained prominence as efficient alternatives for polymer composites. Despite numerous natural fibers being considered, ensuring a sustainable raw material source remains crucial. In this study, fibers were extracted from FMB and subjected to alkali treatment to evaluate their impact on physical, chemical, and thermal properties. Initially, the extracted fibers measured 253.80 ± 15 µm in diameter, reduced to 223.27 ± 12 µm post-alkali treatment. Chemical analysis showed an increase in cellulose content to 59.7 wt%, a 23.34 % improvement over untreated fibers (48.4 wt%). The crystalline index for untreated and treated fibers measured 80.20 % and 84.75 %, respectively, with no noticeable changes in the cellulose phase. Additionally, the crystalline size increased to 3.21 nm. Thermogravimetric analysis demonstrated enhanced stability of treated fibers up to 378.87 °C, while the kinetic activation energy remained constant at 64.76 kJ/mol for both the treated and the untreated fibers. The alkali treatment further improved surface roughness to 39.26, confirmed by scanning electron microscopic images. These findings highlight the potential of cellulose fibers from Ficus Macrocarpa bark as a sustainable and environmentally friendly replacement for synthetic fibers in polymer composites. The enhanced physical properties and excellent thermal stability make them a promising choice for eco-conscious materials.
RESUMO
The three-dimensional molded interconnected device (3D-MID) has received considerable attention because of the growing demand for greater functionality and miniaturization of electronic parts. Polymer based composite are the primary choice to be used as substrate. These materials enable flexibility in production from macro to micro-MID products, high fracture toughness when subjected to mechanical loading, and they are lightweight. This survey proposes a detailed review of different types of 3D-MID modules, also presents the requirement criteria for manufacture a polymer substrate and the main surface modification techniques used to enhance the polymer substrate. The findings presented here allow to fundamentally understand the concept of 3D-MID, which can be used to manufacture a novel polymer composite substrate.
RESUMO
This work focuses on the fabrication of hybrid bio-composites using green epoxy as the matrix material, hemp (H) and sisal (S) fibre mats as the reinforcements. The hybrid composite with sisal/hemp fibres were fabricated by cost effective hand lay-up technique, followed by hot press with different stacking sequences. Static properties of the composites such as tensile, compressive, inter-laminar shear strengths (ILSS) and hardness were examined. The physical properties such as density, void content, water absorption and thickness swelling were also analyzed. The experimental results indicate that hybrid composites exhibited minor variation in tensile strength when the stacking sequence was altered. The hybrid composite with the intercalated arrangement (HSHS) exhibited the highest tensile modulus when compared with the other hybrid counterparts. Hybrid composites (SHHS and HSSH) offered 40% higher values of compressive strength than the other layering arrangements. HHHH sample exhibited the highest ILSS value of 4.08â¯MPa. Typical failure characteristics of the short beam test such as inter-laminar shear cracks in the transverse direction, micro-buckling and fibre rupture were also observed.
