Tailored beads made of dissolved cellulose--investigation of their drug release properties.

In the frame of this work, we have investigated drug entrapping and release abilities of new type of porous cellulose beads (CBs) as a spherical matrix system for drug delivery. For that purpose, CBs prepared with three different methods were used as drug carriers and three compounds, anhydrous theophylline (Thp), riboflavin 5'-phosphate sodium (RSP) and lidocaine hydrochloride monohydrate (LiHCl) were used as model drug substances. The loading procedure was carried out by immersing swollen empty beads into the solutions of different concentrations of model drugs. The morphology of empty and loaded beads was examined using a field emission scanning electron microscopy (FE-SEM). Near-infrared (NIR) imaging was performed to identify the drug distributions on and within the loaded CBs. The drug amount incorporated into CBs was examined spectrophotometrically and in vitro drug release studies were performed to determine the drug release rates. The results of FE-SEM and chemical NIR imaging analyses revealed that incorporated drug were distributed on the surface and but also within the internal structure of the CBs. Physical properties of CBs and solubility of model drugs had effect on loading efficacy. Also, the drug release rates were controlled by solubility of model drugs (diffusion controlled release). In conclusion, CBs from dissolved cellulose show promise in achieving controlled drug delivery.

Investigation of solid phase composition on tablet surfaces by grazing incidence X-ray diffraction.

PURPOSE: To investigate solid state transformations of drug substances during compaction using grazing incidence X-ray diffraction (GIXD). METHODS: The solid forms of three model drugs-theophylline (TP), nitrofurantoin (NF) and amlodipine besylate (AMB)-were compacted at different pressures (from 100 to 1000 MPa); prepared tablets were measured using GIXD. After the initial measurements of freshly compacted tablets, tablets were subjected to suitable recrystallization treatment, and analogous measurements were performed. RESULTS: Solid forms of TP, NF and AMB showed partial amorphization as well as crystal disordering during compaction; the extent of these effects generally increased as a function of pressure. The changes were most pronounced at the outer surface region. The different solid forms showed difference in the formation of amorphicity/crystal disordering. Dehydration due to compaction was observed for the TP monohydrate, whereas hydrates of NF and AMB were stable towards dehydration. CONCLUSIONS: With GIXD measurements, it was possible to probe the solid form composition at the different depths of the tablet surfaces and to obtain depth-dependent information on the compaction-induced amorphization, crystal disordering and dehydration.

The effect of water plasticization on the molecular mobility and crystallization tendency of amorphous disaccharides.

PURPOSE: To study how water plasticization affects the molecular mobility and crystallization tendency of freeze-dried trehalose, sucrose, melibiose and cellobiose. METHODS: Freeze-dried disaccharides were subjected to different relative humidity atmospheres and their physical stabilities were evaluated. Lyophilizate water sorption tendencies and glass transition temperatures were modeled using Brunauer-Emmett-Teller (BET) and Gordon-Taylor (GT) equations, respectively. Sucrose and cellobiose crystallization tendencies were compared by using the concept of reduced crystallization temperature (RCT), and the molecular mobilities of trehalose and melibiose were compared by measuring their T(1)H relaxation time constants. RESULTS: Based on the BET and GT models, water sorption tendency and the resulting plasticizing effect were different in sucrose when compared to the other disaccharides. Trehalose and melibiose exhibited generally slower crystallization rates when compared to sucrose and cellobiose. Amorphous melibiose was shown to be particularly stable within the studied water content range, which may have partly been caused by its relatively slow molecular mobility. CONCLUSIONS: Slow amorphous-to-crystalline transition rate is known to be important for lyoprotecting excipients when formulating a robust drug product. The physical stabilities of amorphous trehalose and melibiose even with relatively high water contents might make their use advantageous in this respect compared to sucrose and cellobiose.

Calorimetric determination of dissolution enthalpy with a novel flow-through method.

A new calorimetric flow-through system for determining the enthalpies of dissolution with small amount of solids (<1mg) was developed. The system was designed to be used as an add-on cell with a 4 ml twin heat conduction calorimeter 2277 TAM but the principle is adoptable also for other heat conduction calorimeters. The system was tested with two salts (NaCl, KCl), sucrose and different polymorphic forms of theophylline at 25 degrees C and 40 degrees C by using water as the solvent. The system gave more accurate and precise results at 25 degrees C. The precision was not affected by the extent of the dissolution enthalpy. The accuracy was dependent on the calibration utilized but even the normal electrical calibration gave acceptable values. The results obtained at 40 degrees C were also acceptable but not as good as at 25 degrees C due to heat leaks. The effect of heat leaks can be minimized by heating the inflowing solvent outside the calorimeter prior to entering the flow-through cell.

Solvent-mediated solid phase transformations of carbamazepine: Effects of simulated intestinal fluid and fasted state simulated intestinal fluid.

Solvent-mediated transformations of carbamazepine (CBZ) anhydrate form III were investigated in Simulated Intestinal Fluid, a simple USP buffer medium, and in FaSSIF, which contains sodium taurocholate (STC) and lecithin, important surfactants that solubilize lipophilic drugs and lipids in the gastrointestinal tract. Raman spectroscopy (in situ) was utilized to reveal the connection between the changes in solid phase composition and dissolution rate while simultaneously detecting the solid state and the dissolved amount of CBZ. Initial dissolution rate was clearly higher in FaSSIF, while the solid phase data revealed that the crystallization of CBZ dihydrate was inhibited in both the dissolution media, albeit by different mechanisms. In SIF this inhibition was related to extensive needle growth, which impeded medium contact with the solid surface by forming a sterical barrier leading to retarded crystallization rates. Morphological changes from the needle-like dihydrate crystals to plate-like counterparts in FaSSIF, combined with the information that the transformation process was leveled off, evidenced strong hydrogen bonding behavior between the CBZ and STC molecules. These results underline the importance of biologically representative dissolution media in linking the in vitro dissolution results of solids that are capable of hydrate formation to their in vivo dissolution behavior.

Does the preferred orientation of crystallites in tablets affect the intrinsic dissolution?

The aim of this study was to examine the effect of preferred orientation of crystallites, i.e. texture, on the intrinsic dissolution rate of some active pharmaceutical ingredients. Although it has often been speculated that the intrinsic dissolution of pharmaceutical tablets is affected by texture, no experimental evidence of this effect has been reported. The texture of acetylsalicylic acid, tolbutamide, carbamazepine and entacapone tablets was measured using three different methods both before and after the dissolution measurements. To clarify the effect of texture, texturizing and less-texturizing batches of each material were used. The texturizing batches had big needle or plate-like particles and the less-texturizing batches were prepared by grinding the texturizing powders. The USP rotation disc method was used to measure the intrinsic dissolution rate of the samples. The results indicated that the acetylsalicylic acid, tolbutamide and entacapone tablets texturized strongly in compression and the grinding of the texturizing powders decreased the degree of texture. Also the carbamazepine tablets were slightly texturized. All of the texture measurement methods used were found to give acceptable and consistent results and therefore a special texture goniometer is not required to perform these measurements. The intrinsic dissolution rate of all the tablets compacted from the ground powder was slightly higher than the intrinsic dissolution rate of the more texturized samples. However, these differences were not significant on a large scale. After the dissolution tests the degree of texture of the samples was decreased. The intrinsic dissolution rates of the samples were presumably affected by several different parameters such as texture, solubility, pH, surface energetics and crystal strains. Although only small differences were found between the intrinsic dissolution rates of texturized and less texturized samples the effect of texture on the dissolution behavior of the pharmaceuticals should be considered when performing accurate intrinsic dissolution studies.