Specific pelvic shape in patients with developmental dysplasia of the hip on 3D morphometric homologous model analysis.

PURPOSE: To clarify the morphological factors of the pelvis in patients with developmental dysplasia of the hip (DDH), three-dimensional (3D) pelvic morphology was analyzed using a template-fitting technique. METHODS: Three-dimensional pelvic data of 50 patients with DDH (DDH group) and 3D pelvic data of 50 patients without obvious pelvic deformity (Normal group) were used. All patients were female. A template model was created by averaging the normal pelvises into a symmetrical and isotropic mesh. Next, 100 homologous models were generated by fitting the pelvic data of each group of patients to the template model. Principal component analysis was performed on the coordinates of each vertex (15,235 vertices) of the pelvic homologous model. In addition, a receiver-operating characteristic (ROC) curve was calculated from the sensitivity of DDH positivity for each principal component, and principal components for which the area under the curve was significantly large were extracted (p<0.05). Finally, which components of the pelvic morphology frequently seen in DDH patients are related to these extracted principal components was evaluated. RESULTS: The first, third, and sixth principal components showed significantly larger areas under the ROC curves. The morphology indicated by the first principal component was associated with a decrease in coxal inclination in both the coronal and horizontal planes. The third principal component was related to the sacral inclination in the sagittal plane. The sixth principal component was associated with narrowing of the superior part of the pelvis. CONCLUSION: The most important factor in the difference between normal and DDH pelvises was the change in the coxal angle in both the coronal and horizontal planes. That is, in the anterior and superior views, the normal pelvis is a triangle, whereas in DDH, it was more like a quadrilateral.

Morphological characteristics of the lateral ankle ligament complex.

PURPOSE: The relevance of each ligament comprising the lateral ankle ligament complex, including the anterior talofibular ligament (ATFL), calcaneofibular ligament (CFL), and posterior talofibular ligament (PTFL), has not been sufficiently elucidated; therefore, we aimed to clarify the morphological characteristics and relevance of these ligaments. METHODS: Total 152 legs from 152 Japanese cadavers were investigated. The lengths and widths of the ATFL, CFL, and PTFL were measured using a caliper. The ATFL was classified according to the number of fiber bundles (Types I, II, and III corresponded to one, two, and three fiber bundles, respectively), and the lengths and widths of the three ligaments were compared between the Type groups. In addition, the ratio of each ligament's length and width to the tibial length was calculated, and the correlation of the ratio of ligament length and width between the ATFL, CFL, and PTFL was examined about 34 legs. RESULTS: The ATFL, CFL, and PTFL were found to connect at the anterior/inferior tip of the lateral malleolus each other. The Type II group of the ATFL was most common (54.6%) in our investigated specimens. However, there were no significant inter-group differences in the lengths and widths of the CFL and PTFL. CONCLUSIONS: This study demonstrates that the lateral ankle ligaments may stabilize the ankle joint through interconnections.