Assessment of road run-off and domestic wastewater contribution to microplastic pollution in a densely populated area (Flanders, Belgium).

Plastics are omnipresent in our daily life. Unfortunately, the produced plastics will partly end up in the environment including aquatic ecosystems. People often refer to littering or illegal waste dumping as sources of plastic emission to the environment. However, daily-life sources could also, unknowingly, contribute considerably to the total microplastic pollution in the ecosystem. Hence, there is an urgent need to study these potential sources. In this research, two common sources, i.e. domestic wastewater and road run-off from tire and road wear particles, were studied in detail to quantify the relative contribution of both domestic sources towards microplastic pollution in freshwater ecosystems in Flanders, Belgium. This assessment shows that every person (in studied area) emits on average 1145 microplastics (25-1000 µm) daily through domestic wastewater, resulting in a yearly discharge of 418,000 microplastic particles per person. The road run-off samples contained between 0.02 and 9.2 mg tire wear particles per litre per day, which corresponds to an emission of 10.8 mg tire wear particles per driven vehicle km. The gross and net emissions of both above mentioned microplastic sources were extrapolated to the whole Flanders region using an emission model. From the yearly gross microplastic pollution in the domestic wastewater, 623 kg (20%) will be discharged in the freshwater. The highest losses originated from the households that have a private drain or are not (yet) connected to an active wastewater treatment plant. In Flanders, the yearly net microplastic emission into the aquatic environment of tire wear particles is estimated to be 246 tonnes (38%), mainly from the direct run-off from the road surface. Based on the results, specific mitigation measures can be installed to reduce the emission of microplastics towards the freshwater ecosystem. Other sources should be quantified in a similar way for a more holistic strategy to counteract plastic pollution.

Distribution of microplastics in freshwater systems in an urbanized region: A case study in Flanders (Belgium).

Microplastics (MPs) are an emerging pollutant of concern in all known aquatic ecosystems. However, studies at a regional scale on MP pollution in freshwater systems and the necessary risk assessments are limited. Therefore, in this study, we examined microplastic concentrations, size distributions, and polymer types in surface waters and sediments in the geographic region Flanders (Belgium), as a case study for a densely populated region and one of the most developed parts of Europe. Samples have been taken on nine different locations, of which five were repeated in a different weather condition. In total 43 aqueous and nine sediment samples have been collected. The quantity and identity of the microplastics in the samples were determined with µFTIR spectroscopy in the range of 25-1000 µm. The MPs' abundances in surface waters and sediments ranged from 0 to 4.8 MP L-1 (average = 0.48 MP L-1) and from 0 to 9558 MP kg-1 dry weight (average = 2774.57 ± 2317.93 MP kg-1 DW), respectively. Polystyrene and polypropylene were the most common polymer compositions found. No correlations were observed between microplastic concentrations in the sediment/the surface water samples and the measured environmental variables rainfall, conductivity, pH, dissolved oxygen content, waterway flow rate and width, and surrounding land use. Risk assessment results for the measured surface water concentrations through the risk quotient (RQ) method and the probabilistic risk assessment framework suggest that most of the sampled sites in Flanders posed negligible risks to freshwater biota, while this was not the case for some of the sediment concentrations. Our results illustrate the need to urgently develop analytical methods that can routinely measure the full size range of MP in environmental samples to adequately assess risks for the environment.

Toward a Better Understanding of the Contribution of Wastewater Treatment Plants to Microplastic Pollution in Receiving Waterways.

Microplastics (1 µm-5 mm), are ubiquitous in daily-use products and regularly end up in the wastewater. The main part of the wastewater is treated in wastewater treatment plants (WWTPs), which allow for at least partial removal of microplastics. The present study aimed to understand the contribution of domestic wastewater to microplastic pollution in Flanders (Belgium) via two main discharge routes of microplastics: (1) the effluent, and (2) removed fractions. Furthermore the effect of effluent discharge on the microplastic contamination in the waterway was studied in both surface water and sediment samples of upstream and downstream locations of the discharge from three WWTPs. On average, 12.64 ± 20.20 microplastic/L entered a WWTP (10 µm-5 mm). The effluent contained on average 0.41 ± 0.91 microplastic/L, resulting in an average removal efficiency of 97.46% ± 2.33%, which is comparable with various (non-)European countries. Removal efficiencies are both polymer- and size-specific, and data suggest that smaller particles are less efficiently removed from the wastewater, which also causes an increased input of smaller particles to the environment. The sludge is the most efficient treatment process to remove microplastics. Despite the high removal efficiencies, still 1.11 × 107 ± 3.07 × 107 microplastics end up in the nearby waterway daily. Nonetheless, based on the results gathered in the present study, this does not seem to impact the microplastic concentration in the waterway significantly. In summary, the present study offers a holistic approach in the research on the impact of wastewater on microplastic pollution in the ecosystem, integrating different discharge routes and measuring the impact on environmental microplastic pollution. Environ Toxicol Chem 2023;42:642-654. © 2022 SETAC.

Sea Spray Aerosols Contain the Major Component of Human Lung Surfactant.

Marine phytoplankton influence the composition of sea spray aerosols (SSAs) by releasing various compounds. The biogenic surfactant dipalmitoylphosphatidylcholine (DPPC) is known to accumulate in the sea surface microlayer, but its aerosolization has never been confirmed. We conducted a 1 year SSA sampling campaign at the Belgian coast and analyzed the SSA composition. We quantified DPPC at a median and maximum air concentration of 7.1 and 33 pg m-3, respectively. This discovery may be of great importance for the field linking ocean processes to human health as DPPC is the major component of human lung surfactant and is used as excipient in medical aerosol therapy. The natural airborne exposure to DPPC seems too low to induce direct human health effects but may facilitate the effects of other marine bioactive compounds. By analyzing various environmental variables in relation to the DPPC air concentration, using a generalized linear model, we established that wave height is a key environmental predictor and that it has an inverse relationship. We also demonstrated that DPPC content in SSAs is positively correlated with enriched aerosolization of Mg2+ and Ca2+. In conclusion, our findings are not only important from a human health perspective but they also advance our understanding of the production and composition of SSAs.

Phycotoxin-Enriched Sea Spray Aerosols: Methods, Mechanisms, and Human Exposure.

To date, few studies have examined the role of sea spray aerosols (SSAs) in human exposure to harmful and beneficial marine compounds. Two groups of phycotoxins (brevetoxins and ovatoxins) have been reported to induce respiratory syndromes during harmful algal blooms. The aerosolization and coastal air concentrations of other common marine phycotoxins have, however, never been examined. This study provides the first (experimental) evidence and characterization of the aerosolization of okadaic acid (OA), homoyessotoxin, and dinophysistoxin-1 using seawater spiked with toxic algae combined with the realistic SSA production in a marine aerosol reference tank (MART). The potential for aerosolization of these phycotoxins was highlighted by their 78- to 1769-fold enrichment in SSAs relative to the subsurface water. To obtain and support these results, we first developed an analytical method for the determination of phycotoxin concentrations in SSAs, which showed good linearity (R2 > 0.99), recovery (85.3-101.8%), and precision (RSDs ≤ 17.2%). We also investigated natural phycotoxin air concentrations by means of in situ SSA sampling with concurrent aerosolization experiments using natural seawater in the MART. This approach allowed us to indirectly quantify the (harmless) magnitude of OA concentrations (0.6-51 pg m-3) in Belgium's coastal air. Overall, this study provides new insights into the enriched aerosolization of marine compounds and proposes a framework to assess their airborne exposure and effects on human health.

Aerosolizable Marine Phycotoxins and Human Health Effects: In Vitro Support for the Biogenics Hypothesis.

Respiratory exposure to marine phycotoxins is of increasing concern. Inhalation of sea spray aerosols (SSAs), during harmful Karenia brevis and Ostreopsis ovata blooms induces respiratory distress among others. The biogenics hypothesis, however, suggests that regular airborne exposure to natural products is health promoting via a downregulation of the mechanistic target of rapamycin (mTOR) pathway. Until now, little scientific evidence supported this hypothesis. The current explorative in vitro study investigated both health-affecting and potential health-promoting mechanisms of airborne phycotoxin exposure, by analyzing cell viability effects via cytotoxicity assays and effects on the mTOR pathway via western blotting. To that end, A549 and BEAS-2B lung cells were exposed to increasing concentrations (ng·L-1 - mg·L-1) of (1) pure phycotoxins and (2) an extract of experimental aerosolized homoyessotoxin (hYTX). The lowest cell viability effect concentrations were found for the examined yessotoxins (YTXs). Contradictory to the other phycotoxins, these YTXs only induced a partial cell viability decrease at the highest test concentrations. Growth inhibition and apoptosis, both linked to mTOR pathway activity, may explain these effects, as both YTXs were shown to downregulate this pathway. This proof-of-principle study supports the biogenics hypothesis, as specific aerosolizable marine products (e.g., YTXs) can downregulate the mTOR pathway.

Marine biogenics in sea spray aerosols interact with the mTOR signaling pathway.

Sea spray aerosols (SSAs) have profound effects on our climate and ecosystems. They also contain microbiota and biogenic molecules which could affect human health. Yet the exposure and effects of SSAs on human health remain poorly studied. Here, we exposed human lung cancer cells to extracts of a natural sea spray aerosol collected at the seashore in Belgium, a laboratory-generated SSA, the marine algal toxin homoyessotoxin and a chemical inhibitor of the mammalian target of rapamycin (mTOR) pathway. We observed significant increased expression of genes related to the mTOR pathway and Proprotein convertase subtilisin/kexin type 9 (PCSK9) after exposure to homoyessotoxin and the laboratory-generated SSA. In contrast, we observed a significant decrease in gene expression in the mTOR pathway and of PCSK9 after exposure to the natural SSA and the mTOR inhibitor, suggesting induction of apoptosis. Our results indicate that marine biogenics in SSAs interact with PCSK9 and the mTOR pathway and can be used in new potential pharmaceutical applications. Overall, our results provide a substantial molecular evidence base for potential beneficial health effects at environmentally relevant concentrations of natural SSAs.

Clinical outcomes with a trifocal intraocular lens: a multicenter study.

PURPOSE: To evaluate the clinical results and safety obtained with a new type of multifocal intraocular lens (IOL) using a trifocal design to achieve pseudoaccommodation. METHODS: A pilot observational study of patients with a trifocal IOL (FineVision; PhysIOL, Liege, Belgium) implanted by 1 of 12 surgeons between March and December 2010. Visual outcomes that were assessed postoperatively included uncorrected and corrected distance, intermediate, and near visual acuity. RESULTS: One hundred ninety-eight eyes of 99 patients were analyzed. Patients were observed for an average of 6.44 ± 4.67 months (range: 0.2 to 17 months). Preoperative corrected distance visual acuity was 0.22 ± 0.26 logMAR. At the final follow-up visit, corrected distance visual acuity was 0.01 ± 0.10 logMAR, uncorrected distance visual acuity was 0.01 ± 0.06 logMAR, uncorrected intermediate visual acuity was 0.08 ± 0.10 logMAR, and mean uncorrected near visual acuity was 0.00 ± 0.04 logMAR. Postoperative binocular uncorrected distance visual acuity was 0.01 ± 0.07 logMAR, uncorrected intermediate visual acuity was 0.06 ± 0.08 logMAR, and uncorrected near visual acuity was -0.03 ± 0.04 logMAR. Postopeative mean residual sphere was 0.21 ± 0.48 diopters (D), with a residual cylinder of -0.24 ± 0.31 D. Postoperative spherical equivalent was 0.11 ± 0.36 D. CONCLUSIONS: The results demonstrated that the trifocal FineVision IOL is able to restore near, intermediate, and distance visual function.

Visual and refractive outcomes after implantation of a fully diffractive trifocal lens.

BACKGROUND: The purpose of this study was to record the visual outcomes of patients treated by six surgeons after implantation of a trifocal lens. METHODS: The setting for this study comprised six ophthalmology units and eye clinics in Belgium and France, with a coordinating center in France, and data management and statistical analysis in France and Belgium. Ninety-four eyes from 47 patients were implanted with a trifocal FineVision(®) intraocular lens by six surgeons. Monocular and binocular, uncorrected and best distance-corrected, and photopic and mesopic visual acuity was measured, as well as the defocus curve between +4 D and -4 D with best distance correction. RESULTS: Near and far monocular visual acuities were similar to the data published after bifocal intraocular lens implantation. Intermediate vision was improved, and was demonstrated by scores of near visual acuity as well as far visual acuity with defocus -1.5 D-add lens. Far vision is maintained in mesopic conditions. CONCLUSION: The trifocal intraocular lens provides good far, intermediate, and near visual acuity.

Anterior segment imaging using optical coherence tomography and ultrasound biomicroscopy in secondary pigmentary glaucoma associated with in-the-bag intraocular lens.

A 43-year-old man with high myopia developed unilateral pigmentary glaucoma with recurrent episodes of painless blurred vision in the left eye following uneventful phacoemulsification. Bilateral cataract surgery was performed with capsular bag implantation of a +4.00 diopter AcrySof MA60 intraocular lens (IOL) (Alcon Laboratories) followed by a neodymium:YAG laser capsulotomy. Secondary iatrogenic dispersion syndrome in the left eye with subsequent intraocular pressure elevation was suspected in the presence of anterior chamber pigmented cells, circular epithelial iris loss around the pupil, and trabecular hyperpigmentation. Close contact between the edge of the IOL and the posterior pigmented iris epithelium, which was clinically suggested by anterior biomicroscopy, was documented by ultrasound biomicroscopy and optical coherence tomography of the anterior segment.