Few-mode erbium-doped fiber amplifier with photonic lantern for pump spatial mode control.

We demonstrate a few-mode erbium-doped fiber amplifier employing a mode-selective photonic lantern for controlling the modal content of the pump light. Amplification of six spatial modes in a 5 m long erbium-doped fiber to ∼6.2 dBm average power is obtained while maintaining high modal fidelity. Through mode-selective forward pumping of the two degenerate LP21 modes operating at 976 nm, differential modal gains of <1 dB between all modes and signal gains of ∼16 dB at 1550 nm are achieved. In addition, low differential modal gain for near-full C-band operation is demonstrated.

Six mode selective fiber optic spatial multiplexer.

Low-loss all-fiber photonic lantern (PL) mode multiplexers (MUXs) capable of selectively exciting the first six fiber modes of a multimode fiber (LP01, LP11a, LP11b, LP21a, LP21b, and LP02) are demonstrated. Fabrication of the spatial mode multiplexers was successfully achieved employing a combination of either six step or six graded index fibers of four different core sizes. Insertion losses of 0.2-0.3 dB and mode purities above 9 dB are achieved. Moreover, it is demonstrated that the use of graded index fibers in a PL eases the length requirements of the adiabatic tapered transition and could enable scaling to large numbers.

Time-division-multiplexed few-mode passive optical network.

We demonstrate the first few-mode-fiber based passive optical network, effectively utilizing mode multiplexing to eliminate combining loss for upstream traffic. Error-free performance has been achieved for 20-km low-crosstalk 3-mode transmission in a commercial GPON system carrying live Ethernet traffic. The alternative approach of low modal group delay is also analyzed with simulation results over 10 modes.

Thermocapillary flow in glass tubes coated with photoresponsive layers.

Thermocapillary flow has proven to be a good alternative to induce and control the motion of drops and bubbles in microchannels. Temperature gradients are usually established by implanting metallic heaters adjacent to the channel or by including a layer of photosensitive material capable of absorbing radiative energy. In this work we show that single drops can be pumped through capillaries coated with a photoresponsive composite (PDMS + carbon nanopowder) and irradiated with a light source via an optical fiber. Maximum droplet speeds achieved with this approach were found to be ~300 µm/s, and maximum displacements, around 120% of the droplet length. The heat generation capacity of the coatings was proven having either a complete coating over the capillary surface or a periodic array of pearls of the photoresponsive material along the capillary produced by the so-called Rayleigh-Plateau instability. The effect of the photoresponsive layer thickness and contact angle hysteresis of the solid-liquid interface were found to be important parameters in the photoinduced thermocapillary effect. Furthermore, a linear relationship between the optical intensity I(o) and droplet velocity v was found for a wide range of the former, allowing us to analyze the results and estimate response times for heat transfer using heat conduction theory.