Effect of magnesium stearate solid lipid nanoparticles as a lubricant on the properties of tablets by direct compression.

This study discusses the lubricant properties of magnesium stearate solid lipid nanoparticles (MgSt-SLN) and their effect on the tabletability, mechanical properties, disintegration, and acetaminophen-model dissolution time of microcrystalline cellulose (MCC) tablets prepared by direct compression. The behavior of MgSt-SLN was compared to reference material (RM) to identify advantages and drawbacks. The nanoprecipitation/ion exchange method was employed to prepare the MgSt-SLN. Particle size, zeta potential, specific surface area, morphology, and true density were measured to characterize the nanosystem. The MgSt-SLN particle sizes obtained were 240 ± 5 nm with a specific surface area of 12.2 m2/g. The MCC tablets with MgSt-SLN presented a reduction greater than 20 % in their ejection force, good tabletability, higher tensile strength, lower disintegration delay, and marked differences in acetaminophen dissolution when compared to the RM. The reduced particle size of the magnesium stearate seems to offer a promising technological advantage as an efficient lubricant process that does not affect the properties of tablets.

Preservation of Fresh-Cut 'Maradol' Papaya with Polymeric Nanocapsules of Lemon Essential Oil or Curcumin.

Papaya is one of the most consumed fruits in the world; however, tissue damage caused by cuts quickly leads to its decay. Therefore, this study aimed to prepare and characterize lemon oil and curcumin nanocapsules to evaluate their capacity for preserving fresh-cut papaya. Lemon essential oil and curcumin nanocapsules were prepared using ethyl cellulose (EC) and poly-(ε-caprolactone) (PCL) by the emulsification-diffusion method coupled with ultrasound. The particles had sizes smaller than 120 nm, with polydispersity indices below 0.25 and zeta potentials exceeding -12 mV, as confirmed by scanning electron microscopy. The nanoparticles remained stable for 27 days, with sedimentation being the instability mechanism observed. These nanoparticles were employed to coat fresh-cut papaya, which was stored for 17 days. The results demonstrated their remarkable efficacy in reducing the respiration rate. Furthermore, nanocapsules maintained the pH and acidity levels of the papayas for an extended period. The lemon oil/EC nanocapsule treatment retained the color better. Additionally, all systems exhibited the ability to minimize texture loss associated with reduced pectin methylesterase activity. Finally, the nanocapsules showed a notable reduction in polyphenol oxidase activity correlating with preserving total phenolic compounds in the fruit. Therefore, the lemon oil and curcumin nanoparticles formed using EC and PCL demonstrated their effectiveness in preserving fresh-cut 'Maradol' papaya.

Development and Characterization of pH-Dependent Cellulose Acetate Phthalate Nanofibers by Electrospinning Technique.

The aim of this work was to obtain pH-dependent nanofibers with an electrospinning technique as a novel controlled release system for the treatment of periodontal disease (PD). Cellulose acetate phthalate (CAP) was selected as a pH-sensitive and antimicrobial polymer. The NF was optimized according to polymeric dispersion variables, polymer, and drug concentration, and characterized considering morphology, diameter, entrapment efficiency (EE), process efficiency (PE), thermal properties, and release profiles. Two solvent mixtures were tested, and CHX-CAP-NF prepared with acetone/ethanol at 12% w/v of the polymer showed a diameter size of 934 nm, a uniform morphology with 42% of EE, and 55% of PE. Meanwhile, CHX-CAP-NF prepared with acetone/methanol at 11% w/v of polymer had a diameter of 257 nm, discontinuous nanofiber morphology with 32% of EE, and 40% of PE. EE and PE were dependent on the polymer concentration and the drug used in the formulation. Studies of differential scanning calorimetry (DSC) showed that the drug was dispersed in the NF matrix. The release profiles of CHX from CHX-CAP-NF followed Fickian diffusion dependent on time (t0.43-0.45), suggesting a diffusion-erosion process and a matrix behavior. The NF developed could be employed as a novel drug delivery system in PD.

Design and Evaluation of pH-Dependent Nanosystems Based on Cellulose Acetate Phthalate, Nanoparticles Loaded with Chlorhexidine for Periodontal Treatment.

This work aimed to develop and evaluate pH-dependent systems based on nanospheres (NSphs) and nanocapsules (NCs) loaded with chlorhexidine (CHX) base as a novel formulation for the treatment of periodontal disease. Cellulose acetate phthalate (CAP) was employed as a pH-dependent polymeric material. The NSphs and NCs were prepared using the emulsion-diffusion technique and then characterized according to encapsulation efficiency (EE), size, zeta-potential, morphology, thermal properties, release profiles and a preliminary clinical panel test. The formulations showed 77% and 61% EE and 57% and 84% process efficiency (PE), respectively. Both systems were spherical with an average size of 250-300 nm. Differential scanning calorimetry (DSC) studies showed that the drug has the potential to be dispersed molecularly in the NSph matrix or dissolved in the oily center of the NCs. The CHX release test revealed that the release of NSphs-CHX follows Fickian diffusion involving diffusion-erosion processes. The NCs showed a slower release than the NSphs, following non-Fickian diffusion, which is indicative of anomalous transport. These nanosystems may, therefore, be employed as novel formulations for treating periodontal disease, due to (1) their coverage of a large surface area, (2) the controlled release of active substances at different pH, and (3) potential gingival tissue infiltration.

Evaluation of the lubricating effect of magnesium stearate and glyceryl behenate solid lipid nanoparticles in a direct compression process.

The aim of this study was to develop solid lipid nanoparticles (SLN) and introduce them into a direct compression process to evaluate their lubricant properties. The study consisted of preparing glyceryl behenate SLN (Compritol® 888 ATO) by hot dispersion, and magnesium stearate SLN by a novel nanoprecipitation/ion exchange method. The ejection force was measured for nanosystems and raw materials in a formulation typically used for direct compression. The smallest particle sizes obtained were 456 nm for Compritol® 888 ATO and 330 nm for magnesium stearate. Results show that the NPs used as lubricants in a direct compression model formulation provided efficient lubrication by maintaining the lubricating properties of the system, thereby decreasing the amount of lubricant used compared to the raw material. The lubricating effect showed an increase of 15-30% for magnesium stearate and Compritol® 888 ATO, compared to the raw material at concentrations above 2%.