RESUMO
The influence of two mixing geometries (at the same scale) with different flow energy distributions on the performance of the gibberellic acid fermentation and on the morphology of the producing fungus Fusarium moniliforme was investigated. Fermentations were performed using a turbine mixing system (TMS) and a counterflow mixing system (CMS), which were high and low power number mixing systems, respectively. Different agitator speed rate profiles were maintained to obtain equal specific power inputs to both mixing systems. Substantial differences in morphology and productivity of F. moniliforme were found. To investigate the causes of these differences, local values and spectra of the kinetic energy of flow fluctuations were measured during the fermentations using a stirring intensity measuring device (SIMD) and a frequency spectrum analyzer. Biomass and gibberellic acid concentrations were found to be higher in the TMS, where the energy distribution was less even, and Vi/here the main part of the energy was at small frequencies (large eddies). An automated image analysis method was used for quantitative characterization of F. moniliforme freely dispersed mycelia and clump morphology. A higher proportion of clumped mycelia with clumps of larger area, perimeter, and roughness was observed in the TMS. A correlation between the morphology and productivity was found, and TMS favored the development of more productive mycelia with longer and thinner hyphae. Introduced power was not a good parameter to characterize different impellers, even at a given scale.
RESUMO
Excess turbulence caused by high-intensity stirring inhibited microbial growth and metabolism. In stirred tank bioreactors, the growth rate and lysine biosynthesis decreased in Brevibacterium flavum beyond 900 rpm, the growth rate of Trichoderma reesei on wheat straw beyond 150 rpm, and the growth rate of Saccharomyces cerevisae beyond 800 rpm. The term turbohypobiosis was introduced to describe this inhibition. Turbohypobiosis was characterized by a stress factor F(str) expressing the interaction of medium flow with microbial cells in local turbulent zones, dependent on the energy distribution of the stirring regime. Lysine synthesis was inhibited at significantly lower F(str) values than the growth of B. flavum. The main reason for the inhibition was shear effects causing decreased adenosine triphosphate (ATP) generation, lower O(2) uptake, and lower specific growth rate of bacteria.
RESUMO
A novel two-stage bioreactor has been designed for a combined submerged (SF) and solid substrate fermentation (SSF) of wheat straw. The straw was pretreated with steam, and cellulases from the culture fluid of Trichoderma reesei were adsorbed on it for increased bioconvertibility. SSF was conducted in the top part of the bioreactor by inoculating the straw with a 36-h mycelial culture of T. reesei, or Coriolus versicolor. In the bottom part of the fermenter, Endomycopsis fibuliger was grown in SF. The SF liquor was recirculated through the SSF stage at 24 h intervals to remove glucose and other metabolites that may inhibit growth, and to maintain optimum moisture level and temperature. The removed glucose and other metabolites provided nutrients for the yeast in the SF stage. The combined fermentation resulted in overall higher biomass yield, increased bioconversion, increased cellulase production, and increased digestibility compared with single SSF or SF.
RESUMO
Steam-treated wheat straw at a 70% (w/w) moisture level was subjected to solid substrate fermentation (SSF) with Trichoderma reesei (Riga, USSR) or a mixed culture of T. reesei and Endomycopsis fibuliger (R-574) in fermentation equipment of various design: some with mixing, some with stationary layers, including a mixedlayer 1.5-m(3) pilot plant scale fermenter. The best protein productivity was obtained in stationary layer fermenters with a product containing 13% protein. The main limitations of lignocellulose SSF, such as hindrance of fungal growth, limiting accessibility and availability of substrate, and difficulty in moisture and heat control, were analyzed. The technological parameters of SSF, submerged fermentation, and alternate lignocellulose conversion processes were compared. The SSF had lower overall efficiency but higher product concentration per reaction volume than other conversion schemes.
RESUMO
Growth processes and biosynthesis of the exocellular polyglucan-type polysaccharide, produced by the bacteria Achromobacter delicatulus, were studied in the laboratory fermentation apparatus FU-6 under three completely different aeration systems. The purpose of this study was to find the most economical way of the polysaccharide biosynthesis. The growth rate and the synthesis of the exopolysaccharide were not limited either by the oxygen transfer or glucose content under the conditions examined. The best construction proved to be the fermentation tank with the lowspeed agitation system. In the case of the bacterial strain Achromobacter delicatulus, producing huge amounts of the thick slimy polyglucan exopolysaccharide, the industrial production may develop without any principal technical difficulties.