Direct Probing of Water Adsorption on Liquid-Phase Exfoliated WS2 Films Formed by the Langmuir-Schaefer Technique.

Tungsten disulfide, a transition metal dichalcogenide, has numerous applications as active components in gas- and chemical-sensing devices, photovoltaic sources, photocatalyst substrates, etc. In such devices, the presence of water in the sensing environment is a factor whose role has not been well-understood. To address this problem, the in situ probing of H2O molecule adsorption on WS2 films supported on solid substrates has been performed in a near-ambient pressure X-ray photoelectron spectroscopy (NAP-XPS) setup. Instead, on the individual nanoflakes or spray-coated samples, the measurements were performed on highly transparent, homogeneous, thin films of WS2 nanosheets self-assembled at the interface of two immiscible liquids, water and toluene, transferred onto a solid substrate by the Langmuir-Schaefer technique. This experiment shows that edge defects in nanoflakes, tungsten dangling bond ensuing the exfoliation in the liquid phase, represent active sites for the WO3, WO3-x, and WO3·nH2O formation under ambient conditions. These oxides interact with water molecules when the WS2 films are exposed to water vapor in the NAP-XPS reaction cell. However, water molecules do not influence the W-S chemical bond, thus indicating the physisorption of H2O molecules at the WS2 film surface.

The Effect of Liquid-Phase Exfoliated Graphene Film on Neurodifferentiation of Stem Cells from Apical Papilla.

BACKGROUND: Dental stem cells, which originate from the neural crest, due to their easy accessibility might be good candidates in neuro-regenerative procedures, along with graphene-based nanomaterials shown to promote neurogenesis in vitro. We aimed to explore the potential of liquid-phase exfoliated graphene (LPEG) film to stimulate the neuro-differentiation of stem cells from apical papilla (SCAP). METHODS: The experimental procedure was structured as follows: (1) fabrication of graphene film; (2) isolation, cultivation and SCAP stemness characterization by flowcytometry, multilineage differentiation (osteo, chondro and adipo) and quantitative PCR (qPCR); (3) SCAP neuro-induction by cultivation on polyethylene terephthalate (PET) coated with graphene film; (4) evaluation of neural differentiation by means of several microscopy techniques (light, confocal, atomic force and scanning electron microscopy), followed by neural marker gene expression analysis using qPCR. RESULTS: SCAP demonstrated exceptional stemness, as judged by mesenchymal markers' expression (CD73, CD90 and CD105), and by multilineage differentiation capacity (osteo, chondro and adipo-differentiation). Neuro-induction of SCAP grown on PET coated with graphene film resulted in neuron-like cellular phenotype observed under different microscopes. This was corroborated by the high gene expression of all examined key neuronal markers (Ngn2, NF-M, Nestin, MAP2, MASH1). CONCLUSIONS: The ability of SCAPs to differentiate toward neural lineages was markedly enhanced by graphene film.

Photosynthetic Reaction-Center/Graphene Biohybrid for Optoelectronics.

Photosynthetic reaction center proteins (RC) purified from purple bacterial strains were deposited on graphene layer prepared by liquid phase exfoliation and light-induced resistance change was measured. By measuring the temperature dependence of the resistance change of the bare and RC covered graphene and comparing with the one inactivated by protein unfolding, two effects were possible to separate. One of them is the resistance change due to temperature effect. The other one clearly indicates a possible electric/electronic interaction between the charge flow in the graphene and the light-induced charge pair within the protein, which is, essentially, different in the open (dark, PBPheo) and closed (light, P+BPheo-) states. These results provide useful information for designing hybrid bio-photonic devices which are able to absorb and convert light energy.

Single-step fabrication and work function engineering of Langmuir-Blodgett assembled few-layer graphene films with Li and Au salts.

To implement large-area solution-processed graphene films in low-cost transparent conductor applications, it is necessary to have the control over the work function (WF) of the film. In this study we demonstrate a straightforward single-step chemical approach for modulating the work function of graphene films. In our approach, chemical doping of the film is introduced at the moment of its formation. The films are self-assembled from liquid-phase exfoliated few-layer graphene sheet dispersions by Langmuir-Blodgett technique at the water-air interfaces. To achieve a single-step chemical doping, metal standard solutions are introduced instead of water. Li standard solutions (LiCl, LiNO3, Li2CO3) were used as n-dopant, and gold standard solution, H(AuCl4), as p-dopant. Li based salts decrease the work function, while Au based salts increase the work function of the entire film. The maximal doping in both directions yields a significant range of around 0.7 eV for the work function modulation. In all cases when Li-based salts are introduced, electrical properties of the film deteriorate. Further, lithium nitrate (LiNO3) was selected as the best choice for n-type doping since it provides the largest work function modulation (by 400 meV), and the least influence on the electrical properties of the film.

Differentiation of stem cells from apical papilla into neural lineage using graphene dispersion and single walled carbon nanotubes.

Stem cell-based therapies are considered a promising treatment modality for many medical conditions. Several types of stem cells with variable differentiation potentials have been isolated from dental tissues, among them stem cells from apical papilla (SCAP). In parallel, new classes of biocompatible nanomaterials have also been developed, including graphene and carbon nanotube-based materials. The aim of the study was to assess whether graphene dispersion (GD) and water-soluble single walled carbon nanotubes (ws-SWCNT), may enhance SCAPs capacity to undergo neural differentiation. SCAPs cultivated in neuroinductive medium supplemented with GD and ws-SWCNT, separately and in combination, were subjected to neural marker analysis by real-time polymerase chain reaction (neurofilament medium [NF-M], neurogenin-2 [ngn-2], ß III-tubulin, microtubule-associated protein 2) and immunocytochemistry (NeuN and ß III-tubulin). GD, ws-SWCNT, and their combination, had neuro-stimulatory effects on SCAPs, as judged by the production of neural markers. Compared to cells grown in nanomaterial free medium, cells with GD showed higher production of B3T, cells with ws-SWCNT had higher production of ngn-2 and NF-M, while the combination of nanomaterials gave similar levels of both B3T and NF-M as the neuroinductive medium alone, but with the finest neuron-like morphology. In conclusion, GD and ws-SWCNT seem to enhance neural differentiation of SCAP. © 2018 Wiley Periodicals, Inc. J Biomed Mater Res Part A: 106A: 2653-2661, 2018.

Probing charge transfer between molecular semiconductors and graphene.

The unique density of states and exceptionally low electrical noise allow graphene-based field effect devices to be utilized as extremely sensitive potentiometers for probing charge transfer with adsorbed species. On the other hand, molecular level alignment at the interface with electrodes can strongly influence the performance of organic-based devices. For this reason, interfacial band engineering is crucial for potential applications of graphene/organic semiconductor heterostructures. Here, we demonstrate charge transfer between graphene and two molecular semiconductors, parahexaphenyl and buckminsterfullerene C60. Through in-situ measurements, we directly probe the charge transfer as the interfacial dipoles are formed. It is found that the adsorbed molecules do not affect electron scattering rates in graphene, indicating that charge transfer is the main mechanism governing the level alignment. From the amount of transferred charge and the molecular coverage of the grown films, the amount of charge transferred per adsorbed molecule is estimated, indicating very weak interaction.