Sequential biodegradation of 1,2,4-trichlorobenzene at oxic-anoxic groundwater interfaces in model laboratory columns.

Halogenated organic solvents such as chlorobenzenes (CBs) are frequent groundwater contaminants due to legacy spills. When contaminated anaerobic groundwater discharges into surface water through wetlands and other transition zones, aeration can occur from various physical and biological processes at shallow depths, resulting in oxic-anoxic interfaces (OAIs). This study investigated the potential for 1,2,4-trichlorobenzene (1,2,4-TCB) biodegradation at OAIs. A novel upflow column system was developed to create stable anaerobic and aerobic zones, simulating a natural groundwater OAI. Two columns containing (1) sand and (2) a mixture of wetland sediment and sand were operated continuously for 295 days with varied doses of 0.14-1.4 mM sodium lactate (NaLac) as a model electron donor. Both column matrices supported anaerobic reductive dechlorination and aerobic degradation of 1,2,4-TCB spatially separated between anaerobic and aerobic zones. Reductive dechlorination produced a mixture of di- and monochlorobenzene daughter products, with estimated zero-order dechlorination rates up to 31.3 µM/h. Aerobic CB degradation, limited by available dissolved oxygen, occurred for 1,2,4-TCB and all dechlorinated daughter products. Initial reductive dechlorination did not enhance the overall observed extent or rate of subsequent aerobic CB degradation. Increasing NaLac dose increased the extent of reductive dechlorination, but suppressed aerobic CB degradation at 1.4 mM NaLac due to increased oxygen demand. 16S-rRNA sequencing of biofilm microbial communities revealed strong stratification of functional anaerobic and aerobic organisms between redox zones including the sole putative reductive dechlorinator detected in the columns, Dehalobacter. The sediment mixture column supported enhanced reductive dechlorination compared to the sand column at all tested NaLac doses and growth of Dehalobacter populations up to 4.1 × 108 copies/g (51% relative abundance), highlighting the potential benefit of sediments in reductive dechlorination processes. Results from these model systems suggest both substantial anaerobic and aerobic CB degradation can co-occur along the OAI at contaminated sites where bioavailable electron donors and oxygen are both present.

Influence of oxygenation on chromium redox reactions with manganese sulfide (MnS(s)).

Manganese sulfide (MnS(s)) minerals exist in sulfidic environments and can have unique reactive abilities because of sulfide, which is a known reductant, and Mn, the oxyhydroxides of which are known oxidants. This study elucidated the role of MnS(s) in controlling Cr speciation with implications on its fate and toxicity in the natural environment, specifically sulfidic sediments that undergo biogeochemical changes due to sediment resuspension during dredging, bioturbation, and flood events. In continuously mixed batch reaction experiments, aqueous CrVI reduction under anaerobic conditions occurred primarily on the surface of MnS(s) displaying a biphasic behavior- the initial rapid removal of CrVI from solution was followed by a slow decline due to surface passivation by reaction products, mainly sorbed or precipitated CrIII. The reaction progress increased with MnS(s) surface area loading but decreased on increasing CrVI concentration and pH, suggesting that surface site regeneration through product desorption was the rate-controlling mechanism. Below circum-neutral pH, higher solubility of MnS(s) resulted in additional CrVI reduction by reduced sulfur species in solution, whereas increased CrIII solubility lowered surface passivation allowing for more reactive sites to participate in the reaction. Aeration of MnS(s) at pH≥7 caused the formation of a heterogeneous MnIII(hydr)oxide that was composed of hausmanite and manganite. CrVI reoccurrence was observed on aeration of CrVI-spiked MnS(s) from the oxidation of product CrIII. The reoccurrence at pH≥7 was attributed to the oxidation of product CrIII by MnIII(hydr)oxide, whereas the reoccurrence at pH<7 was hypothesized from the oxidation of product CrIII by intermediate aqueous MnIII and/or sulfur species. Just as with Cr, MnS(s) may play an important role in speciation, fate, and transport of other environmental contaminants.

Biogeochemical controls on hexavalent chromium formation in estuarine sediments.

Predicting the aquatic and human health impacts of chromium (Cr) necessitates one to determine its speciation as either relatively nontoxic Cr(III) or toxic Cr(VI) and elucidate the influence of biogeochemical changes on its behavior and fate. In the Baltimore Harbor, Cr predominantly exists as Cr(III) associated with sediments. While reduction of Cr(VI) to Cr(III) is dominant in these anoxic sediments, the potential of Cr(III) oxidation and Cr(VI) reoccurrence during sediment resuspension and oxygenation resulting from dredging, bioturbation, and flood events poses a serious concern. In batch experiments, aqueous Cr(VI) spiked into continuously mixed anoxic suspensions was reduced to product Cr(III) under anaerobic conditions. No Cr(VI) reoccurrence was observed when conditions remained anaerobic. Aeration caused Cr(VI) reoccurrence from the abiotic oxidation of product Cr(III). Rates of aeration-driven Cr(VI) reoccurrence increased with pH, and Cr(VI) reoccurrence positively correlated with dissolved manganese (Mn) decline at pH ≥ 7. Aeration-driven oxidation of Mn(II) to Mn(III,IV)(hydr)oxides was the underlying mechanism causing product Cr(III) oxidation. Cr(VI) reoccurrence decreased with sediment loading and negatively correlated with the acid volatile sulfide (AVS) concentration. Although sediment resuspension and oxygenation may create temporary conditions conducive to Cr(VI) formation, long-term Cr(VI) persistence is unlikely in the presence of sediment reductants. While such natural attenuation in reducing environments mitigates the risk associated with Cr toxicity, this risk may still persist in Mn-rich and reductant-deficient environments.

Chromium occurrence and speciation in Baltimore harbor sediments and porewater, Baltimore, Maryland, USA.

Industrial activities in the Baltimore Harbor, Baltimore, Maryland, USA, have resulted in widespread chromium contamination of sediments. A comprehensive analysis of Cr speciation in sediment and porewater collected from 22 locations in the Baltimore Harbor was completed to understand Cr bioavailability and probability of toxicity due to Cr in sediments. The analysis employed a reverse-phase ion-pair high-performance liquid chromatography-inductively coupled plasma-mass spectrometry (HPLC-ICP-MS) method. Sub-microgram-per-liter determination of Cr(III) and Cr(VI) in environmental samples was found, with method validation revealing broad method applicability of HPLC-ICP-MS to a wide range of sample types. The major limitation of the method was poor Cr species separation in high ionic strength solutions (greater than 0.1 M NaCl). Total Cr concentrations in Baltimore Harbor sediments ranged from 2.5 to 1,050 mg/kg with 11 of the 22 sites containing total Cr in excess of the 370 mg/ kg effects range-median (ER-M) sediment quality guideline. The Cr(VI) concentrations in sediments, however, were markedly lower, ranging from 0.10 to 0.38 mg/kg with Cr(VI) not detected in 14 of the 22 stations. Porewater concentrations, both for total Cr and Cr(VI), were quite low, with total Cr ranging from 0.20 to 2.16 microg/L and Cr(VI) ranging from 0.73 to 1.17 microg/L. The Cr(VI)-reducing capacity of the sediments, based on a sediment-spiking experiment, was found to be strongly correlated with the acid volatile sulfides content of the sediment. Overall, our results provide field validation of the hypothesis that Cr(VI) will not persist in sediments with excess acid volatile sulfides. Given the low concentrations of Cr(VI) in sediment and porewater, it appears unlikely that Cr in Baltimore Harbor sediments contributes appreciably to previously observed sediment toxicity.