Separation of Lithium from Aluminum-Containing Clay Mineral Leachate Solution Using Energy-Efficient Membrane Solvent Extraction.

This study investigated a novel membrane solvent extraction (MSX) process for the recovery and separation of lithium (Li) from clay minerals using a cation exchange organic extractant [di-(2-ethylhexyl)phosphoric acid] (DEHPA). The Li is selectively extracted from clay mineral leachate solution using highly efficient aluminum hydroxide sorbents to form lithium aluminum double hydroxide sulfate (LDH sulfate) as the precipitate. Several delithiation methods have been explored to separate Li from aluminum (Al). LDH sulfate is dissolved in dilute H2SO4 and used as the feed solution, and DEHPA is used to selectively separate Li and Al from the feed solution. The MSX process immobilizes DEHPA in the microporous membrane pores and continuously removes Al from the feed solution to obtain pure Li. The efficiency of DEHPA for the selective separation of Li from Al is determined by measuring its distribution coefficient. This study used the optimum feed solution pH of 3, strip solution concentration of 2 mol/L H2SO4, and an organic phase composition of 30% v/v DEHPA in Isopar-L. The MSX process achieved a Li yield of about 92% and a purity of ⩾ 94%. The results suggest that the innovative MSX technology is a time- and energy-efficient approach for the recovery and separation of high-purity Li for application in Li-ion batteries and other clean energy technologies.

Increasing Salt Rejection of Polybenzimidazole Nanofiltration Membranes via the Addition of Immobilized and Aligned Aquaporins.

Aquaporins are water channel proteins in cell membrane, highly specific for water molecules while restricting the passage of contaminants and small molecules, such as urea and boric acid. Cysteine functional groups were installed on aquaporin Z for covalent attachment to the polymer membrane matrix so that the proteins could be immobilized to the membranes and aligned in the direction of the flow. Depth profiling using x-ray photoelectron spectrometer (XPS) analysis showed the presence of functional groups corresponding to aquaporin Z modified with cysteine (Aqp-SH). Aqp-SH modified membranes showed a higher salt rejection as compared to unmodified membranes. For 2 M NaCl and CaCl2 solutions, the rejection obtained from Aqp-SH membranes was 49.3 ± 7.5% and 59.1 ± 5.1%. On the other hand, the rejections obtained for 2 M NaCl and CaCl2 solutions from unmodified membranes were 0.8 ± 0.4% and 1.3 ± 0.2% respectively. Furthermore, Aqp-SH membranes did not show a significant decrease in salt rejection with increasing feed concentrations, as was observed with other membranes. Through simulation studies, it was determined that there was approximately 24% capping of membrane pores by dispersed aquaporins.