Out-of-Band Fiber-Optic Time and Frequency Transfer Using Asymmetric and Symmetric Opto-Electronic Repeaters.

Signal repeaters for fiber-optic communication can be realized with back-to-back connected transceivers. This configuration can provide high gain ( ≈ 30 dB) at low cost, and the needed semiconductor lasers and modulators can be realized for practically any relevant wavelength. Unfortunately, for time and frequency (TF) transfer the uncorrelated wavelength drifts in the transceiver lasers can compromise transfer stability, and device replacement due to failure may result in large time offsets that have to be measured via global navigation satellite services (GNSS). This work demonstrates that good results can nevertheless be obtained with standard telecom dense wavelength-division multiplexing (DWDM) transceivers over long time periods (years). More importantly, a simple wavelength-symmetric repeater is proposed that can be used to cancel the detrimental effects of wavelength drifts and which lessens the need for link recalibrations after transceiver replacements. In a proof-of-concept test setup, timing drift due to wavelength drift of a repeater laser is reduced by approximately two orders of magnitude.

Broadband, unpolarized repumping and clearout light sources for Sr(+) single-ion clocks.

Future transportable optical clocks require compact and reliable light sources. Here, broadband, unpolarized repumper and state clearout sources for Sr+ single-ion optical clocks are reported. These turn-key devices require no frequency stabilization or external modulators. They are fiber based, inexpensive, and compact. Key characteristics for clock operation are presented, including optical spectra, induced light shifts, and required extinction ratios. Tests with an operating single-ion standard show a clearout efficiency of 100%. Compared to a laser-based repumper, the achievable fluorescence rates for ion detection are a few tens of percent lower. The resulting ion kinetic temperature is 1-1.5 mK, near the Doppler limit of the ion system. Similar repumper light sources could be made for Ca+ (866 nm) and Ba+ (650 nm) using semiconductor gain media.