Pan trapping is an effective method to trap adults of the jujube gall midge, Dasineura jujubifolia (Diptera: Cecidomyiidae).

Jujube gall midge (Dasineura jujubifolia Jiao & Bu) (Diptera: Cecidomyiidae) is an important pest in jujube (Ziziphus jujuba Mill.) orchards in Aksu, Xinjiang, China. Yellow sticky traps are the main device used for monitoring jujube gall midge adults, but their efficacy is low. Here, we compared the effectiveness of yellow sticky traps with water pan traps (are commonly used for trapping Diptera insects) to monitor jujube gall midge adults. Yellow sticky traps and pan traps were deployed for 2 consecutive years in jujube orchards in Aksu, Xinjiang, China. The midge's population dynamics as revealed by these 2 trap types were consistent, but the effectiveness of pan traps was about 5 times greater than that of the yellow sticky traps. In addition, pan traps captured fewer non-target species (e.g., parasitic wasps, lacewings, and lady beetles) than yellow sticky traps. Our study suggests that pan trap is an effective device to monitor jujube gall midge adults with minimal harm to natural enemies.

Improved Stretchable and Sensitive Fe Nanowire-Based Strain Sensor by Optimizing Areal Density of Nanowire Network.

Flexible strain sensors, when considering high sensitivity and a large strain range, have become a key requirement for current robotic applications. However, it is still a thorny issue to take both factors into consideration at the same time. Here, we report a sandwich-structured strain sensor based on Fe nanowires (Fe NWs) that has a high GF (37-53) while taking into account a large strain range (15-57.5%), low hysteresis (2.45%), stability, and low cost with an areal density of Fe NWs of 4.4 mg/cm2. Additionally, the relationship between the contact point of the conductive network, the output resistance, and the areal density of the sensing unit is analyzed. Microscopically, the contact points of the conductive network directly affect the sensor output resistance distribution, thereby affecting the gauge factor (GF) of the sensor. Macroscopically, the areal density and the output resistivity of the strain sensor have the opposite percolation theory, which affects its linearity performance. At the same time, there is a positive correlation between the areal density and the contact point: when the stretching amount is constant, it theoretically shows that the areal density affects the GF. When the areal density reaches this percolation threshold range, the sensing performance is the best. This will lay the foundation for rapid applications in wearable robots.