CO direct esterification to dimethyl oxalate and dimethyl carbonate: the key functional motifs for catalytic selectivity.

The direct esterification of CO involves processes using CO as the starting material and ester chemicals as products. Dimethyl oxalate (DMO) and dimethyl carbonate (DMC) are two different products of the direct CO esterification reaction. However, the effective control of the reaction pathway and direct synthesis of DMO and DMC are challenging. In this review, we summarize the recent research progress on the direct esterification of CO to DMO/DMC and reveal the functional motifs responsible for the catalytic selectivity. Firstly, we discuss the microstructure of catalysts for the direct esterification of CO to DMO and DMC, including the valence state and the aggregate state of Pd. Then, the influence of characteristics of the support on the selectivity is analyzed. Importantly, the aggregate state of the active component, Pd is deemed as a vital functional motif for catalytic selectivity. The isolated Pd is conducive for the formation of DMC, while the aggregated Pd is beneficial for the formation of DMO. This review will provide rational guidance for the direct esterification of CO to DMO and DMC.

[Stability of Ferrihydrite and Goethite Nanoparticles Under Different Environmental Conditions].

Agglomeration and dispersion of nanoparticles control many important environmental processes. In this study, the particle size and zeta potential of ferrihydrite nanoparticles (FHNPs) and goethite nanoparticles (GTNPs) under different pH, ion, and organic matter conditions were measured. These data were used to calculate the Derjaguin-Landau-Verwey-Overbeek (DLVO) interaction energy between nanoparticles to further investigate the stability of two nanoparticles. The results showed that Na+ and Ca2+ promoted FHNPs and GTNPs agglomeration due to their ionic strength. The PO43- with low-concentration (2 mmol·L-1), humic acid and fulvic acid (2 mg·L-1 and 10 mg·L-1) loaded on iron mineral nanoparticles changed their surface charge and further improved the stability of FHNPs and GTNPs at medium and high pH. Although the PO43- with high concentration (10 mmol·L-1) also changed the electrical properties of iron mineral nanoparticles, it had little contribution to the GTNP stability due to its ionic strength. When the zeta potentials of FHNPs or GTNPs were close to 0, the primary barrier and secondary minima were nonexistent simultaneously. The two kinds of nanoparticles irreversibly agglomerated in primary minima. When the primary barrier and secondary minima coexisted, the proportion of reversible aggregation of FHNPs and GTNPs in secondary minima increased. The results provided support for further investigation of the environmental behavior of FHNPs and GTNPs, and iron mineral nanoparticle-facilitated transport of pollutants.

Zn2+ stabilized Pd clusters with enhanced covalent metal-support interaction via the formation of Pd-Zn bonds to promote catalytic thermal stability.

Pd-Based heterogeneous catalysts have been demonstrated to be efficient in numerous heterogeneous reactions. However, the effect of the support resulting in covalent metal-support interaction (CMSI) has not been researched sufficiently. In this work, a Lewis base is modulated over MgAl-LDH to investigate the support effects and it is further loaded with Pd clusters to research the metal-support interactions. MgAl-LDH with ultra-low Pd loading (0.0779%) shows CO conversion (55.0%) and dimethyl oxalate (DMO) selectivity (93.7%) for CO oxidative coupling to DMO, which was gradually deactivated after evaluation for 20 h. To promote the stability of Pd/MgAl-LDH, Zn2+ ions were introduced into the MgAl-LDH support to strengthen the CMSI by forming Pd-Zn bonds, which further increased the adsorption energy of the Pd clusters on ZnMgAl-LDH, and this was verified by X-ray absorption fine structure (XAFS) measurements and density functional theory (DFT) calculations. The stability of the Pd/ZnMgAl-LDH catalyst could be maintained for at least 100 h. This work highlights that covalent metal-support interactions can be strengthened by forming new metal-metal bonds, which could be extended to other systems for the stabilization of noble metals over supports.

CeO2-x quantum dots with massive oxygen vacancies as efficient catalysts for the synthesis of dimethyl carbonate.

CeO2-x quantum dots with massive oxygen vacancies are obtained by a one-step single molecular synthesis strategy. The yield of dimethyl carbonate from CO2 and methanol is more than 5 times that for commercial CeO2 nanoparticles.

Fluorometric determination of the activity of the biomarker terminal deoxynucleotidyl transferase via the enhancement of the fluorescence of silver nanoclusters by in-situ grown DNA tails.

The activity of terminal deoxynucleotidyl transferase (TdTase) is a biomarker for routine diagnosis of acute leukemia. A method has been developed for the determination of TdTase activity. It is based on the use of silver nanoclusters (AgNCs) whose yellow fluorescence is enhanced by an in-situ grown DNA tail of TdTase-polymerized and guanine-rich DNA at the 3' end of a hairpin DNA. The fluorescence, best measured at excitation/emission peaks of 530/585 nm, increases linearly in the 1 to 35 mU mL-1 TdTase activity range. The detection limit is 0.8 mU mL-1. The method is cost-efficient, selective and convenient. It integrates enhancement of the fluorescence of AgNCs and target recognition into a single process. Graphical abstract Schematic presentation of a method for determination of TdTase activity. It is based on AgNCs fluorescence enhanced by in-situ grown TdTase-polymerized G-rich DNA tail. The method integrates AgNCs fluorescence enhancement and the target recognition into a single process.

Thermophysical and mechanical properties of granite and its effects on borehole stability in high temperature and three-dimensional stress.

When exploiting the deep resources, the surrounding rock readily undergoes the hole shrinkage, borehole collapse, and loss of circulation under high temperature and high pressure. A series of experiments were conducted to discuss the compressional wave velocity, triaxial strength, and permeability of granite cored from 3500 meters borehole under high temperature and three-dimensional stress. In light of the coupling of temperature, fluid, and stress, we get the thermo-fluid-solid model and governing equation. ANSYS-APDL was also used to stimulate the temperature influence on elastic modulus, Poisson ratio, uniaxial compressive strength, and permeability. In light of the results, we establish a temperature-fluid-stress model to illustrate the granite's stability. The compressional wave velocity and elastic modulus, decrease as the temperature rises, while poisson ratio and permeability of granite increase. The threshold pressure and temperature are 15 MPa and 200 °C, respectively. The temperature affects the fracture pressure more than the collapse pressure, but both parameters rise with the increase of temperature. The coupling of thermo-fluid-solid, greatly impacting the borehole stability, proves to be a good method to analyze similar problems of other formations.

Manipulating the concavity of rhodium nanocubes enclosed by high-index facets via site-selective etching.

Manipulating the degrees of concavity or Miller indices of high-index facets is significant for metal nanocrystals to further tailor their properties; however, generating a concave surface with negative curvature is still in the early development stage and tuning the degree of concavity remains a challenge. Herein, we have developed a simple and effective site-selective etching strategy to manipulate the concavity of rhodium (Rh) nanocrystals with high-index facets.

An ultra-low Pd loading nanocatalyst with high activity and stability for CO oxidative coupling to dimethyl oxalate.

A Pd/α-Al2O3 nanocatalyst with ultra-low Pd loading exhibits high activity and stability for CO oxidative coupling to dimethyl oxalate, which was prepared by a Cu(2+)-assisted in situ reduction method at room temperature. The small size and high dispersion of Pd nanoparticles facilitated by Cu(2+) ions are responsible for the excellent catalytic activity.