The loading of Fe ions on N-doped carbon nanosheets to boost photocatalytic cascade for water disinfection.

The pervasive presence of pathogenic bacteria in water environment poses a serious threat to public health. Here, a photocatalytic cascade was developed to reveal great water disinfection. Firstly, N-doped carbon nanosheets (N-CNSs) about 30-50 nm in size were synthesized by a hydrothermal strategy. It revealed wide-spectrum photocatalysis for H2O2 generation via a typical two-step single-electron process. A Fenton agent (Fe ion) was loaded, N-CNSs-Fe can in-situ convert photocatalytic H2O2 into ·OH with high oxidation potential. Moreover, its Fenton active is three times greater than pure Fe2+ owing to electron enrichment from N-CNSs to Fe for Fe3+/Fe2+ cycle. Further investigation displayed that Fe loading also could decrease bad gap and promote charge separation to boost photocatalysis. In addition, N-CNSs-Fe possesses positive surface potential to exhibit strong interaction with negative bacteria, facilitating the capture. Therefore, the nanocomposite can effectively inactivate E. coli with a lethality rate of 99.7 % under stimulated sunlight irradiation. In addition, it also was employed to treat a complex lake water sample, revealing great antibacterial (95.1 %) and dye-decolored (92.3 %) efficiency at the same time. With novel biocompatibility and antibacterial ability, N-CNSs-Fe possessed great potential for water disinfection.

Identification of a New Pathogenic fungi Causing Sorghum Leaf Spot Disease and Its Management Using Natural Product and Microorganisms.

Sorghum bicolor is cultivated worldwide. Leaf spot of sorghum, which leads to leaf lesions and yield reduction, is a prevalent and serious disease in Guizhou Province, southwest China. In August 2021, new leaf spot symptoms were observed on sorghum leaves. In this study, traditional methods and modern molecular biology techniques were used to isolate and identify the pathogen. Sorghum inoculated with the isolate GY1021 resulted in reddish brown lesion that similar to symptoms observed in the field: the original isolate inoculated was reisolated and Koch's postulates were fulfilled. Based on morphological features and phylogenetic analysis of the internal transcribed spacer (ITS) combined sequence with ß-tubulin (TUB2) and translation elongation factor 1-α (TEF-1α) genes, the isolate was identified as Fusarium thapsinum (Strain accession: GY 1021; GenBank Accession: ITS (ON882046), TEF-1α (OP096445), and ß-TUB (OP096446)). Then, we studied the bioactivity of various natural products and microorganisms against F. thapsinum using the dual culture experiment. Carvacrol, 2-allylphenol, honokiol, and cinnamaldehyde showed excellent antifungal activity, with EC50 values of 24.19, 7.18, 46.18, and 52.81 µg/mL, respectively. The bioactivity of six antagonistic bacteria was measured using a dual culture experiment and the mycelial growth rate method. Paenibacillus polymyxa, Bacillus amyloliquefaciens and Bacillus velezensis displayed significant antifungal effects against F. thapsinum. This study provides a theoretical basis for the green control of leaf spot of sorghum.

First Report on Colletotrichum fructicola Causing Anthracnose in Chinese Sorghum and Its Management Using Phytochemicals.

Sorghum bicolor is cultivated worldwide. Leaf spots on sorghum, which lead to leaf lesions and impaired growth, are prevalent and severe in Guizhou Province, Southwest China. In August 2021, new leaf spot symptoms were observed on sorghum plants growing in agricultural fields. We used conventional tissue isolation methods and pathogenicity determination tests. Inoculations of sorghum with isolate 022ZW resulted in brown lesions similar to those observed under field conditions. The original inoculated isolates were reisolated and fulfilled Koch's postulates. Based on the morphological character and phylogenetic analyses of the combined sequences of the internal transcribed spacer (ITS) region and the ß-tubulin (TUB2) and glyceraldehyde-3-phosphate dehydrogenase (GAPDH) genes, we identified the isolated fungus as C. fructicola. This paper is the first to report this fungus-causing disease in sorghum leaves. We studied the sensitivity of the pathogen to various phytochemicals. The sensitivity of C. fructicola to seven phytochemicals was measured using the mycelial growth rate method. Honokiol, magnolol, thymol, and carvacrol displayed good antifungal effects, with EC50 (concentration for 50% of the maximal effect) values of 21.70 ± 0.81, 24.19 ± 0.49, 31.97 ± 0.51, and 31.04 ± 0.891 µg/mL, respectively. We tested the control effect of the seven phytochemicals on the anthracnose caused by C. fructicola: honokiol and magnolol displayed good field efficacy. In this study, we expand the host range of C. fructicola, providing a basis for controlling sorghum leaf diseases caused by C. fructicola.

Uptake and transport of antibiotic kasugamycin in castor bean (Ricinus communis L.) seedlings.

Kasugamycin (KSM), an aminoglycoside antibiotic, has been widely used for the management of plant diseases, especially for the control of rice blast in Asia. However, its uptake mechanism and transport in plants are still obscure. The castor bean (Ricinus communis L.) seeding, a model plant for phloem transport, was used to study the mechanism of uptake and transport of KSM. Results showed that cotyledon-applied KSM could transport into the phloem and distributed in root and shoot of plant. The temperature, concentration, and pH had significant effects on the uptake of KSM, indicating that the uptake of KSM was mediated by an active carrier system. Compared with the control, competitive inhibitors of sugar transporters D-glucose, D-chiro-inositol, and phloridzin inhibited 71.03%, 67.95%, and 61.73% uptake of KSM, respectively. Energy inhibitor dinitrophenol (DNP) and carbonyl cyanide chlorophenylhydrazone (CCCP) also affected the uptake of KSM, and the inhibition rates were 34.23% and 48.06%. All the results showed that the uptake of KSM was mediated by a sugar transporter, and it could transport from shoot to root in plants via the phloem. The study preliminary elucidated the plant-microbe interactions in the context of the transport of microbial secondary metabolites in plants. It has certain significance for scientific application of antibiotics and biological control of plant diseases and provides theoretical basis for the development of bidirectional transport pesticides.

Genome Sequence and Comparative Analysis of Colletotrichum gloeosporioides Isolated from Liriodendron Leaves.

Colletotrichum gloeosporioides is a hemibiotrophic pathogen causing significant losses to economically important crops and forest trees, including Liriodendron. To explore the interaction between C. gloeosporioides and Liriodendron and to identify the candidate genes determining the pathogenesis, we sequenced and assembled the whole genome of C. gloeosporioides Lc1 (CgLc1) using PacBio and Illumina next generation sequencing and performed a comparative genomic analysis between CgLc1 and Cg01, the latter being a described endophytic species of the C. gloeosporioides complex. Gene structure prediction identified 15,744 protein-coding genes and 837 noncoding RNAs. Species-specific genes were characterized using an ortholog analysis followed by a pathway enrichment analysis, which showed that genes specific to CgLc1 were enriched for the arginine biosynthetic process. Furthermore, genome synteny analysis revealed that most of the protein-coding genes fell into collinear blocks. However, two clusters of polyketide synthase genes were identified to be specific for CgLc1, suggesting that they might have an important role in virulence control. Transcriptional regulators coexpressed with polyketide synthase genes were detected through a Weighted Correlation Network Analysis. Taken together, this work provides new insight into the virulence- and pathogenesis-associated genes present in C. gloeosporioides and its possible lifestyle.

Preparation of Nitrogen-Doped Mesoporous Carbon for the Efficient Removal of Bilirubin in Hemoperfusion.

The development of bilirubin adsorbent with high selectivity, brilliant adsorption ability, and biocompatibility is still a considerable challenge. In this study, a copolymer-templated nitrogen-doped mesoporous carbon (CTNC) has been prepared via a simple carbonization procedure of well-defined polyacrylonitrile-block-poly(n-butyl acrylate) (PAN-b-PBA) block copolymer precursors. The structure and morphology were characterized by transmission electron microsphere (TEM), adsorption-desorption isotherms, and X-ray photoelectron spectroscopy (XPS). Owing to its high specific area, hierarchical open-porous structure, and the introduction of nitrogen atoms in graphitic sp2 network, the adsorbent CTNC exhibited high removal efficiency toward bilirubin and bile acid from human plasma. The removal rate of bilirubin was more than 50.7% with a minimal loss of albumin. Meanwhile, exceeding 95% of bile acid was eliminated. The effect of albumin on the adsorption kinetic of bilirubin was identified. The result indicated that the adsorption rate of BSA-bonded bilirubin experienced a decline than that of free bilirubin, but the adsorption capacity was still up to 39.8 mg/g within 2 h. Moreover, the effect of porosity and nitrogen contents on bilirubin adsorption ability and blood compatibility were systematically investigated. The material with lower nitrogen content showed only a negligible hemolysis activity. Therefore, the nitrogen-doped mesoporous carbon developed in this work has potential application in blood purification for the efficient removal of bilirubin.

Quantitative Analysis of Surface Sites on Carbon Dots and Their Interaction with Metal Ions by a Potentiometric Titration Method.

Carbon dots (CDs) possess abundant functional groups on their surface which are related to their application in various fields such as sensing, imaging, and catalysis. Understanding the amount and properties of these functional groups and their interaction with metal ions is essential but has posed longstanding challenges because of the diverse and complex structures of CDs. In this work, potentiometric titration is demonstrated as an effective method to figure out the categories and amounts of functional groups. Surface complexation modeling with the FITEQL program was applied to the quantification of the surface sites on CDs with the titration data. Then with the obtained molar concentrations of the surface sites, the pKas of these surface sites were calculated with the Hyperquad program. Finally, titration experiments of CDs with and without Fe(III) were carried out and the stability constants of Fe(III) and ArgCDs were simulated on the Hyperquad program. By utilizing the stability constants, the distribution of Fe(III) species at different pHs and the concentrations of Fe(III) and CDs were also investigated. This potential method might be used for characterizing the surface sites on other CDs or even other soluble nanoparticles as well as for investigating the interactions of the surface sites with different metal ions.

Microplasma Anode Meeting Molten Salt Electrochemistry: Charge Transfer and Atomic Emission Spectral Analysis.

Molten salt electrolysis is normally conducted with solid anode, such as noble metal or graphite, which has defects such as high cost or emission of carbon oxide. Herein, we report that a microplasma based on atmospheric-pressure glow discharge could act as a kind of gaseous anode for electrolysis in molten salt. When the Ag/Ag+ redox couple was chosen as the research object, the microplasma anode could initiate charge-transfer reactions in the molten salt and Ag could be electrodeposited with current efficiency of above 90%. The microplasma anode has also shown excellent anticorrosive performance in both chloride and carbonate molten salt. Furthermore, the microplasma anode could potentially serve as an excitation source of atomic emission spectrometry (AES), making it possible to determine the concentration of Ag ions in the molten salt in situ and in real-time. With properties such as being carbon-free and having corrosion resistance and extensive utilization for analysis, the microplasma anode has opened a new direction for molten salt electrochemistry.

Nano Endoscopy with Plasmon-Enhanced Fluorescence for Sensitive Sensing Inside Ultrasmall Volume Samples.

Plasmon-enhanced fluorescence (PEF) generally requires the samples settled on a metal substrate and the effective enhancement distance is less than 100 nm, which limit its application in intracellular sensing. Herein, we report a nano endoscopy with PEF effect for sensing analytes inside the extremely small volume samples. The nano endoscopy was fabricated by assembling single nanoporous gold nanowire (PGNW) on the tip of a tungsten needle. It was accurately manipulated to insert into a micro droplet, and an effective sensing was realized at micrometre scale with submicrometer resolution. By taking lysozyme as a model sensing target, a 23-fold improvement of sensitivity was obtained, comparing with that of smooth gold nanowire (SGNW). These results indicated that the nano endoscopy can realize a high spatial resolution sensing, showing its potential application in intracellular sensing.

Visualization of Adsorption: Luminescent Mesoporous Silica-Carbon Dots Composite for Rapid and Selective Removal of U(VI) and in Situ Monitoring the Adsorption Behavior.

The removal and separation of uranium from aqueous solutions are quite important for resource reclamation and environmental protection. Being one of the most effective techniques for metal separation, adsorption of uranium by a variety of adsorbent materials has been a subject of study with high interest in recent years. However, current methods for monitoring the adsorption process require complicated procedures and tedious measurements, which hinders the development of processes for efficient separation of uranium. In this work, we prepared a type of luminescent mesoporous silica-carbon dots composite material that has high efficiency for the adsorption of uranium and allows simultaneous in situ monitoring of the adsorption process. Carbon dots (CDs) were prepared in situ and introduced onto amino-functionalized ordered mesoporous silica (SBA-NH2) by a facile microplasma-assisted method. The prepared CDs/SBA-NH2 nanocomposites preserved the high specific surface area of the mesoporous silica, as well as the fluorescent properties of the CDs. Compared with bare SBA-NH2, the CDs/SBA-NH2 nanocomposites showed much improved adsorption ability and excellent selectivity for uranyl ions. Moreover, the fluorescence intensity of the composites decreased along with the increase of uranium uptake, indicating that the CDs/SBA-NH2 nanocomposites could be used for on-site monitoring of the adsorption behavior. More interestingly, the adsorption selectivity of the composites for metal ions was in good agreement with the selective fluorescence response of the original CDs, which means that the adsorption selectivity of CDs-based composite materials can be predicted by evaluating the fluorescence selectivity of the CDs for metal ions. As the first study of CDs-based nanocomposites for the adsorption of actinide elements, this work opens a new avenue for the in situ monitoring of adsorption behavior of CDs-based nanocomposites while extending their application areas.