RESUMO
In this work, a 200 µm diameter InGaP (GaInP) p+-i-n+ mesa photodiode was studied across the temperature range 100 °C to 20 °C for the development of a temperature-tolerant electron spectrometer. The depletion layer thickness of the InGaP device was 5 µm. The performance of the InGaP detector was analysed under dark conditions and then under the illumination of a 183 MBq 63Ni radioisotope beta particle source. The InGaP photodiode was connected to a custom-made low-noise charge-sensitive preamplifier to realise a particle counting electron spectrometer. Beta spectra were collected at temperatures up to 100 °C with the InGaP device reverse biased at 5 V. The spectrum accumulated at 20 °C was compared with the spectrum predicted using Monte Carlo simulations; good agreement was found between the predicted and experimental spectra. The work is of importance for the development of electron spectrometers that can be used for planetary and space science missions to environments of high temperature or extreme radiation (e.g. Mercury, Jupiter's moon Europa, near-Sun comets), as well as terrestrial applications.
RESUMO
This paper investigates the effects of temperature on an InGaP (GaInP) 55Fe X-ray photovoltaic cell prototype for a radioisotope microbattery (also called a nuclear microbattery). An In0.5Ga0.5P p-i-n (5 µm i-layer) mesa photodiode was illuminated by a standard 206 MBq 55Fe radioisotope X-ray source and characterised over the temperature range -20 °C to 100 °C. The electrical power output of the device reached its maximum value of 1.5 pW at a temperature of -20 °C. An open circuit voltage and a short circuit current of 0.82 V and 2.5 pA, respectively, were obtained at -20 °C. While the electrical power output and the open circuit voltage decreased with increasing temperature, an almost flat trend was found for the short circuit current. The cell conversion efficiency decreased from 2.1% at -20 °C to 0.7% at 100 °C.
RESUMO
The roles of bulk surface states and interfacial defects are probed experimentally using a combination of current-voltage, capacitance-voltage, and impedance measurements. The critical importance of the quality of both the film and interfaces is evident in current-voltage measurements where shunting and interface states result in large dark currents and the subsequent loss of Jsc. These properties are shown to be critically related to the nature and role of the PbS QD interface with the (nominally) ohmic gold contact. Specifically, the nonideality of this interface results in the formation of an electric field and therefore a Schottky barrier that opposes the transport of carriers across the conventional ZnO-PbS CQD system. Nonidealities in the structure and absorber layer are also reflected in nonmonotonic behavior and dispersion in C-V measurements with trapping processes on the CQD surfaces, and the ZnO/PbS and PbS/Au interfaces also affecting the carrier dynamics, which is reflected in the response time of these systems under different biases.
RESUMO
This paper describes the performance of a fabricated prototype Al0.2Ga0.8As 55Fe radioisotope microbattery photovoltaic cells over the temperature range -20 °C to 50 °C. Two 400 µm diameter p+-i-n+ (3 µm i-layer) Al0.2Ga0.8As mesa photodiodes were used as conversion devices in a novel X-ray microbattery prototype. The changes of the key microbattery parameters were analysed in response to temperature: the open circuit voltage, the maximum output power and the internal conversion efficiency decreased when the temperature was increased. At -20 °C, an open circuit voltage and a maximum output power of 0.2 V and 0.04 pW, respectively, were measured per photodiode. The best internal conversion efficiency achieved for the fabricated prototype was only 0.95% at -20 °C.
