Malathion-resistant Tribolium castaneum has enhanced response to oxidative stress, immunity, and fitness.

Many cases of insecticide resistance in insect pests give resulting no-cost strains that retain the resistance genes even in the absence of the toxic stressor. Malathion (rac-diethyl 2-[(dimethoxyphosphorothioyl)sulfanyl]succinate) has been widely used against the red flour beetle, Tribolium castaneum Herbst. in stored products although no longer used. Malathion specific resistance in this pest is long lasting and widely distributed. A malathion resistant strain was challenged with a range of stressors including starvation, hyperoxia, malathion and a pathogen to determine the antioxidant responses and changes to some lifecycle parameters. Adult life span of the malathion-specific resistant strain of T. castaneum was significantly shorter than that of the susceptible. Starvation and/or high oxygen reduced adult life span of both strains. Starving, with and without 100% oxygen, gave longer lifespan for the resistant strain, but for oxygen alone there was a small extension. Under oxygen the proportional survival of the resistant strain to the adult stage was significantly higher, for both larvae and pupae, than the susceptible. The resistant strain when stressed with malathion and oxygen significantly increased catalase activity, but the susceptible did not. The resistant strain stressed with Paranosema whitei infection had significantly higher survival compared to the susceptible, and with low mortality. The malathion resistant strain of T. castaneum showed greater vigour than the susceptible in oxidative stress situations and especially where stressors were combined. The induction of the antioxidant enzyme catalase could have helped the resistant strain to withstand oxidative stresses, including insecticidal and importantly those from pathogens. These adaptations, in the absence of insecticide, seem to support the increased immunity of the insecticide resistant host to pathogens seen in other insect species, such as mosquitoes. By increasing the responses to a range of stressors the resistant strain could be considered as having enhanced fitness, compared to the susceptible.

Insecticide resistance and intracellular proteases.

Pesticide resistance is an example of evolution in action with mechanisms of resistance arising from mutations or increased expression of intrinsic genes. Intracellular proteases have a key role in maintaining healthy cells and in responding to stressors such as pesticides. Insecticide-resistant insects have constitutively elevated intracellular protease activity compared to corresponding susceptible strains. This increase was shown for some cases originally through biochemical enzyme studies and subsequently putatively by transcriptomics and proteomics methods. Upregulation and expression of proteases have been characterised in resistant strains of some insect species, including mosquitoes. This increase in proteolysis results in more degradation products (amino acids) of intracellular proteins. These may be utilised in the resistant strain to better protect the cell from stress. There are changes in insect intracellular proteases shortly after insecticide exposure, suggesting a role in stress response. The use of protease and proteasome inhibitors or peptide mimetics as synergists with improved application techniques and through protease gene knockdown using RNA interference (possibly expressed in crop plants) may be potential pest management strategies, in situations where elevated intracellular proteases are relevant. © 2017 Society of Chemical Industry.

Oviposition deterrent activities of Pachyrhizus erosus seed extract and other natural products on Plutella xylostella (Lepidoptera: Plutellidae).

An extract of a rotenone-containing plant yam bean, Pachyrhizus erosus (L.) Urban, seeds was tested against the diamondback moth, Plutella xylostella (L.) in a greenhouse to determine its potential as an oviposition deterrent and compared with coumarin and rutin, known as diamondback moth oviposition deterrent compounds, rotenone, and an extract of Peruvian cube root, at a concentration of 0.5% (w/v). Oviposition deterrent index (ODI) was used to determine effects of extracts or compounds in inhibiting oviposition of diamondback moth. Coumarin showed a stronger deterrent effect than the yam bean seed extract with a higher ODI value. On the contrary, rotenone, rutin, and the cube root extract, containing 6.7% (w/w) of rotenone, showed no significant deterrent effects having low or negative ODI values, suggesting that the deterrent effect of the yam bean seed extract is not due to rotenone content of the yam bean seeds. The extract of yam bean seed and coumarin partially deterred the moth from laying eggs on treated leaves in a concentration-dependent manner. The effective concentration for 50% deterrency of coumarin and the yam bean seed extract were 0.11 and 0.83% (w/v), respectively. However, the yam bean seed extract showed a residual deterrent effect on the moth even at 3 d after the treatment and is probably because of its low volatile nature. A long-term deterrency of the yam bean seed extract is an advantage over coumarins. Both the yam bean seed extract and coumarin deterred diamondback moth from laying eggs in total darkness, indicating their nonvisual deterrent effect. This made the extract an effective deterrence to diamondback moth in light and in darkness. To conclude, this study revealed the potential of the crude extract of the yam bean seed to prevent diamondback moth from ovipositing on its plant host.

Modeling pesticide leaching and dissipation in a mediterranean littoral greenhouse.

The one-dimensional chromatographic flow model PEARL was used to simulate the movement of the insecticide imidacloprid and the fungicide procymidone through a greenhouse soil. The model was parametrized using measured and literature values of soil hydrological parameters. Soil water movement and soil temperature were reasonably well described by the model. The ability of PEARL to simulate the fate of imidacloprid and procymidone following four applications of each compound was evaluated against greenhouse data. Simulated imidacloprid residues in the 0-10 cm layer were in good agreement with measured data. Below 10 cm, the model overestimated imidacloprid remaining following the spray applications, whereas simulated residues following the chemigation applications were in reasonable agreement with measured data. Simulated residues of procymidone in the 0-10 cm layer were in general agreement with measured values. In the 10-20 cm layer, peaks in simulated concentrations occurred later than observed in the greenhouse. Predictions of procymidone residues below 20 cm were poor and underestimated compared to the measured data. For both pesticides, discrepancies between modeled and measured data in the 10-20 cm layer were attributed to the drip irrigation method used in the greenhouse. The model was unable to satisfactorily predict pesticide movement from the soil surface by irrigation water unless the scenario was modified to reflect the localized pattern of water application. Scenario analysis indicated that air boundary layer thickness is a key parameter for readily volatilized pesticides such as procymidone. This is of particular relevance to the greenhouse environment, where the boundary layer thickness may be greater than that in outdoor conditions.

Low molecular weight polylactic acid as a matrix for the delayed release of pesticides.

Low molecular weight polylactic acid (LMW PLA) was used as a matrix to formulate biodegradable matrix granules and films with bromacil using a melt process. The compatibility of the PLA with bromacil was evaluated. The release characteristics of the formulations were investigated in vitro. The degradation and erosion of the formulations were monitored by pH and gravimetric analysis during the course of release. Various granules and films had similar biphasic release patterns, a delayed release followed by an explosive release. The release rates were independent of bromacil content in the matrix, but varied with the geometry of matrices. The mechanisms of diffusion and erosion were involved in the release. The delayed release of the formulations was dominantly governed by the degradation and erosion of PLA. LMW PLA underwent bulk erosion. LMW PLA-based matrix formulations could thus be useful for the application of pesticides to sensitive targets such as seed treatment.

Characterization of the sorption of an anthranilate fungicide in soil using thermal analytical and mineralogical techniques.

The sorption of pesticides to soil particles has implications for their distribution and fate in the soil environment. A batch equilibrium technique was used to investigate sorption of the fungicide AEC623892 to intact and hydrogen-peroxide-treated whole soils and several particle-size fractions isolated from them. Sorption of AEC623892 to the soil as a whole was low. K(f oc) values measured in the whole soils were 169.2 and 41.9 ml g(-1) for Soil A and Soil B respectively. The highest values of K(f oc) were measured in soil particle-size fractions <53 microm (266.5 ml g(-1) in the 2-20 microm fraction of Soil A; 471.9 ml g(-1) in the 20-53 microm fraction of Soil B). Sorption was most irreversible in the 2-20 microm fractions. Overall, treatment of soil particle-size fractions with hydrogen peroxide resulted in lower values of K(f oc) (112.3 ml g(-1) in Soil A whole soil and 30.9 ml g(-1) in Soil B whole soil). In both soils, the maximum sorption among hydrogen-peroxide-treated samples was observed in the <2 microm fraction (166.6 and 311.0 ml g(-1) for Soil A and Soil B, respectively). Investigation of the mineralogical composition of the soils suggested that the clay mineralogy (dominated by kaolinite and illite) is less likely to account for the differences in sorption observed than differences in the characteristics of the soil organic matter. Thermal analysis of the different soil fractions indicated that hydrogen peroxide treatment preferentially removed aliphatic fractions of organic matter, but had less effect on lignin-like, aromatic fractions.

Comparison of antioxidant activity in commercial Ginkgo biloba preparations.

AIM: To compare the relative levels of antioxidant activity in vitro in Ginkgo biloba samples (in tablet or capsule form) from different commercial suppliers, to determine whether some brands may be more efficacious in their potential to increase endogenous antioxidant activity, and thereby counter oxidative stress related disorders. DESIGN: Antioxidant activity of the above sample extracts was determined in vitro against the ABTS.(+) (2-2'-amino-bis-3-ethylbenzthiazoline-6-sulfonic acid) radical, relative to Trolox (water-soluble vitamin E analogue) antioxidant standards, using an established assay procedure. OUTCOME MEASURES: The relative antioxidant activity of G. biloba sample extracts was expressed in terms of millimoles per liter of Trolox equivalent (TE) for the initial extract, micromol TE per whole tablet, nmol TE per mg tablet, and nmol TE per mg ginkgo content. RESULTS: Data (as mean +/- standard deviation (SD) from 4 separate estimations) obtained in this study showed a considerable variation (approximately 50-fold) in the level of antioxidant activity in preparations from different suppliers, particularly when compared on an equivalent (i.e., nmol TE/mg ginkgo) basis. Of the 18 products investigated, the highest level of antioxidant activity (whether expressed as micromol TE per whole tablet or nmol TE/mg ginkgo) was obtained for Pharma Nord Bio-Biloba (Pharma Nord, Morpeth, UK) tablets (p < 0.05, Dunnett's statistical test). CONCLUSIONS: Some of the apparent variation in antioxidant activity of the various products investigated can be accounted for in terms of the physical nature of the G. biloba (i.e., dried leaf powder or standardized concentrated extract) used in tablet formulation. However, even when comparing products based on concentrated extract, the data demonstrated that there is still a considerable variation in antioxidant activity. Presumably this may result from differences in the manufacturing process between suppliers, which in turn may limit the efficacy of these preparations in the prevention or treatment of disease.

Controlled release of the herbicide, fluometuron, from matrix granules based on fractionated organosolv lignins.

An organosolv lignin and several of its fractions were used to prepare controlled release matrix granules with fluometuron using a melt process. Release profiles of fluometuron from these granules and a commercial granular formulation were studied in vitro. The release rates of fluometuron were considerably reduced from all lignin-based granules as compared to the commercial formulation. The release rates markedly varied with the lignin fraction used in the fluometuron-lignin matrix systems with the corresponding times for 50% release (T(50)) values ranging from 2.37 to 11.2 days. The variation in release rate of fluometuron was related to the high proportion of low molecular weight lignin and its associated water soluble lignin in the lignin-based granules, in terms of the hydrophobicity of matrix, the content, and release rate of soluble lignin. The release kinetics were fitted to the generalized model for up to 60% release of fluometuron; the kinetics of fluometuron were of the anomalous type for all matrixes in which release rates increased following a delay.

Parameterisation, evaluation and comparison of pesticide leaching models to data from a Bologna field site, Italy.

Effective prediction of pesticide fate using mathematical models requires good process descriptions in the models and good choice of parameter values by the user. This paper examines the ability of seven pesticide leaching models (LEACHP, MACRO, PELMO, PESTLA, PLM, PRZM and VARLEACH) to describe an arable field environment where sunflowers are grown in the Po Valley, northern Italy. Two pesticides were considered, aclonifen and ethoprophos. The models were evaluated in terms of their ability to reproduce field data of soil water content and pesticide residues in the soil and ground water. The evaluation was based on a combination of calibrated and uncalibrated runs. The results from the models were compared with each other to explore the differences between the models. The models varied in their ability to predict soil water content in the summer: the capacity models PRZM, PELMO and VARLEACH predicted less drying than MACRO, PESTLA, PLM and LEACHP. The models varied in their ability to simulate the persistence of the pesticides in the soil. Differences in the simulated pesticide degradation rate were observed between the models, due to variations in the simulated soil water content and soil temperature, and also differences in the equation linking degradation rate to soil water content. There were large differences among the predictions of the models for the mean leaching depth of ethoprophos. PRZM, PELMO, PESTLA and LEACHP all showed similar mean leaching depth to each other, whereas VARLEACH predicted lower ethoprophos mobility and PLM and MACRO predicted greater mobility. All the models overpredicted dispersion of ethoprophos through the soil profile, as compared to the field data. None of the models was able to simulate the field data of rapid leaching of pesticide to ground water except PLM after calibration of the percentage of macropores in the mobile pore space. More work is required in the parameterisation of macropore flow for those models that include this process.