Experimental Study on the Relationship between the Velocity of Surface Movements and Tilting Rate in Pre-Failure Stage of Rainfall-Induced Landslides.

With the development of deformation measuring technology at slope surfaces, prediction methods for rainfall-induced landslides based on the surface movements and tilting of slopes in the pre-failure stage have been recognized as a promising technique for risk reduction of slope failure triggered by rainfall. However, the correlation and possible mechanism for these prediction methods were rarely discussed. In this study, the comparison between the prediction methods of slope failure based on the time history of surface displacements and tilting in the acceleration stage was carried out by conducting a series of laboratory tests and field tests under rainfall, in which the movements and tilting behaviors at the slope surface were measured. The results show that the predicted failure time of tested slopes obtained by different prediction methods is consistent, and the correlation between these landslide prediction methods were also detected. A proportional relationship between the velocity of surface displacements and tilting rate was observed, and a possible mechanism for the sliding behavior was discussed based on this linear relationship as well. In addition, an expression for the linear relationship between the rate of the surface tilting and displacement was also established in this study, and the results could have significance for the understanding of the sliding behavior in the failure process in rainfall-induced landslides.

Investigation on Surface Tilting in the Failure Process of Shallow Landslides.

In recent decades, early warning systems to predict the occurrence of landslides using tilt sensors have been developed and employed in slope monitoring due to their low cost and simple installation. Although many studies have been carried out to validate the efficiency of these early warning systems, few studies have been carried out to investigate the tilting direction of tilt sensors at the slope surface, which have revealed controversial results in field monitoring. In this paper, the tilting direction and the pre-failure tilting behavior of slopes were studied by performing a series of model tests as well as two field tests. These tests were conducted under various testing conditions. Tilt sensors with different rod lengths were employed to investigate the mechanism of surface tilting. The test results show that the surface tilting measured by the tilt sensors with no rods and those with short rods located above the slip surface are consistent, while the tilting monitored by the tilt sensors with long rods implies an opposite rotational direction. These results are important references to understand the controversial surface tilting behavior in in situ landslide monitoring cases and imply the correlation between the depth of the slip surface of the slope and the surface tilting in in situ landslide monitoring cases, which can be used as the standard for tilt sensor installation in field monitoring.