RESUMO
A new high-strength, thermally stable, and degradable covalent organic framework (COF) -modified polylactic acid fiber (PLA) material (COF-PLA) was constructed for reinforcing the PLA material, to be used to produce environmentally friendly sand barriers. The micrographs, structure, thermal stability, and photodegradation products of COF-PLA were investigated. The results indicated that the COF material was compatible with PLA, and that the COF-PLA material took on the merits of the COF, so that it had a more regular arrangement, smoother surface, and smaller size, and was more thermostable than PLA alone. The successful incorporation of the COF improved the thermal stability of PLA. The initial pyrolysis temperature of the COF-PLA material is 313.7 °C, higher than that of the PLA material at 297.5 °C. The photodegradation products of COF-PLA and PLA indicated that the COF and PLA materials were mixed in a complex manner. After photodegradation, the COF-PLA material can produce melamine molecules that can neutralize the lactic acid and CO2 produced by PLA, which can maintain the acid-base balance in sandy soil and is beneficial to plant growth. Therefore, COF-PLA degradation does not cause pollution, making it a promising sand-control material.
RESUMO
An environmentally friendly liquefaction of wood powder was prepared by atmospheric pressure liquefaction technology to replace the non-renewable petroleum polyols in the preparation of polyurethane foam composites. The liquefaction time varied from 0 min to 140 min. The composition of liquefied products and the effects of liquefaction time on the morphology, apparent density and mechanical properties of polyurethane foam composites were investigated. The results showed that the optimal process time for the preparation of wood powder liquefaction products, which could replace traditional petroleum polyols, was 110 min. At this time, polyether polyols are the main liquefaction products, with an average molecular weight in Mn reaching 237 and average molecular weight in Mw reaching 246. The functional group of the liquefied product consisted mainly of hydroxyl, with the highest content of 1042 mg KOH/g and the lowest acid number of 1.6 mg KOH/g. In addition, the surface of the polyurethane foam based on poplar wood is dominated by closed cell foam; thus its foam has good heat insulation and heat preservation properties. At 110 min liquefaction time, the apparent density of polyurethane foam is 0.164 g/cm3 and the compression strength is 850 kPa, which is higher than that of traditional polyurethane foam (768 kPa), which is without wood powder modification. Replacing petroleum polyol with renewable wood powder liquefaction products to prepare biomass-based polyurethane foam composite materials, researching complex chemical changes in different liquefaction stages, and finding the best liquefaction conditions are of great significance to optimize the performance of polyurethane, address the shortage of resources and reduce environmental pollution.