Antioxidant CeO2 doped with carbon dots enhance ammonia production by an electroactive Azospirillum humicireducens SgZ-5T.

Microbial nitrogen fixation is a fundamental process in the nitrogen cycle, providing a continuous supply of biologically available nitrogen essential for life. In this study, we combined cerium oxide-doped carbon dots (CeO2/CDs) with electroactive nitrogen-fixing bacterium Azospirillum humicireducens SgZ-5T to enhance nitrogen fixation through ammonium production. Our research demonstrates that treatment of SgZ-5T cells with CeO2/CDs (0.2 mg mL-1) resulted in a 265.70% increase in ammonium production compared to SgZ-5T cells alone. CeO2/CDs facilitate electron transfer in the biocatalytic process, thereby enhancing nitrogenase activity. Additionally, CeO2/CDs reduce the concentration of reactive oxygen species in SgZ-5T cells, leading to increased ammonium production. The upregulation of nifD, nifH and nifK gene expression upon incorporation of CeO2/CDs (0.2 mg mL-1) into SgZ-5T cells supports this observation. Our findings not only provide an economical and environmentally friendly approach to enhance biological nitrogen fixation but also hold potential for alleviating nitrogen fertilizer scarcity.

Superior performance of a membrane bioreactor through innovative in-situ aeration and structural optimization using computational fluid dynamics.

The optimization of membrane bioreactors (MBRs) involves a critical challenge in structural design for mitigation of membrane fouling. To address this issue, a three-dimensional computational fluid dynamics (CFD) model was utilized in this study to simulate the hydrodynamic characteristics of a flat sheet (FS) MBR. The optimization of the membrane module configuration and operating conditions was performed by investigating key parameters that altered the shear stress and liquid velocity. The mixed liquor suspended solids (MLSS) concentration was found to increase the shear stress, leading to a more uniform distribution of shear stress. By optimizing the appropriate bubble diameter to 5 mm, the shear stress on the membrane surface was optimized with relatively uniform distribution. Additionally, extending the side baffle length dramatically improved the uniformity of the shear stress distribution on each membrane. A novel in-situ aeration method was also discovered to promote turbulent kinetic energy by 200 times compared with traditional aeration modes, leading to a more uniform bubble streamline. As a result, the novel in-situ aeration method demonstrated superior membrane antifouling potential in the MBR. This work provides a new approach for the structural design and optimization of MBRs. The innovative combination of the CFD model, optimization techniques, and novel in-situ aeration method has provided a substantial contribution to the advancement of membrane separation technology in wastewater treatment.

Flame-retardant ethylene vinyl acetate composite materials by combining additions of aluminum hydroxide and melamine cyanurate: Preparation and characteristic evaluations.

There is a great interest to develop efficient fire-resistant materials. While ethylene vinyl acetate (EVA) is a widely used material, it suffers from the problem of relatively high inflammability which seriously hinders its usage as the product material with a high flame-retardant requirement. In this study, a strategy to combine aluminum hydroxide (ATH) and melamine cyanurate (MCA) with EVA was proposed to prepare the EVA composite materials with high flame resistance. It was found that slight addition of MCA could increase the lubricity of EVA and raise the compatibility between EVA and ATH. Thermogravimetric analysis (TGA) indicated that the thermal stability of EVA was improved via adding MCA, which was evidenced by the delayed thermal decomposition temperature. Moreover, the combustion results indicated that the EVA composite with 60 parts per hundred (phr) ATH and 40 phr MCA addition (EVA-60-40) displayed the optimal isolated layer favoring the fire resistance. In addition, the highest limiting oxygen index (LOI) value (27.5%) and V-0 rating of the EVA-60-40 as compared with other components indicated its incombustible nature. These results suggested the synergetic effect of ATH and MCA additions, the high efficiency of the proposed strategy and the wide application prospect of the produced EVA-ATH-MCA composite materials.

[Assessment of Soil Fluorine Pollution in Jinhua Fluorite Ore Areas].

The contents of. soil total fluorine (TF) and water-soluble fluorine (WF) were measured in fluorite ore areas located in Jinhua City. The single factor index, geoaccumulation index and health risk assessment were used to evaluate fluorine pollution in soil in four fluorite ore areas and one non-ore area, respectively. The results showed that the TF contents in soils were 28. 36-56 052. 39 mg.kg-1 with an arithmetic mean value of 8 325.90 mg.kg-1, a geometric mean of 1 555. 94 mg.kg-1, and a median of 812. 98 mg.kg-1. The variation coefficient of TF was 172. 07% . The soil WF contents ranged from 0. 83 to 74. 63 mg.kg-1 with an arithmetic mean value of 16. 94 mg.kg-1, a geometric mean of 10. 59 mg.kg-1, and a median of 10. 17 mg.kg-1. The variation coefficient of WF was 100. 10%. The soil TF and WF contents were far higher than the national average level of the local fluorine epidemic occurrence area. The fluoride pollution in soil was significantly affected by human factors. Soil fluorine pollution in Yangjia, Lengshuikeng and Huajie fluorite ore areas was the most serious, followed by Daren fluorite ore area, and in non-ore area there was almost no fluorine pollution. Oral ingestion of soils was the main exposure route. Sensitivity analysis of model parameters showed that children's weight exerted the largest influence over hazard quotient. Furthermore, a significant positive correlation was found among the three kinds of evaluation methods.

Hg(0) oxidative absorption by K(2)S(2)O(8) solution catalyzed by Ag(+) and Cu(2+).

The aqueous phase oxidation of gaseous elemental mercury (Hg(0)) by potassium persulfate (K(2)S(2)O(8), KPS) catalyzed by Ag(+) and Cu(2+) was investigated using a glass bubble column reactor. Concentrations of gaseous Hg(0) and aqueous Hg(2+) were measured by cold vapor generation atomic absorption spectrometry (CVAAS). The effects of several experimental parameters on the oxidation were studied; these include different types of catalysts, pHs and concentrations of potassium persulfate, temperatures, Hg(0) inlet concentrations and tertiary butanol (TBA). The results showed that the removal efficiency of Hg(0) increased with increasing concentration of potassium persulfate and catalysts Ag(+), Cu(2+) and Ag(+) provided better catalytic effect than Cu(2+). For example, in the presence of 5.0 mmol l(-1) KPS, the mercury removal efficiency could reach 75.4 and 97.0% for an Ag(+) concentration of 0.1 and 0.3 mmol l(-1), respectively, and 69.8 and 81.9% for 0.1 and 0.3 mmol l(-1) Cu(2+). On the other hand, high temperature and the introduction of TBA negatively affect the oxidation. Furthermore, the removal efficiency of Hg(0) was much greater in neutral solution than in either acidic or alkaline solution. But the influence of pH was almost eliminated upon the addition of Ag(+) and Cu(2+), and high Hg(0) inlet concentration also has positive impact on the removal efficiency of Hg(0). The possible catalytic oxidation mechanism of gaseous mercury by KPS was also proposed.

Hg(0) absorption in potassium persulfate solution.

The aqueous phase oxidation of gaseous elemental mercury (Hg(0)) by potassium persulfate (KPS) catalyzed by Ag(+) was investigated using a glass bubble column reactor. Concentration of gaseous mercury and potassium persulfate were measured by cold vapor atom absorption (CVAA) and ion chromatograph (IC), respectively. The effects of pH value, concentration of potassium persulfate and silver nitrate (SN), temperature, Hg(0) concentration in the reactor inlet and tertiary butanol (TBA), free radical scavenger, on the removal efficiency of Hg(0) were studied. The results showed that the removal efficiency of Hg(0) increased with increasing concentration of potassium persulfate and silver nitrate, while temperature and TBA were negatively effective. Furthermore, the removal efficiency of Hg(0) was much better in neutral solution than in both acidic and alkaline solution. But the influence of pH was almost eliminated by adding AgNO(3). High Hg(0) concentration has positive effect. The possible reaction mechanism of gaseous mercury was also discussed.