The human sacrum and safe approaches for screw placement.

The human sacrum is the target of lumbosacral instrumentation and decompression procedures. Such surgical interventions require detailed knowledge of the anatomy of the human sacrum. The aim of this study was to measure surgically relevant parameters. Several factors, including the one-piece composition of the sacrum, the angles of the sacral pedicles and the anteroposterior diameter of the sacral vertebral bodies distinguish the sacrum from other parts of spine. Thirty-two measurements of shape, angles and distances between parts were taken of the sacra of 100 adult West Anatolian people using a Vernier caliper accurate to 0.1 mm and goniometer. According to this morphometric study, when measured from the sagittal, the S1 facet angle was measured as 35.71 degrees +/-9.59 and 34.70 degrees +/-9.66, the sacral pedicle anteromedial screw trajectory angle was 35.65 degrees +/-4.73 and 31.95 degrees +/-3.95 and the anterolaterally oriented sacral wing screw trajectory angle was 32.65 degrees +/-3.51 and 29.10 degrees +/-3.14, on the right and left sides, respectively. The distance of the midline oriented S1 pedicle screw was 51.12 mm and 51.26 mm on the right and left side, respectively. The distance for sacral wing oriented screw placement was 50.13 mm and 50.46 mm on the right and left side, respectively. The anteroposterior and transverse diameter of the sacral spinal canal were 21.81 mm and 31.31 mm, respectively. Thus, this study describes anatomical specifications of the sacrum. These defined morphometric details should be taken into consideration during surgical procedures. This study also describes anatomical landmarks which will allow injury of the sacrum during surgery to be avoided.

The relation between the lumbar vertebrae and the spinal nerves for far lateral lumbar spinal approaches.

The far lateral approaches to the lumbar spine require accurate knowledge of regional anatomy. The aim of this study is to evaluate the course of the lumbar nerve roots and their relation to important bony landmarks. Seven adult male cadavers fixed with formaldehyde were used. Morphometric parameters, including the lumbar nerve root diameters, the angle between the nerve roots and the midline, the transverse process length, the inter-transverse process height and width, and the relation between the nerve roots and the transverse processes of the caudal vertebrae were measured. It was observed that the diameter of the nerve roots, and the angle between the nerve roots and the midline, and the distance between the nerve roots and the lateral edge of the superior articular process increased gradually from L1 to L5. The diameter of the nerve root was 4.9+/-0.5mm for L1 and 7.5+/-1.0mm for L5. The midline nerve root angle was 36.1+/-1.6 degrees mm for L1 and 40.4+/-1.4 degrees mm for L5. The distance between the nerve root and the lateral edge of the superior articular process was 6.5+/-1.0mm for L1 and 11.4+/-1.6mm for L5. The nerve roots crossed the transverse processes of the caudal lumbar vertebrae. The nerve roots of L1 and L2 crossed the transverse processes in their first two quarters, the L3 nerve root crossed the transverse process in its second, third or fourth quarters, and the L4 nerve roots crossed the L5 transverse process in its third and fourth quarter or even external to it. Descending toward the lower lumbar vertebrae, the diameter of the lumbar nerve root increases and the nerve roots exit the intervertebral foramen with a larger angle. The special relation between the nerve roots and the caudal vertebra transverse process should be remembered during far lateral lumbar spine approaches.