RESUMO
Adsorption-based atmospheric water harvesting (AWH) with solar-driven photothermal desorption has become an effective means of solving freshwater scarcity in arid regions due to its low energy consumption and high efficiency. Moisture adsorption and desorption capacities are the most critical properties in AWH, and it is a challenge to improve the rate of moisture adsorption and desorption of composite adsorbents. Therefore, this paper reports a SA/carboxymethyl chitosan (CCS)/C/CaCl2-U composite aerogel adsorbents with simultaneously green, low-cost, degradable, and fast hygroscopicity and desorption kinetics. The composite adsorbent used water-soluble biomass materials sodium alginate (SA) and carboxymethyl chitosan (CCS) as the backbone of the aerogel, constructed a vertically aligned unidirectional pore structure by directional freezing, and introduced nanocarbon powder and moisture-absorbent salt calcium chloride (CaCl2) to improve the solar photothermal performance and water absorption, respectively. The results showed that the composite adsorbent had good water uptake capacity at 30-90% relative humidity (RH), the time to reach the water uptake of 1 g g-1 at 90% RH was only 2.5 h, and the final water uptake rate was up to 1.9 g g-1 within 12 h. Meanwhile, the composite sorbent can be heated and desorbed basically within 1 h at 80 °C and its evaporation efficiency is 1.3 times higher than that of the aerogel sorbent prepared by the conventional method when irradiated with 1000 W m-2 light intensity for 2 h. Therefore, the SA/CCS/C/CaCl2-U composite aerogel adsorbent of this study has a potential that can be applied in AWH due to its environmental friendliness, low cost, and faster hygroscopic desorption kinetics.
RESUMO
The flexible manipulation of underwater gas bubbles on solid substrates has attracted considerable research interest from scientists in the fields of water electrolysis, bubble microreactions, drug delivery, and heat transfer. Inspired by the oxygen-binding mechanisms of aquatic organisms, scientists have designed a series of interfacial materials for use in collecting gases, detecting and grading bubbles, and conducting microbubble reactions. Aerophilic surfaces are commonly used in underwater bubble manipulation platforms due to their excellent gas-trapping properties. However, during bubble transport, some of the bubbles are retained in the rough structure of the aerophilic surface and cause gas loss, which in the long run reduces the gas transport function. In addition, the aerophilic surface is prone to failure in high-humidity and high-pressure underwater environments. The lubricant-infused surface features an oil layer that remains stable on a rough substrate and is immiscible with water. Additionally, the bubbles are transported over the oil layer without causing losses other than those dissolved in water. These attributes make it more favorable than the aerophilic surface. Inspired by the unique properties of Nepenthes and cactus spines, we developed a patterned slippery surface [patterned lubricant-infused surface (PLIS)] through laser etching and ammonia etching that facilitates the coexistence of superaerophobic and aerophilic surfaces. The PLIS executes bubble capture utilizing a difference in wettability measuring 78°, transports bubbles through Laplace force and buoyancy, and regulates bubble release by restricting the contact area on the PLIS. The PLIS can be prepared rapidly and affordably in just about an hour, and its potential for large-scale production is high. Following tests for shear, acid and alkali resistance, and corrosion resistance, the PLIS exhibited impressive weathering resistance and appears to have potential for application in some extreme environments.
