RESUMO
A field experiment was conducted in a modern municipal solid waste (MSW) incineration power plant to explore the feasibility of using chemical agglomeration agent anionic polyacrylamide (PAM) to reduce the atmospheric emission of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs). Spraying PAM solution into the cooling tower caused an obvious decrease in the volume fraction of ultrafine and fine particles with diameter of 0.3-30 µm in BF fly ash, and a significant reduction in dust content in stack gas. The increased agglomeration of particles promoted the removal of particle-phase PCDD/Fs by BF, and thus resulted in a lower atmospheric emission of PCDD/Fs. The calculated removal efficiency of PCDD/Fs by BF was almost positively proportional to the concentration of PAM solution, while inversely proportional to the average content of dusk in stack gas. Compared with the control treatment, the spraying of 0.1 g/L PAM solution enhanced the removal efficiency of total tetra-to octa-CDD/Fs (∑PCDD/Fs) from 93.8% to 97.8% by BF, and resulted in a decrease of 47.0% in the concentration of international toxicity equivalent (I-TEQ) in stack gas. During the experiment of 2 d, the spraying of PAM solution did not induce a significant change in the differential pressure of BF, and did not essentially affect the partitioning behaviors of PCDD/F homologues between flue gas and BF fly ash. In view of technical safety and low cost, PAM application is recommended for reducing the atmospheric emission of PCDD/Fs from MSW incineration system.