RESUMO
This study investigates the use of low molecular weight poly(ethylene glycol) (PEG) as a plasticizer for poly(lactic acid) (PLA). PLA/PEG blend films were prepared using the solvent casting method with varying mixing ratios. The films were analyzed using differential scanning calorimetry (DSC), dynamic mechanical analysis (DMA), and dynamic rheological analysis. The results indicate that the addition of PEG as a plasticizer affects the thermal and mechanical properties of the PLA/PEG blend films. The study found that the glass transition and cold crystallization temperatures decreased with increasing PEG content up to 20 wt%, while the crystallinity and crystallization rate increased. The blends with up to 20 wt% PEG were miscible, but phase separation occurred when the plasticizer content was increased to 30 wt%. Subsequently, amorphous samples of neat PLA and PLA plasticized with 10 wt% of PEG underwent annealing at various temperatures (Ta = 80-120 °C) for durations ta of 1 and 24 h. The samples were then analyzed using DSC and DMA. The addition of PEG to PLA altered the content of α' and α crystalline forms compared to neat PLA at a given (Ta; ta) and favored the formation of a mixture of α' and α crystals. The crystallinity achieved upon annealing increased with increasing Ta or ta and with the incorporation of PEG.
RESUMO
This investigation reports on the thermomechanical properties of Poly-tripropyleneglycoldiacrylate (Poly-TPGDA)/liquid crystal (LC) blends, developed via free radical polymerization processes, which are induced by Electron Beam (EB) and Ultraviolet (UV) radiation. The EB-cured Poly-TPGDA network exhibits a higher glass transition temperature (Tg), a higher tensile storage, and Young moduli than the corresponding UV-cured sample, indicating a lower elasticity and a shorter distance between the two adjacent crosslinking points. Above Tg of Poly-TPGDA/LC blends, the LC behaves as a plasticizing agent, whereas, for EB-cured networks, at temperatures below Tg, the LC shows a strong temperature dependence on the storage tensile modulus: the LC reinforces the polymer due to the presence of nano-sized phase separated glassy LC domains, confirmed by electron microscopy observations. In the case of the UV-cured TPGDA/LC system, the plasticizing effect of the LC remains dominant in both the whole composition and the temperature ranges explored. The rubber elasticity and Tg of Poly-TPGDA/LC films were investigated using mechanical measurements.