RESUMO
This paper applies a recently developed technique for deriving long-term trends in ozone from sparsely sampled data sets to multiple occultation instruments simultaneously without the need for homogenization. The technique can compensate for the nonuniform temporal, spatial, and diurnal sampling of the different instruments and can also be used to account for biases and drifts between instruments. These problems have been noted in recent international assessments as being a primary source of uncertainty that clouds the significance of derived trends. Results show potential "recovery" trends of â¼2-3 % decade-1 in the upper stratosphere at midlatitudes, which are similar to other studies, and also how sampling biases present in these data sets can create differences in derived recovery trends of up to â¼1 % decade-1 if not properly accounted for. Limitations inherent to all techniques (e.g., relative instrument drifts) and their impacts (e.g., trend differences up to â¼2 % decade-1) are also described and a potential path forward towards resolution is presented.
RESUMO
The optical properties of PbSe quantum dots (QDs) in AB9093 epoxy nanocomposite are examined with respect to temperature over a range of 0°C-80°C, a useful working range for many QD-based sensors and devices, and results are compared to QDs in toluene solution. A complete characterization of QD optical properties is provided as a function of temperature, including the absorption spectrum, first excitonic (1-s) absorption peak intensity and wavelength, fluorescence intensity, and peak wavelength. QD optical properties in toluene were found to be more sensitive to temperature as compared to those in AB9093. Interestingly, 1-s and fluorescence peak wavelength variation with temperature are reversed in AB9093 as compared to those in toluene solution. Results for the fluorescence properties of Lumogen F Red 305 dye in toluene are presented for comparison. The dye was found to have similar sensitivity to temperature to that of the QDs in terms of fluorescence peak wavelength shift, but the fluorescence peak intensity was far less variant. These results can be used to build a temperature sensor or as a guide to building other types of QD-based devices to be more robust against changes in ambient temperature.
RESUMO
The results are presented for luminescent solar concentrators (LSCs) fabricated with poly(lauryl methacrylate-co-ethylene glycol dimethacrylate) (P(LMA-co-EGDMA)) and Angstrom Bond, Inc. AB9093 acrylic epoxy matrix, high quantum yield (> 70%) PbSe quantum dots (QDs) and silicon photovoltaic (Si PV) cells. LSCs were tested under a lamp with broadband illumination, photon flux-matched to a standard solar spectrum and verified under a calibrated solar lamp source. The P(LMA-co-EGDMA) sample demonstrated the highest power conversion efficiency of any known LSC fabricated with either QDs or Si PV cells, 4.74%. Additionally, increased temperature was shown to reduce efficiency.
RESUMO
Optical absorption and fluorescence properties of PbSe quantum dots (QDs) in an Angstrom Bond AB9093 epoxy polymer matrix to form a nanocomposite were investigated. To the authors' knowledge, this is the first reported use of AB9093 as a QD matrix material and it was shown to out-perform the more common poly(methyl methacrylate) matrix in terms of preserving the optical properties of the QD, resulting in the first reported quantum yield (QY) for PbSe QDs in a polymer matrix, 26%. The 1-s first excitonic absorption peak of the QDs in a polymer matrix red shifted 65 nm in wavelength compared to QDs in a hexane solution, while the emission peak in the polymer matrix red shifted by 38 nm. The fluorescence QY dropped from 55% in hexane to 26% in the polymer matrix. A time resolved fluorescence study of the QDs showed single exponential lifetimes of 2.34 and 1.34 µs in toluene solution and the polymer matrix respectively.
