The Effect of Arthroscopic Extra-Articular Entire Coracohumeral Ligament Release for Patients with Recalcitrant Frozen Shoulder.

OBJECTIVE: The thickened coracohumeral ligament (CHL) is an important part of the typical manifestations and magnetic resonance imaging of frozen shoulder. However, only a few clinical studies with limited cases on arthroscopic extra-articular entire CHL release exist in the literature. This study was to evaluate the effect of arthroscopic extra-articular entire CHL release for patients with recalcitrant frozen shoulder. METHODS: From February 2014 to February 2020, 81 cases of recalcitrant frozen shoulder patients treated with surgery in a single-center shoulder department and followed for more than 2 years were analyzed. Arthroscopic 360° capsular release was performed with intra-articular partial release (IPR group) or additional extra-articular entire release (IPR + EER group) of CHL. The same rehabilitation program was performed after surgery in both groups. Visual analogue scale (VAS) for pain, range of motion (ROM), and the Constant-Murley scoring system was evaluated before operation, at 3 months after operation, 6 months after operation, and the final follow-up. T-test, Mann-Whitney U-test and chi-squared test were used to compared data. RESULTS: There were 39 patients in the IPR group, with an average follow-up of 29.2 months. A total of Forty-two patients in the IPR + EER group completed a mean follow-up of 25.7 months. All incisions healed in stages. There were significant differences in Constant-Murley shoulder score, VAS score, and ROM before operation and at the final follow-up in both groups (both P < 0.001). The VAS score of the IPR + EER group was lower than that of the IPR group at 3 months after surgery (P < 0.05), and 6 months after operation (P < 0.05). External rotation, internal rotation, and abduction of ROMs and Constant-Murley shoulder score were significantly greater in the IPR + EER group at 3 months (P < 0.001, P < 0.05, P < 0.001, P < 0.05, respectively) and 6 months after operation (P < 0.001, P < 0.05, P < 0.001, P < 0.05, respectively). At the last follow-up, there was no significant difference in forward flexion, internal rotation, and abduction of ROMs, VAS, and the Constant-Murley shoulder score between the IPR and IPR + EER groups. The external rotation of the IPR + EER group was still greater than that of the IPR group at the last follow-up (P < 0.001). CONCLUSION: Arthroscopic extra-articular entire coracohumeral ligament release could solve early pain of shoulder joint, recover shoulder joint functions effectively, and achieve a satisfactory efficacy in the treatment of recalcitrant frozen shoulder.

Clinical Study of Wrist Arthroscopy Combined with Oblique Ulnar Shortening Osteotomy in the Treatment of Ulnar Impaction Syndrome.

OBJECTIVE: To explore the clinical effects of wrist arthroscopy combined with oblique ulnar shortening osteotomy in the treatment of ulnar impaction syndrome. METHODS: This was a retrospective study of 60 patients with ulnar impaction syndrome who were admitted to our department from January 2016 to December 2019. According to different surgical methods, they were divided into an observation group and a control group, with 30 cases in each group. The control group was treated with oblique ulnar shortening osteotomy, and the observation group used wrist arthroscopy based on the control group. The two groups of patients were compared in terms of wrist function before and 12 months after surgery. We compared the Disabilities of the Arm, Shoulder, and Hand Score (DASH Score), Patient-Rated Wrist Evaluation Score (PRWE Score), Visual Analog Score (VAS), and ulnar variation between the two groups at 12 months after surgery. The excellent and good rates by Mayo wrist score were compared between the two groups at the last follow-up. RESULTS: All patients were followed up for 12-36 months, with an average of 14.5 months. Bone union was achieved at the oblique osteotomy of the ulna, with an average healing time of 13.6 weeks. The observation group was examined by wrist arthroscopy, and the triangular fibrocartilage complex (TFCC) Palmer classification was confirmed in three cases of type IIA, seven cases of type IIB, 14 cases of type IIC, and six cases of type IID. Compared with before surgery, the grip strength, flexion-extension, ulnar radial deflection, and forearm rotation of the two groups of patients were significantly improved at 12 months after surgery. The DASH score, PRWE score, and VAS score of the observation group were better than those of the control group, and the difference in ulnar shortening length was not statistically significant between the two groups. The excellent and good rates of the observation group (93.3%) were better than those of the control group (87.5%) at the last follow-up, and the difference was statistically significant. CONCLUSION: Compared with oblique ulnar shortening osteotomy alone, combined wrist arthroscopy can better reduce the pain of patients with ulnar impaction syndrome, restore wrist function, and improve the excellent and good rates. Therefore, it is clinically worthy of promotion.

Combined transcriptome and metabolome integrated analysis of Acer mandshuricum to reveal candidate genes involved in anthocyanin accumulation.

The red color formation of Acer mandshuricum leaves is caused by the accumulation of anthocyanins primarily, but the molecular mechanism researches which underlie anthocyanin biosynthesis in A. mandshuricum were still lacking. Therefore, we combined the transcriptome and metabolome and analyzed the regulatory mechanism and accumulation pattern of anthocyanins in three different leaf color states. In our results, 26 anthocyanins were identified. Notably, the metabolite cyanidin 3-O-glucoside was found that significantly correlated with the color formation, was the predominant metabolite in anthocyanin biosynthesis of A. mandshuricum. By the way, two key structural genes ANS (Cluster-20561.86285) and BZ1 (Cluster-20561.99238) in anthocyanidin biosynthesis pathway were significantly up-regulated in RL, suggesting that they might enhance accumulation of cyanidin 3-O-glucoside which is their downstream metabolite, and contributed the red formation of A. mandshuricum leaves. Additionally, most TFs (e.g., MYBs, bZIPs and bHLHs) were detected differentially expressed in three leaf color stages that could participate in anthocyanin accumulation. This study sheds light on the anthocyanin molecular regulation of anthocyanidin biosynthesis and accumulation underlying the different leaf color change periods in A. mandshuricum, and it could provide basic theory and new insight for the leaf color related genetic improvement of A. mandshuricum.

[Anatomical repair of Atzei-EWAS type 2 triangular fibrocartilage complex injury under wrist arthroscopy].

OBJECTIVE: To explore the effectiveness of anatomical repair of Atzei-EWAS type 2 triangular fibrocartilage complex (TFCC) injury under wrist arthroscopy. METHODS: Between March 2018 and March 2020, 16 patients with Atzei-EWAS type 2 TFCC injury were admitted, and the TFCCs were anatomically repaired with a three-dimensional suture with a thread anchor under wrist arthroscopy. There were 10 males and 6 females with an average of 40.2 years (range, 22-54 years). The disease duration ranged from 2 to 9 months (mean, 6.4 months). Preoperative grip strength of the affected limb was (20.06±3.38) kg, wrist range of motion in flexion and extension was (117.19±7.74)°, radial-ulnar deviation was (31.25±5.32)°, forearm rotation range of motion was (137.19±14.83)°, visual analogue scale (VAS) score was 5.6±1.2. At last follow-up, the effectiveness was evaluated by the grip strength of the affected limb, the range of motion of the wrist joint, the VAS score, and the modified Mayo wrist score. RESULTS: All incisions healed by first intention. One case had paralysis of the dorsal branch of the ulnar nerve after operation, and no other complications occurred in other cases. All patients were followed up 12-18 months (mean, 14.5 months). The distal radioulnar joint stability of all patients recovered. At last follow-up, the grip strength of the affected limb was (24.88±3.26) kg, the range of motion in flexion and extension was (146.59±6.49)°, radial-ulnar deviation was (39.38±6.55)°, and forearm rotation range of motion was (152.50±11.55)°, which were significantly higher than those before operation ( P<0.05); the VAS score was 0.9±0.8, which was significantly lower than that before operation ( t=21.029, P=0.000). The modified Mayo wrist score was rated as excellent in 10 cases, good in 5 cases, and fair in 1 case. The excellent and good rate was 93.8%. MRI results showed that TFCC healed in all cases. CONCLUSION: For Atzei-EWAS type 2 TFCC injury, anatomical repair under wrist arthroscopy can restore the anatomical structure of TFCC, effectively relieve wrist pain, improve function, and obtain good effectiveness.

Three-Dimensional Printing-Assisted Masquelet Technique in the Treatment of Calcaneal Defects.

OBJECTIVE: The aim of the present study was to summarize the clinical efficacy of three-dimensional (3D) printing technology combined with the Masquelet technique in the treatment of calcaneal defects. METHODS: From January 2018 to April 2019, 3D printing combined with induced masquelet technology was used to treat four patients with calcaneal defects, including two men and two women. The patients were aged 22-52 years old, with an average age of 36 years. There were two cases of traffic accident injuries, there was one case of a fall from height, and there was one case of crush injury. CT scans were used to reconstruct the bilateral calcaneus, mirror technology was used to construct the bone defect area, and Materialise 3-matic software was used to design the calcaneus shaper mold and 3D print the mold. During the operation, the mold was used to shape the bone cement and fill the bone defect. In the second stage, the bone cement was removed and autologous bone was implanted to repair the bone defect. All patients were followed up to observe the effect. RESULTS: All four patients were followed up for 14 months (range, 10-18 months). There were three cases of infectious bone defects: two cases of Escherichia coli and one case of Pseudomonas aeruginosa. The 3D printed mold was used to shape the bone cement. During the operation, it was found to have a high degree of matching with the defect area of calcaneus. There is no need to adjust it again, and the wound healed well after the first stage. In the second stage of surgery, it was found that the induced membrane formed was complete and of appropriate size; the bone cement was easily removed during the operation. The fracture healing time was 3-6 months, with an average of 4 months. At the last follow up, there was no pain and the patients walked with full weight bearing. The Maryland score was 94 points (range, 88-98 points); three cases were excellent and one case was good. The AOFAS score ranged from 86 to 98, with an average of 92.8 points; three cases were excellent and one case was good. CONCLUSION: Three-dimensional printing technology combined with induced membrane technology is an effective approach for treating calcaneal bone defects.

[Treatment of the fifth metacarpal neck fracture with elastic intramedullary nail under the guidance of high frequency ultrasound].

OBJECTIVE: To analyze the feasibility and effectiveness of elastic intramedullary nail fixation for the fifth metacarpal neck fracture under the guidance of high frequency ultrasound. METHODS: The clinical data of 30 patients with the fifth metacarpal neck fractures who were treated with elastic intramedullary nails fixation under the guidance of high frequency ultrasound and met the selection criteria between May 2013 and September 2017 were retrospectively analysed. There were 24 males and 6 females, the age ranged from 18 to 58 years, with an average of 31.4 years. The head-shaft angle of the fifth metacarpal was (55.6±11.3)°. The time from injury to operation was 12 hours to 8 days, with an average of 2.4 days. The operation time, number of intraoperative fluoroscopy, fracture reduction, complications, and fracture healing time were recorded. The head-shaft angle of the fifth metacarpal on the affected side after fracture healing were measured and compared with the healthy side. At last follow-up, the active range of motion of the fifth metacarpophalangeal joint of both sides were measured, and the function was evaluated by using the total active movement (TAM) evaluation standard of the Hand Surgery Association of Chinese Medical Association. RESULTS: The operation time was 22-40 minutes, with an average of 32.4 minutes; the intraoperative fluoroscopy was performed once; ultrasound images and X-ray fluoroscopy showed that the fracture was well reduced and no adjustment was required. The incisions healed well after operation, without tendon adhesion or local numbness. All 30 patients were followed up 8-16 months, with an average of 11.7 months. The fracture healing time was 4-8 weeks, with an average of 5.6 weeks. The head-shaft angle of the fifth metacarpal was (13.2±1.4)°, which was significantly improved when compared with preoperative value ( t=-20.02, P=0.00); and there was no significant difference ( t=1.94, P=0.06) when compared with the healthy side [(12.6±1.0)°]. At last follow-up, the active range of motion of the fifth metacarpophalangeal joint on the affected side was (89.4±2.4)°, showing no significant difference ( t=-1.58, P=0.13) when compared with the healthy side [(90.3±2.0)°]. According to the TAM evaluation standard of the Hand Surgery Association of Chinese Medical Association, all patients were considered to be excellent. CONCLUSION: The effectiveness of elastic intramedullary nail fixation for the fifth metacarpal neck fracture under the guidance of high frequency ultrasound is definite. It can dynamically observe the fracture reduction from different angles, reduce ionizing radiation and postoperative complications.