RESUMO
Piezo-photocatalysis combines photocatalysis and piezoelectric effects to enhance catalytic efficiency by creating an internal electric field in the photocatalyst, improving carrier separation and overall performance. This study presents a high-performance piezo-photocatalyst for efficient dye degradation using a synergistic barium titanate (BTO)-MXene composite. The composite was synthesized via a facile method, combining the unique properties of BTO nanoparticles with the high conductivity of MXene. The structural and morphological analysis confirmed the successful formation of the composite, with well-dispersed BTO nanoparticles on the MXene surface. The piezo-photocatalytic activity of the composite was evaluated using a typical dye solution (Rhodamine B: RhB) under ultraviolet irradiation and mechanical agitation. The results revealed a remarkable enhancement in dye degradation (90 % in 15 min for piezo-photocatalysis) compared to individual stimuli (58.2 % for photocatalysis and 95.8 % in 90 min for piezocatalysis), highlighting the synergistic effects between BTO and MXene. The enhanced catalytic performance was attributed to the efficient charge separation and transfer facilitated by the composite's structure, leading to increased reactive species generation and dye molecule degradation. Furthermore, the composite exhibited excellent stability and reusability, showcasing its potential for practical applications in wastewater treatment. Overall, this work represents a promising strategy for designing high-performance synergistic catalysts, addressing the pressing need for sustainable solutions in environmental remediation.
RESUMO
Piezocatalysis-induced dye degradation has garnered significant attention as an effective method for addressing wastewater treatment challenges. In our study, we employed a room-temperature sonochemical method to synthesize piezoelectric barium titanate nanoparticles (BaTiO3: BTO) with varying levels of Li doping. This approach not only streamlined the sample preparation process but also significantly reduced the overall time required for synthesis, making it a highly efficient and practical method. One of the key findings was the exceptional performance of the Li-doped BTO nanoparticles. With 20â mg of Li additive, we achieved 90 % removal of Rhodamine B (RhB) dye within a relatively short timeframe of 150â minutes, all while subjecting the sample to ultrasonic vibration. This rapid and efficient dye degradation was further evidenced by the calculated kinetic rate constant, which indicated seven times faster degradation rate compared to pure BTO. The enhanced piezoelectric performance observed in the Li-doped BTO nanoparticles can be attributed to the strategic substitution of Li atoms, which facilitated a more efficient transfer of charge charges at the interface. Overall, our study underscores the potential of piezocatalysis coupled with advanced materials like Li-doped BTO nanoparticles as a viable and promising solution for wastewater treatment, offering both efficiency and environmental sustainability.
RESUMO
Ni-rich layered ternary cathodes are promising candidates thanks to their low toxic Co-content and high energy density (â¼800 Wh/kg). However, a critical challenge in developing Ni-rich cathodes is to improve cyclic stability, especially under high voltage (>4.3 V), which directly affects the performance and lifespan of the battery. In this study, niobium-doped strontium titanate (Nb-STO) is successfully synthesized via a facile solvothermal method and used as a surface modification layer onto the LiNi0.8Co0.1Mn0.1O2 (NCM811) cathode. The results exhibited that the Nb-STO modification significantly improved the cycling stability of the cathode material even under high-voltage (4.5 V) operational conditions. In particular, the best sample in our work could provide a high discharge capacity of â¼190 mAh/g after 100 cycles under 1 C with capacity retention over 84% in the voltage range of 3.0-4.5 V, superior to the pristine NCM811 (â¼61%) and pure STO modified STO-811-600 (â¼76%) samples under the same conditions. The improved electrochemical performance and stability of NCM811 under high voltage should be attributed to not only preventing the dissolution of the transition metals, further reducing the electrolyte's degradation by the end of charge, but also alleviating the internal resistance growth from uncontrollable cathode-electrolyte interface (CEI) evolution. These findings suggest that the as-synthesized STO with an optimized Nb-doping ratio could be a promising candidate for stabilizing Ni-rich cathode materials to facilitate the widespread commercialization of Ni-rich cathodes in modern LIBs.
RESUMO
The crystalline and electronic structures are two important factors for the design of electrocatalysts. In this work, Co-doped MnO electrocatalysts grown on nickel foam (NF) were prepared by a facile hydrothermal reaction, followed by H2 treatment process. The electrocatalytic performance of MnO was significantly improved after doping with Co and the Co0.1Mn0.9O-NF sample achieved excellent oxygen evolution reaction (OER) performance with low overpotential (370 mV at 10 mA cm-2) and reasonable Tafel slope (85.6 mV dec-1). Significantly, the low work function was obtained in the Co0.1Mn0.9O-NF sample (4.37 eV), which could accelerate the charge transfer process of the OER activity. The excellent OER performance of the Co0.1Mn0.9O-NF sample is also attributed to the rich active sites, which improved electrical conductivity and enlarged electrochemical surface areas.
RESUMO
Metallic 1T-phase MoS2 exhibits superior hydrogen evolution reaction (HER) performance than natural 2H-phase MoS2 owing to its higher electrical conductivity and abundance of active sites. However, the reported 1T-MoS2 catalysts usually suffer from extreme instability, which results in quick phase transformation at ambient conditions. Herein, we present a facile approach to engineer the phase of MoS2 by introducing intercalated hydrazine. Interestingly, the as-synthesized 1T-dominant MoS2 sample demonstrates excellent ambient stability without noticeable degradation for 3 months. Additionally, the 1T-dominant MoS2 exhibits superior electrical conductivity (â¼700 times higher than that of 2H-MoS2) and improved electrochemical catalytic performance (current density â¼12 times larger than that of 2H-MoS2 at an overpotential of 300 mV vs the reversible hydrogen electrode, RHE). Through experimental characterizations and density functional theory (DFT) calculation, we conclude that the stabilization of the metallic phase could be attributed to the electron donation from hydrazine molecules to the adjacent Mo atoms. The phase control strategy in this work provides a guideline to develop other highly efficient and stable two-dimensional (2D) electrocatalysts.
RESUMO
The aim of this study was to determine the presence of and characterize methicillin-resistant Staphylococcus pseudintermedius (MRSP) isolated from pets in South China. From 2007 to 2009, 898 samples were collected from 785 pets in Guangdong Province. The identity of staphylococcal species and the presence of methicillin resistance were confirmed by phenotypic and genotypic assays. The genetic relationships of MRSP isolates were determined by multilocus sequence typing (MLST), PFGE and spa typing. SCCmec elements and antimicrobial resistance genes profiling were characterized by PCR amplification. A total of 144 S. pseudintermedius isolates were recovered from the dogs and cats tested, and 69 (47.9%) of these isolates were identified as MRSP. Most of the MRSP isolates exhibited simultaneous resistance to four or more different antimicrobial agents. However, valnemulin showed robust activity against MRSP (MIC(90)=1 µg/ml). Integron 1, 2 and 3 were not detected in MRSP isolates. Twenty-four different multilocus sequence types were found among the MRSP isolates, with ST4 (n=9), ST5 (n=8), and ST95 (n=7) being dominant sequence types. In addition, 8 new sequence types (ST134, 135, 136, 137, 138, 139, 140 and 148) were identified. Of the 69 MRSP isolates, SCCmecV was the most prevalent type (n=33), followed by SCCmecVII (n=13), SCCmecII-III (n=7), and SCCmecIII (n=4). This study demonstrates for the first time that the occurrence of MRSP in healthy pets in China and shows that MRSP in South China has high genetic diversity.