Pollutant gas and particulate material emissions in ethanol production in Brazil: social and environmental impacts.

The replacement of fossil-based fuels by renewable fuels (biofuels) was proposed in the IPCC report, as an alternative to reduce greenhouse gas emission and reach out to a low-carbon economy. On this perspective, the Brazilian government had implemented a renewable energy program based on the use of ethanol in the transport sector. This work evaluates the scenario of pollutant gas emissions and particulate material that comes from the biomass burning process involved in ethanol production cycle, in the city of Campos dos Goytacazes, Brazil. The gases and particulate material emitted by sugarcane and bagasse burning processes-the last one in energy co-generation mills-were analyzed. A laboratory-controlled burning of both samples was realized in an oven with temperature ramp from 250 to 400 °C, at a regular rate of 50 °C. The gas samples were collected directly from the oven's exhaust pipe. The particulates obtained were the residual material taken out of the burned samples: a powder with the aspect of soot. A photoacoustic spectroscopy system coupled with quantum cascade laser and electrochemical analyzers was used to measure the emission of polluting gases such as N2O, CO2, CO, NOx (NO, NO2), and SO2 in ppmv range. Fluorescent X-ray spectrometry was applied to evaluate the chemical composition of particulate material, enabling the identification of elements such as Si, Al, Ca, K, Fe, S, P, Ti, Mn, Cu, Zn, Sc, V, Cu, and Sr.

Photothermal gas analyzer for simultaneous measurements of thermal diffusivity and thermal effusivity.

In this paper, we describe a new, simple, and fast photothermal method for simultaneous measurements of two important gas thermal properties: thermal diffusivity and thermal effusivity. The method consists essentially in combining a photoacoustic cell and a thermal wave pyroelectric cell enclosed in a single compact gas analyzer. The photoacoustic cell is kept filled with synthetic air and sealed. The pyroelectric cell is also filled with synthetic air, and after some warm up time, the synthetic air is exchanged to the gas of interest. It is shown that the analysis of the transient and saturation signals of both photoacoustic and pyroelectric cells is capable of measuring the thermal properties with an accuracy of 3%. This particular capability of performing simultaneously the measurements of thermal diffusivity and thermal effusivity allows us to carry on the complete characterization of the thermal properties of gases.

Ammonia detection by using quantum-cascade laser photoacoustic spectroscopy.

A pulsed quantum-cascade distributed-feedback laser, temperature tunable from -41 degrees C to +31.6 degrees C, and a resonant differential photoacoustic detector are used to measure trace-gas concentrations to as low as 66 parts per 10(9) by volume (ppbv) ammonia at a low laser power of 2 mW. Good agreement between the experimental spectrum and the simulated HITRAN spectrum of NH3 is found in the spectral range between 1046 and 1052 cm(-1). A detection limit of 30 ppbv ammonia at a signal-to-noise ratio of 1 was obtained with the quantum-cascade laser (QCL) photoacoustic (PA) setup. Concentration changes of approximately 50 ppbv were detectable with this compact and versatile QCL-based PA detection system. The performance of the PA detector, characterized by the product of the incident laser power and the minimum detectable absorption coefficient, was 4.7 x 10-9 W cm(-1).