Modeling the effect of Croton blanchetianus Baill essential oil on pathogenic and spoilage bacteria.

This study aimed to evaluate and model the antimicrobial action of different concentrations of Croton blanchetianus essential oil (CBEO) on the behavior of six bacterial species in vitro. CBEO extraction was performed by hydrodistillation and characterized by CG-MS. CBEO solutions in culture media were tested at 0.90, 1.80, 2.71, and 4.51 mg of CBEO/mL, against foodborne bacteria: pathogenic bacteria (Staphylococcus aureus, Listeria monocytogenes and Salmonella Enteritidis at 35 °C), a non-pathogenic Escherichia coli (at 35 °C), and spoilage bacteria (Weissella viridescens and Leuconostoc mesenteroides at 30 °C). The CBEO major compounds were eucalyptol, α-pinene, sativene, E-caryophyllene, bicyclogermacrene, and spatulenol. Baranyi and Roberts (growth) and Weibull (inactivation) primary models, along with power and hyperbolic secondary models, were able to describe the data. CBEO inactivated L. monocytogenes, S. aureus, L. mesenteroides and W. viridescens at all applied concentrations. CBEO did not inactivate S. Enteritidis and E. coli, but their growth rates were reduced.

Modelling the inactivation, survival and growth of Salmonella enterica under osmotic stress considering inoculum phase and serotype.

AIMS: This study evaluated the behaviour of the Salmonella enterica serotypes in osmotically stressful BHI broth (0.940 ≤ aw  ≤ 0.960), assessing inoculum from two stages of the bacterial life cycle (exponential and stationary) and two temperatures (25°C and 35°C). METHODS AND RESULTS: Four S. enterica serotypes (Typhimurium, Enteritidis, Heidelberg and Minnesota) were grown in stressful BHI at 25°C. A mathematical model was proposed for describing the total microbial count as the sum of two subpopulations, inactivating and surviving-then-growing. When submitted to aw of 0.950 and 0.960, all strains showed a decreased count, followed by a period of unchanged count and then exponential growth (Phoenix Phenomenon). Strains inoculated at aw  = 0.940 and 0.945 showed inactivation kinetics only. Cells cultivated at 25°C and inoculated from the exponential phase were the most reactive to the osmotic stress, showing a higher initial population reduction and shorter adaptation period. The proposed model described the inactivation data and the Phoenix Phenomenon accurately. CONCLUSIONS: The results quantified the complex response of S. enterica to the osmotic environment in detail, depending on the inoculum characteristic and serotype evaluated. SIGNIFICANCE AND IMPACT OF STUDY: Quantifying these differences is truly relevant to food safety and improves risk analysis.

Modeling the inactivation of Aspergillus fischeri and Paecilomyces niveus ascospores in apple juice by different ultraviolet light irradiances.

The present work aimed to evaluate and to model the influence of UV-C light treatments with different irradiances (6.5, 13, 21, and 36 W/m2) on Aspergillus fischeri and Paecilomyces niveus ascospores inactivation in clarified apple juice. Approximately 5.0 and 6.0 log CFU/mL spores of P. niveus and A. fischeri, respectively, were suspended in 30 mL of clarified apple juice (pH 3.8, 12 ± 0.1°Brix) and exposed to UV-C light at different irradiances (as above) and exposure times (0 to 30 min). The first-order biphasic model was able to describe the experimental data with good statistical indices (RMSE = 0.296 and 0.308, R2 = 0.96 and 0.98, for P. niveus and A. fischeri respectively). At the highest irradiance level tested (36 W/m2), the UV-C light allowed the reduction of 5.7 and 4.2 log-cycles of A. fischeri and P. niveus ascospores, respectively, in approximately 10 min. P. niveus was the most UV-C resistant mould. The results showed that, to a defined UV-C fluence, a change in the level of either time or UV-C irradiance did not affect the effectiveness of UV-C light for A. fischeri and P. niveus inactivation. Thus, the modeling of the inactivation as a function of the UV-C fluence allowed the estimation of the primary model parameters with all experimental data and, consequently, no secondary models were needed. The model parameters were validated with experiments of variable UV-C fluences. Accordingly, experimental results allowed to conclude that UV-C treatment at the irradiances tested is a promising application for preventing A. fischeri and P. niveus spoilage of juices.

A mathematical modeling approach to the quantification of lactic acid bacteria in vacuum-packaged samples of cooked meat: Combining the TaqMan-based quantitative PCR method with the plate-count method.

The TaqMan-based quantitative Polymerase Chain Reaction (qPCR) method and the Plate Count (PC) method are both used in combination with primary and secondary mathematical modeling, to describe the growth curves of Leuconostoc mesenteroides and Weissella viridescens in vacuum-packaged meat products during storage under different isothermal conditions. Vacuum-Packaged Morcilla (VPM), a typical cooked blood sausage, is used as a representative meat product, with the aim of improving shelf-life prediction methods for those sorts of meat products. The standard curves constructed by qPCR showed good linearity between the cycle threshold (CT) and log10 CFU/g, demonstrating the high precision and the reproducible results of the qPCR method. The curves were used for the quantification of L. mesenteroides and W. viridescens in artificially inoculated VPM samples under isothermal storage (5, 8, 13 and 18 °C). Primally, both the qPCR and the PC methods were compared, and a linear regression analysis demonstrated a statistically significant linear correlation between the methods. Secondly, the Baranyi and Roberts model was fitted to the growth curve data to estimate the kinetic parameters of L. mesenteroides and W. viridescens under isothermal conditions, and secondary models were used to establish the dependence of the maximum specific growth rate on the temperature. The results proved that primary and secondary models were adequate for describing the growth curves of both methods in relation to both bacteria. In conclusion, the results of all the experiments proved that the qPCR method in combination with the PC method can be used to construct microbial growth kinetics and that primary and secondary mathematical modeling can be successfully applied to describe the growth of L. mesenteroides and W. viridescens in vacuum-packaged morcilla and, by extension, other cooked meat products with similar characteristics.

Effect of soluble solids concentration on Neosartorya fischeri inactivation using UV-C light.

Ascospores of Neosartorya fischeri are heat-resistant and can survive thermal commercial treatments normally applied to the juices, as apple juice. Non-thermal processing of food such as exposure to ultraviolet light (UV-C) is reported to induce minimal quality changes while reduces microbial load. The main objective of this study was to determine the effect at different soluble solids concentration (12, 25, 30, 40, 50, 60 and 70 °Brix) on N. fischeri ascospores inactivation in apple juice, using UV-C light intensity (38 W/m2). Weibull model was fitted to experimental data. Then, a secondary model was used to describe how the inactivation kinetic parameters varied with the changes in soluble solids concentration. Results showed that the UV-C light had influence on N. fischeri ascospores inactivation in apple juice even at the highest soluble solids concentrations used, reaching approximately 4 log reductions at all concentrations used. The inactivation parameters, obtained by Weibull model, were δ (dose for the first decimal reduction) and p (the shape factor). Exponential model was chosen to describe the influence of soluble solids concentration on δ and p parameters. It can be concluded that UV-C light is a promising treatment with a drastic impact on the loads of N. fischeri, especially when low soluble solids concentration is used and a model was obtained to describe Brix effect.

Modeling the effect of oregano essential oil on shelf-life extension of vacuum-packed cooked sliced ham.

The present study modeled the effect of oregano essential oil, as an antimicrobial agent, on the shelf-life of vacuum-packed cooked sliced ham, based on the growth of lactic acid bacteria natural microbiota under isothermal conditions. The bacterial growth in ham without oregano essential oil (control) and with 0.4% oregano essential oil (v/w) was evaluated at five different temperatures (6, 12, 15, 20 and 25°C). Baranyi and Roberts, and modified Gompertz primary models were fitted to microbial growth curves. Square Root and Exponential secondary models were fitted to µmax parameter data. The addition of oregano essential oil increased lag phase, decreased growth rates and extended shelf-life of ham for all temperatures (at 6°C extended for, at least, 30days when compared to control). Statistical indexes showed that Baranyi and Roberts, and Exponential were the primary and secondary models, respectively, that better fit to the data. Thus, oregano essential oil showed a good antimicrobial effect and extended the ham shelf-life.

Poly(3-Hydroxybutyrate) Production in Repeated fed-Batch with Cell Recycle Using a Medium with low Carbon Source Concentration.

Among approaches applied to obtain high productivity and low production costs in bioprocesses are high cell density and the use of low cost substrates. Usually low cost substrates, as waste/agroindustrial residues, have low carbon concentration, which leads to a difficulty in operating bioprocesses. Real time control of process for intracellular products is also difficult. The present study proposes a strategy of repeated fed-batch with cell recycle to attain high cell density of Cupriavidus necator and high poly(3-hydroxybutyrate) (P(3HB)) productivity, using a substrate with low carbon source concentration (90 g l(-1)). Also, the use of the oxygen uptake rate data was pointed out as an on line solution for process control, once P(3HB) is an intracellular product. The results showed that total biomass (X), residual biomass (Xr) and P(3HB) values at the end of the culture were 61.6 g l(-1), 19.3 g l(-1) and 42.4 g l(-1) respectively, equivalent to 68.8 % of P(3HB) in the cells, and P(3HB) productivity of 1.0 g l(-1) h(-1). Therefore, the strategy proposed was efficient to achieve high productivity and high polymer content from a medium with low carbon source concentration.

Survey of molds, yeast and Alicyclobacillus spp. from a concentrated apple juice productive process.

Bacteria and molds may spoil and/or contaminate apple juice either by direct microbial action or indirectly by the uptake of metabolites as off-flavours and toxins. Some of these microorganisms and/or metabolites may remain in the food even after extensive procedures. This study aim to identify the presence of molds (including heat resistant species) and Alicyclobacillus spp., during concentrated apple juice processing. Molds were isolated at different steps and then identified by their macroscopic and microscopic characteristics after cultivation on standard media at 5, 25 and 37 °C, during 7 days. Among the 19 isolated found, 63% were identified as Penicillium with 50% belonging to the P. expansum specie. With regards to heat resistant molds, the species Neosartorya fischeri, Byssochlamys fulva and also the genus Eupenicillium sp., Talaromyces sp. and Eurotium sp. were isolated. The thermoacidophilic spore-forming bacteria were identified as A. acidoterrestris by a further investigation based on 16S rRNA sequence similarity. The large contamination found indicates the need for methods to eliminate or prevent the presence of these microorganisms in the processing plants in order to avoid both spoilage of apple juice and toxin production.