Mitochondrial oxygen monitoring with COMET: verification of calibration in man and comparison with vascular occlusion tests in healthy volunteers.

Mitochondria are the primary consumers of oxygen and therefore an important location for oxygen availability and consumption measurement. A technique has been developed for mitochondrial oxygen tension (mitoPO2) measurement, incorporated in the COMET. In contrast to most textbooks, relatively high average mitoPO2 values have been reported. The first aim of this study was to verify the validity of the COMET calibration for mitoPO2 measurements in human skin. The second aim was to compare the dynamics of mitoPO2 to several other techniques assessing tissue oxygenation. Firstly, we performed a two-point calibration. Mitochondrial oxygen depletion was achieved with vascular occlusion. A high mitoPO2 was reached by local application of cyanide. MitoPO2 was compared to the arterial oxygen partial pressure (PaO2). Secondly, for deoxygenation kinetics we compared COMET variables with the LEA O2C, SenTec OxiVenT™ and Medtronic INVOS™ parameters during a vascular occlusion test. 20 healthy volunteers were recruited and resulted in 18 datasets (2 times 9 subjects). The lowest measured mitoPO2 value per subject had a median [IQR] of 3.0 [1.0-4.0] mmHg, n = 9. After cyanide application the mitoPO2 was 94.1 mmHg [87.2-110.9] and did not differ significantly (n = 9, p = 0.5) from the PaO2 of 101.0 [98.0-106.0] mmHg. In contrast to O2C, OxiVenT™ and INVOS parameters, mitoPO2 declined within seconds with pressure on the probe. The kinetics from this decline are used to mitochondrial oxygen consumption (mitoVO2). This study validates the calibration of the COMET device in humans. For mitoVO2 measurements not only blood flow cessation but application of local pressure is of great importance to clear the measurement site of oxygen-carrying erythrocytes.

Evaluation of a new suture material (Duramesh™) by measuring suture tension in small and large bites techniques for laparotomy closure in a porcine model.

PURPOSE: After closure of laparotomies, sutures may pull through tissue due to too high intra-abdominal pressure or suture tension, resulting in burst abdomen and incisional hernia. The objective of this study was to measure the suture tension in small and large bites with a new suture material. METHODS: Closure of the linea alba was performed with small bites (i.e., 5 mm between two consecutive stitches and 5 mm distance from the incision) and large bites (i.e., 10 mm × 10 mm) with Duramesh™ size 0 (2 mm) and PDS II 2-0 in 24 experiments on six porcine abdominal walls. The abdominal wall was fixated on an artificial computer-controlled insufflatable abdomen, known as the 'AbdoMan'. A custom-made suture tension sensor was placed in the middle of the incision. RESULTS: The suture tension was significantly lower with the small bites technique and Duramesh™ when compared with large bites (small bites 0.12 N (IQR 0.07-0.19) vs. large bites 0.57 N (IQR 0.23-0.92), p < 0.025). This significant difference was also found in favour of the small bites with PDS II 2-0 (p < 0.038). No macroscopic tissue failure was seen during or after the experiments. CONCLUSION: Closure of the abdominal wall with the small bites technique and Duramesh™ was more efficient in dividing suture tension across the incision when compared to large bites. However, suture tension compared to a conventional suture material was not significantly different, contradicting an advantage of the new suture material in the prevention of burst abdomen and incisional hernia during the acute, postoperative phase.