Brominated Dioxins in Egg, Broiler, and Feed Additives: Significance of Bioassay-Directed Screening for Identification of Emerging Risks in Food.

Food authorities aim to safeguard our food. This requires sensitive analyses to guarantee detection of both banned and regulated substances at low concentrations. At the same time, broad screening methods are needed to identify new emerging risks. For this purpose, effect-based bioassays combined with mass spectrometric analyses offer an advantage. During the regular monitoring of dioxins in agricultural products, a discrepancy was observed between the results of the DR CALUX (Dioxin-Responsive Chemical Activated Luciferase gene Expression) bioassay and the confirmatory gas chromatographic high resolution mass spectrometric (GC-HRMS) analysis in egg and broiler fat samples. The response in the bioassay was high, suggesting a clear exceedance of the maximum limits of dioxins in these samples, yet regulated dioxins or dl-PCBs were not detected by GC/HRMS analysis. Ultimately, a broad screening analysis using GC-HRMS resulted in the identification of 2,3,7,8-tetrabromo-dibenzofuran (2,3,7,8-TBDF) in both egg and broiler fat. To investigate the potential source of this brominated furan contaminant, different samples were analyzed: bedding material, poultry feed, feed additives (choline chloride and l-lysine), and seaweed. The poultry feed and feed additives all contained 2,3,7,8-TBDF. Using a feed-to-food transfer model, it became clear that the poultry feed was probably the source of 2,3,7,8-TBDF in broilers and eggs through a feed additive like L-lysine or choline chloride. This study underlines the importance of using a combination of effect-based screening assays with sensitive analytical methods to detect potential new and emerging risks.

Presence and risks of polycyclic aromatic hydrocarbons, dioxins and dioxin-like PCBs in dietary plant supplements as elucidated by a combined DR CALUX® bioassay and GC-HRMS based approach.

Plant-based dietary supplements may contain undesirable contaminants such as polycyclic aromatic hydrocarbons, dioxins and dioxin-like polychlorinated biphenyls (dl-PCBs) due to the sources of raw materials or processing methods used. The presence of these contaminants in a series of herbal supplements sold on the Ghanaian market for improving sexual performance was examined using the DR CALUX® bioassay in combination with GC-HRMS analysis. Overall, cell responses at 4 and 48 h exposure to extracts prepared without an acid-silica clean-up were relatively higher than the responses obtained from extracts prepared with an acid-silica clean-up. This indicated that the 40 supplements contained only low levels of stable aryl hydrocarbon receptor (AhR) agonists like polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) and dl-PCBs, while some contained substantial amounts of less stable AhR-agonists. Ten supplements selected for confirmation with GC-HRMS analysis contained PCDD/Fs and dl-PCBs at levels ranging from 0.01 to 0.19 pg toxic equivalent (TEQ)/g only, while the level of the sum of 4 polycyclic aromatic hydrocarbons (Σ4PAHs) representing less stable AhR agonists, ranged from not detected (ND) to 25.5 ng/g. These concentrations were in line with the responses observed in the DR CALUX® bioassay. The concentration of PCDD/Fs and dl-PCBs corresponded to estimated daily intakes (EDIs) ranging from 0.01 to 1.20 pg TEQ/day, or 0.001 to 0.12 pg TEQ/kg bw/week for a 70 kg bw consumer, which was below the established tolerable weekly intake (TWI) of 2 pg TEQ/kg bw/week, thus indicating low concern for consumers' health. Similarly, the EDIs based on the detected Σ4PAHs in supplements ranged from 7.2 to 111 ng/day, or 0.1 to 1.6 ng/kg bw/day, which corresponded to MOE values above 10,000, indicating a low health concern.

metAlignID: a high-throughput software tool set for automated detection of trace level contaminants in comprehensive LECO two-dimensional gas chromatography time-of-flight mass spectrometry data.

A new alternative data processing tool set, metAlignID, is developed for automated pre-processing and library-based identification and concentration estimation of target compounds after analysis by comprehensive two-dimensional gas chromatography with mass spectrometric detection. The tool set has been developed for and tested on LECO data. The software is developed to run multi-threaded (one thread per processor core) on a standard PC (personal computer) under different operating systems and is as such capable of processing multiple data sets simultaneously. Raw data files are converted into netCDF (network Common Data Form) format using a fast conversion tool. They are then preprocessed using previously developed algorithms originating from metAlign software. Next, the resulting reduced data files are searched against a user-composed library (derived from user or commercial NIST-compatible libraries) (NIST=National Institute of Standards and Technology) and the identified compounds, including an indicative concentration, are reported in Excel format. Data can be processed batch wise. The overall time needed for conversion together with processing and searching of 30 raw data sets for 560 compounds is routinely within an hour. The screening performance is evaluated for detection of pesticides and contaminants in raw data obtained after analysis of soil and plant samples. Results are compared to the existing data-handling routine based on proprietary software (LECO, ChromaTOF). The developed software tool set, which is freely downloadable at www.metalign.nl, greatly accelerates data-analysis and offers more options for fine-tuning automated identification toward specific application needs. The quality of the results obtained is slightly better than the standard processing and also adds a quantitative estimate. The software tool set in combination with two-dimensional gas chromatography coupled to time-of-flight mass spectrometry shows great potential as a highly-automated and fast multi-residue instrumental screening method.

Levels of PCDD/Fs, PCBs and PBDEs in butter from Turkey and estimated dietary intake from dairy products.

Polychlorinated dibenzo-p-dioxin and dibenzofurans (PCDD/Fs), dioxin-like and non-dioxin-like (indicator) polychlorinated biphenyls (PCBs) and polybrominated diphenylethers (PBDEs) were monitored in butterfat obtained from 18 different areas in Turkey, both rural and industrial. The results obtained both at RIKILT in the Netherlands and in a food control laboratory in Turkey for PCDD/Fs and PCBs were in good agreement. The sum of PCDD/Fs+dl-PCBs, total indicator PCBs and PBDEs were in the range 0.26-3.82 pg TEQ g(-1) fat, 0.20-3.04 ng g(-1) fat and 0.18-5.00 ng g(-1) fat, respectively. Despite the very low levels measured, slightly elevated PCDD/F and PCB levels were found in Izmir-Aliaga, Kocaeli, Denizli, and Zonguldak. The only result exceeding the EU action level was the dl-PCB concentration in Izmir-Aliaga. Ratios of PCDD/Fs and PCBs indicate that contamination in the elevated areas originated from different sources. High BDE 209 levels were detected in Mersin and Bursa. For the 18 regions analysed, the average total daily intake of total TEQ (dioxins and dl-PCBs) from butterfat was 0.09 pg TEQ(1998) (0.08 pg TEQ(2005)) kg(-1) body weight, while those for indicator PCBs and PBDEs were 58.8 and 35.1 pg kg(-1) body weight, respectively. The average total daily intake from dairy products were 0.26 pg TEQ(1998) (0.20 pg TEQ(2005)), 183 and 103 pg kg(-1) body weight, respectively.

Validation of automated library-based qualitative screening of pesticides by comprehensive two-dimensional gas chromatography/time-of-flight mass spectrometry.

A method for automated detection and reporting of pesticides in plant materials based on comprehensive two-dimensional GC/time-of-flight MS with library-based detection by software has been developed and validated. Optimum settings for detection parameters such as spectral match threshold and first and second dimension retention time tolerances were assessed with respect to occurrence of false detects and false negatives. Next the method was validated following European Union guidelines established for qualitative screening of pesticides. The validation was largely done in retrospect by using data obtained for spiked samples (235 pesticides, various crops, 0.01-0.2 mg/kg) that had been analyzed previously with routine samples over a period of 18 months. At 0.01 mg/kg, the required 95% confidence level (<5% false negatives) was met for 83 compounds. This increased to 185 compounds at the 0.2 mg/kg level. For a number of pesticides, especially at low levels, it had to be concluded that at this stage the method was not fit-for-purpose to reliably demonstrate the absence of pesticides in samples to be analyzed. On the other hand, the fact that the overall detection rate at 0.01 mg/kg was 71% clearly showed that the method does provide added value for the numerous pesticides that are not covered by quantitative methods because the infrequent occurrence does not justify inclusion in such methods.

Qualitative screening and quantitative determination of pesticides and contaminants in animal feed using comprehensive two-dimensional gas chromatography with time-of-flight mass spectrometry.

A method has been developed for the target analysis of over 100 pesticides and contaminants in a complex feed matrix. The method is based on extraction with ethyl acetate, cleanup by gel permeation chromatography (GPC) and dispersive solid-phase extraction (SPE) with primary secondary amine phase (PSA), and analysis by comprehensive two-dimensional gas chromatography with full scan time-of-flight mass spectrometric detection (GC x GC-TOF-MS). Parameters studied during method development included a dispersive SPE cleanup step after GPC, large volume injection into the GC system and the GC x GC separation. Qualitative and quantitative performance of the GC x GC system was evaluated by analyzing spiked extracts in the range equivalent to 1-100 microg/kg in feed. At levels of 50 microg/kg and higher, all compounds targeted for could be identified fully automatically by the software based on their mass spectra. At lower levels the hit rate decreased with the concentration. System linearity was excellent in solvent and only slightly affected by matrix (correlation coefficients r>or=0.995 for 90% of the compounds). Limits of quantification were in the 1-20 microg/kg range for most compounds. The overall method was validated for 106 compounds at the 10 and 100 microg/kg level. Recoveries between 70% and 110% and RSDs below 20% were obtained for the majority of the compounds.

The German bakery waste incident; use of a combined approach of screening and confirmation for dioxins in feed and food.

During the last six years several incidents have occurred with dioxins in feed, stressing the need for rapid screening methods for these compounds. The most recent incident was the contamination of bakery waste used for animal feed due to the use of waste wood for drying of the material. In addition to Germany, the material was also shipped to the Netherlands. Levels up to 12ng TEQ/kg have been detected, being about 15 times over the current limit of 0.75ng TEQ/kg. In the Netherlands a combined strategy of screening with the CALUX-bioassay and the HRGC/HRMS confirmatory method was used to rapidly control the incident. Pigs were contaminated by the incident but only to a very limited extent. Despite the rather low limits for pig meat, the CALUX bioassay showed excellent performance, once again confirming the value of this assay.