Removal of isopropyl alcohol and methanol in ultrapure water production system using a 185 nm ultraviolet and ion exchange system.

The oxidation of low-molecular-weight (LMW) compounds, including isopropyl alcohol (IPA) and methanol in ultrapure water (UPW) production system was evaluated using the continuously operating 185 nm total organic carbon (TOC) reduction UV and ion exchange system. The initial concentration of compounds was in the range of tens of ppb which was the general feed condition of UV system located after 2 pass reverse osmosis (RO) in the UPW production system. UV irradiation transformed the compounds to less oxidative products that were ultimately converted to CO2. The ion exchange system then removed carboxyl-containing organic acids generated by UV oxidation. It means that the oxidation efficiency of organic compounds by UV irradiation can be accurately measured by the summation of the final product (CO2) and the by-product containing carboxyl functional group. The removal efficiency of LMW compounds decreased when either the initial TOC concentration increased or the UV intensity was reduced. Finally, the insertion of a baffle into the UV oxidation system was found to enhance solution turbulence and improve the oxidation efficiency.

Allergic contact dermatitis to gamma-irradiated WEBCOL alcohol prep pads.

We report a case of allergic contact dermatitis to WEBCOL(®) alcohol prep pads in a healthy 17-year-old girl who showed no reaction to the individual components of the prep pads upon provocative use testing. Although several case reports have described allergic contact dermatitis to isopropyl alcohol, there have been no reports of allergic contact dermatitis to alcohol prep pads sterilized with gamma irradiation, a common sterilization technique capable of producing volatile products in this type of alcohol prep pad.

Active peroxo titanium complexes: syntheses, characterization and their potential in the photooxidation of 2-propanol.

Two novel peroxo titanium complexes, Li(2)(NH(4))(4)[Ti(2)(O(2))(2)(cit)(Hcit)](2).5H(2)O and Zn(NH(4))(4)[Ti(4)(O(2))(4)(Hcit)(2)(cit)(2)].12H(2)O (cit = citrate), show encouraging results in the photochemical oxidation of 2-propanol.

Regeneration of granular activated carbon saturated with acetone and isopropyl alcohol via a recirculation process under H2O2/UV oxidation.

This study examines a water-based system, coupling an adsorber and a photoreactor, for regeneration of granular activated carbon (GAC) saturated with acetone and isopropyl alcohol (IPA). Through water recirculation the regeneration reaction was operated in both intermittent and continuous ultraviolet illumination modes. With a periodic dosage of hydrogen peroxide not only was regeneration efficient but it was also catalyzed by GAC in the adsorber. The concentrations of acetone, solution chemical oxygen demand (COD), pH and organic residues on GAC surfaces were measured during regenerations. Both pH and solution COD were found to correlate with regeneration completion as measured by organic residue on GAC surfaces in four regeneration cycles with acetone. Solution pH decreased to the acidic values and then returned to near its original value when organic residues were 0.085-0.255 mg/g GAC, that is, destruction efficiency of adsorbed acetone on the GAC surface was more than 99%. Likewise, solution COD became low (<100 mg/l) at regeneration completion. The pH variation pattern was then applied to another four cycles of regeneration with IPA, and successfully reflected the timing of complete regeneration. The final levels of organic residue on GAC surfaces were between 0.135 and 0.310 mg/g GAC in each of four regeneration cycles, each of which had been stopped based on the measurements of pH and solution COD. Furthermore, nearly the same batch of GAC could be repeatedly used with little changes in physicochemical properties in each of eight cycles: adsorptive capacities were 95+/-7 mg acetone/g GAC and 87+/-3 mg IPA/g GAC, and breakthrough time was 0.86+/-0.05 for acetone and 0.78+/-0.03 h for IPA. An economic assessment of the system showed that the operating cost was about 0.04 USD for treating every gram of acetone in the air.

Photocatalytic properties of titania nanostructured films fabricated from Titania nanosheets.

We examined the photochemical properties of well-ordered multilayer films of titania nanosheets prepared on quartz-glass substrate using the layer-by-layer deposition method. The photocatalytic decomposition of gaseous 2-propanol and bleaching of Methylene Blue dye under UV light illumination were measured to evaluate the photocatalytic oxidation ability. Photoinduced hydrophilicity was also studied by measuring the contact angle of water droplets on the film. The results indicated that titania nanosheets had good photoinduced hydrophilicity. The monolayer film of titania nanosheets showed almost identical activity compared with well investigated sol-gel derived anatase TiO(2) film, while its photocatalytic oxidation activity was low by more than an order of magnitude. This fact suggests that photoinduced hydrophilicity could not be explained simply in terms of the photocatalytic removal of hydrophobic organic species adsorbed on the surface. The photocatalytic oxidation activity and the photoinduced hydrophilic conversion rate decreased with increasing number of nanosheet layers, suggesting that photogenerated carriers produced in the internal part of the multilayer films can hardly diffuse to the surface layer. Photochemical properties of ultrathin anatase films obtained simply by heating the titania nanosheet films were evaluated as well, and also revealed high photoinduced hydrophilicity.

Preparation and photoactivity of nanostructured anatase, rutile and brookite TiO2 thin films.

Photoactive films consisting of pure anatase, brookite or rutile TiO2 were prepared by dip coating from water dispersions obtained by using TiCl4 as the precursor under similar mild experimental conditions.

Experimental microkinetic approach of the photocatalytic oxidation of isopropyl alcohol on TiO2. Part 1. Surface elementary steps involving gaseous and adsorbed C3H(x)O species.

The present study concerns an experimental microkinetic approach of the photocatalytic oxidation (PCO) of isopropyl alcohol (IPA) into acetone on a pure anatase TiO2 solid according to a procedure previously developed. Mainly, the kinetic parameters of each surface elementary step of a plausible kinetic model of PCO of IPA are experimentally determined: natures and amounts of the adsorbed species and rate constants (preexponential factor and activation energy). The kinetics parameters are obtained by using experiments in the transient regime with either a FTIR or a mass spectrometer as a detector. The deep oxidation (CO2 and H2O formation) of low concentrations of organic pollutants in air is one of the interests of the PCO. For IPA, literature data strongly suggest that acetone is the single route to CO2 and H2O and this explains that the present study is dedicated to the elementary steps involving gaseous and adsorbed C3H(x)O species. The microkinetic study shows that strongly adsorbed IPA species (two species denoted nd-IPA(sads) and d-IPA(sads) due to non- and dissociative chemisorption of IPA, respectively) are involved in the PCO of IPA. A strong competitive chemisorption between IPA(sads) and a strongly adsorbed acetone species controls the high selectivity in acetone of the PCO at a high coverage of the surface by IPA(sads). The kinetic parameters of the elementary steps determined in the present study are used in part 2 to provide a modeling of macroscopic kinetic data such as the turnover frequency (TOF in s(-1)) of the PCO using IPA/O2 gas mixtures.

Experimental microkinetic approach of the photocatalytic oxidation of isopropyl alcohol on TiO2. Part 2. from the surface elementary steps to the rates of oxidation of the C3H(x)O species.

The present study concerns an experimental microkinetic approach of the photocatalytic oxidation (PCO) of isopropyl alcohol (IPA) into acetone on a pure anatase TiO2 solid according to a procedure previously developed. Mainly, the kinetic parameters of each surface elementary step of a plausible kinetic model of the PCO of IPA are experimentally determined: natures and amounts of the adsorbed species and rate constants (preexponential factors and activation energies). These kinetic parameters are used to evaluate a priori the catalytic activity (turnover frequency, TOF, in s(-1)) of the solid that is compared to the experimental value. The kinetics parameters are obtained by using experiments in the transient regime with either a FTIR or a mass spectrometer as a detector. The microkinetic study shows that only strongly adsorbed IPA species (two species denoted nd-IPA(sads) and d-IPA(sads) due to non- and dissociative chemisorption of IPA respectively) are involved in the PCO of IPA. A strong competitive chemisorption between IPA(sads) and a strongly adsorbed acetone species controls the high selectivity in acetone of the PCO at a high coverage of the surface by IPA(sads). The apparent rate constant (1.4 10(-3) s(-1)) of the Langmuir-Hinshelwood elementary step between IPA(sads) and the active oxygen containing species generated by the UV irradiation provides the TOF of the PCO for IPA/O2 gas mixtures. The kinetic parameters of the elementary steps determined by the experimental microkinetic approach allow us to provide a reasonable simulation of the experimental data (coverages of the adsorbed species and partial pressures of the gases of interest) recorded during a static PCO of IPA(sads) species.

Radiation-induced chain reactions in alcohol solutions of diphenyliodonium salts: a high-sensitivity chemical dosimeter.

Chain reactions in gamma-irradiated 2-propanol solutions of diphenyliodonium salts have been studied. Protonic acids were generated in the irradiated solutions with high yields, whereas acid formation as a result of thermal reactions was negligible. The solution can be used as a high-sensitivity chemical dosimeter. The G value of acidic protons increases with increasing concentration of diphenyliodonium salt at the lower concentrations because the reaction rate of a propagation reaction increases. However, the chain is limited by a termination reaction between phenyl radical and the iodonium salt: The G value shows a maximum value of 610 micromol J(-1) at the concentration of 0.08 mol dm(-3) and decreases at higher salt concentrations.

Photocatalytic activity of TiO2 particulate films prepared by depositing TiO2 particles with various sizes.

TiO2 particles of various sizes were prepared by grinding in cyclohexanone, and TiO2 particulate films were obtained by depositing these TiO2 particles with various sizes onto a glass or quartz substrate. The effect of the particle size and thickness on the photocatalytic properties of the films was evaluated via oxidative degradation of gaseous 2-propanol. The initial rate of 2-propanol degradation under UV light irradiation for the films deposited with 30 nm TiO2 particles increased with increasing film thickness up to 600 nm, and reached a saturated value above this film thickness. Photocatalytic activity for the films with thickness below 600nm was larger when smaller TiO2 particles were deposited onto the substrate, due to the increase in the surface area of the particulate films. Furthermore, saturated values of the photocatalytic activity for thick films were smaller for the films deposited with smaller particles, which is mainly attributed to the change in crystal form of the particles during the grinding treatment.