Immunohistochemistry evaluation of BMP-2 with ß-tricalcium phosphate matrix, polylactic and polyglycolic acid gel, and calcium phosphate cement in rats.

PURPOSE: The installation of implants has become a routine procedure in the clinic. However, it takes time and adequate bone thickness, and for that, tissue engineering has made efforts to develop substitutes for autografts, in view of certain disadvantages of this material. The decision to choose the most suitable graft material for each case is an important step in the success of bone reconstruction. This study was to verify, by means of immunohistochemical study, that the addition of bone morphogenetic protein had some influence on biomaterials commercially available, taking into account the formation of mineralized tissue, bone replacement, and the amount of degradation of biomaterials. METHODS: The sample consisted of 72 rats that were divided into eight treatment groups, in which two defects of 5 mm were made in each animal calvaria. Euthanasia was performed at 5, 15, and 30 days postop. RESULTS: A histologic and histometric analysis was performed to quantitate the area of mineralized tissue formed, the area of newly formed bone, and the area of degradation of the biomaterials. Data were analyzed with multiple comparisons of means by Tukey contrasts, and significant difference was assigned at the level of P < 0.05. The proteins used for immunohistochemical analysis accounted for the process of formation, mineralization, and bone resorption and was performed using ordinal qualitative analysis, where from assigning scores. CONCLUSIONS: Bone morphogenetic protein 2 was shown to be effective as an inducer of bone formation process independent biomaterial used mainly for accelerating the resorption process of the framework.

Flexural strength distribution of a PMMA-based bone cement.

Polymethylmethacrylate bone cement containing either no added antibiotic or 0.5 g of Gentamicin was prepared and stored either in air at room temperature or in a 37 degree C water bath for 48 h. An additive-free cement stored in air at room temperature was also tested for purposes of comparison. Following storage the specimens were tested in flexure. Weibull statistics demonstrated to fit the flexural strength distribution of all the materials tested with regression coefficients of at least 0.98. The presence of a BaSO(4) radiopacifier markedly reduced the mean flexural strength and increased the data scatter in the air-stored specimens. On the other hand, the flexural strength of both impregnated and nonimpregnated antibiotic increased when those materials were stored in water at 37 degree C, compared with the same material stored in air, as a consequence of the water ingress. The water-stored antibiotic-impregnated cement displayed lower flexural strength, increased data scatter, and a remarkably higher number of weak specimens compared with the antibiotic-free cement. The influence of the load type on the flexural behavior was studied by testing the air-stored specimens in three-point bending and four-point bending. Cements tested in four-point bending resulted in lower flexural strength than that tested in three-point bending. The ratio of mean strength measured in the different load arrangements was satisfactory, as predicted by the Weibull model.